聚苯乙烯基硫代磺酸钾树脂的合成及其与卤代烃的反应

由聚苯乙烯基磺酰氯树脂与硫化氢钾反应制备聚苯乙烯基硫代磺酸钾树脂（Ｉ）,树脂Ｉ与亲电的卤代烃反应,生成聚苯乙烯基硫代磺酸酯树脂（Ⅱ）,树脂Ⅱ经过乙硫醇处理,使卤代烃结构部分以不对称二硫醚的形式游离下来,用ＧＣ／ＭＳ对其结构进行鉴定。从不对称二硫醚的结构可推导出原卤代烃的结构,所制备的聚苯乙烯基硫代磺酸钾树脂的转化效率为１．１１ｍｍｏｌ·ｇ＾－１。     

Ru/AC催化臭氧氧化难生物降解有机物

研究了臭氧单独氧化和Ru/AC催化臭氧氧化DMP、酚类物质和消毒副产物前体物.结果表明,Ru/AC能显著提高臭氧氧化中有机物的矿化效果.在DMP降解中,反应100 min后TOC的去除率由单独臭氧氧化的28.84%提高到66.13%.在23种酚类物质降解中,反应60min后TOC的去除率由单独臭氧的9.57%~56.08%提高到41.81%~82.32%.相对于单独臭氧,Ru/AC催化臭氧氧化更能有效地降低水源水中消毒副产物的生成势,以卤乙酸生成势的降低最为明显,100 min后卤乙酸生成势由144.02μg/L降到58.50μg/L,低于美国环保局规定的限制浓度60μg/L.而使用单独臭氧处理并不能使卤乙酸生成势降到符合美国EPA的规定.比较了BAC、O3+BAC、O3/AC+BAC以及Ru/AC+O3+BAC工艺处理水源水的效果,TOC平均去除率分别为3.80%、20.14%、27.45%和48.30%;COD平均去除率分别为4.37%、27.22%、39.91%和50.00%;UV254去除率分别为8.16%、62.24%、67.03%和84.95%.Ru/AC+O3+BAC工艺相比其他工艺,更能有效地...     

Carbonyl sulfide and dimethyl sulfide fluxes in an urban lawn and adjacent bare soil in Guangzhou, China

Carbonyl sulfide (COS) and dimethyl sulfide (DMS) fluxes from an urban Cynodon dactylon lawn and adjacent bare soil were measured during April–July 2005 in Guangzhou, China. Both the lawn and bare soil acted as sinks for COS and sources for DMS. The mean fluxes of COS and DMS in the lawn (–19.27 and 18.16 pmol/(m2 sec), respectively) were significantly higher than those in the bare soil (–9.89 and 9.35 pmol/(m2 sec), respectively). Fluxes of COS and DMS in mowed lawn were also higher than those in bare soils. Both COS and DMS fluxes showed diurnal variation with detectable but much lower values in the nighttime than in the daytime. COS fluxes were related significantly to temperature and the optimal temperature for COS uptake was 29°C. While positive linear correlations were found between DMS fluxes and temperature. COS fluxes increased linearly with ambient COS mixing ratios, and had a compensation point of 336 ppt.     

γAl2O3负载金属氧化物热催化分解沙林毒剂模拟剂

为了考察负载型金属氧化物催化剂对毒剂的热催化分解性能,以γ-Al2O3为载体,金属氧化物(Mn、Ni、Fe、Co、Cu和Ce)为活性组分,采用等体积浸渍法制备了负载型金属氧化物催化剂,对沙林毒剂模拟剂——甲基膦酸二甲酯(DMMP)进行了热催化分解评价实验,分别研究了不同反应温度、空速条件下热催化分解性能的变化规律。结果表明,在几种负载型金属氧化物催化剂中,CuO/γ-Al2O3表现出了最佳的防护性能。通过调控CuO负载量(1%~20%),发现5% CuO/γ-Al2O3具有较高的分散度和比表面积,热催化分解性能最好。磷物种的沉积造成催化剂比表面积的降低和晶体结构的破坏,是催化剂活性下降的主要原因。     

开口圆管非对称弯曲的一种方法

开口圆管非对称弯曲时,在尺寸、形状均有较高精度要求的情况下弯曲有一定的难度。此文介绍了一种成功的开口圆管非对称弯曲冷态成形方法。     

Al2O3催化臭氧化处理邻苯二甲酸二甲酯

'Al₂O₃催化剂对邻苯二甲酸二甲酯(DMP)溶液臭氧化过程的影响结果表明:Al₂O₃可以显著提高臭氧氧化的效果,反应120min后,TOC的去除率从单独臭氧氧化的23.9%提高到55.1%.实验中还考察了制备条件对Al₂O₃催化剂活性的影响并确定了反应的最佳工艺条件.在实验考察的范围内:焙烧温度600℃,Al₂O₃粒径为0.5～1.0mm时催化活性最高;最佳反应工艺条件为:催化剂投加量20g/L,混和气体流速200mL/min,反应温度15℃.通过单独臭氧氧化,单独臭氧氧化后再进行催化剂吸附,催化臭氧化的对比实验证明了Al₂O₃催化剂对体系TOC的去除主要是基于催化作用.     

颗粒活性炭对水中邻苯二甲酸二甲酯的吸附特性

研究了颗粒活性炭(GAC)对水中邻苯二甲酸二甲酯(DMP)的静态与动态吸附特性.结果表明,Freundlich和Langmuir等温线模型可以较好的拟合GAC对DMP的吸附.GAC对DMP的吸附容量较大,溶液初始浓度为200mg/L时,GAC对DMP的动态和最大静态吸附容量分别为484.60,450.89mg/g.考察了不同流速条件下(0.65～4.00mL/min)GAC吸附DMP的穿透特性,Yoon-Nelson模型能很好地拟合DMP在GAC柱中的穿透曲线,根据试验数据和Yoon-Nelson模型计算出穿透参数K′、T和穿透点t1以及平衡点t2.在建立了进水流量与Yoon-Nelson穿透模型的参数之间的关系基础上,得到了活性炭柱出水浓度与进水流量和穿透时间之间的动态关系模型.     

Ag~+改性复合钛铌酸钾盐对二甲基硫醚和乙硫醇吸附与光催化氧化研究

采用高温固相法合成具有不同Nb/Ti摩尔比的复合钛铌酸钾盐,通过Ag+离子交换对其进行改性。在静态下评价了Ag+改性复合钛铌酸钾盐对二甲基硫醚(DMS)和乙硫醇(EM)的吸附与紫外光催化氧化作用,使用红外光谱技术对催化剂表面滞留物种进行表征。结果表明,Ag+改性复合钛铌酸钾盐对DMS的吸附作用力比EM弱。随着Nb/Ti摩尔比增加,Ag+改性复合钛铌酸钾盐对EM的吸附作用力增强。在紫外光辐射下,Ag+改性的复合钛铌酸钾盐将DMS氧化为亚砜、砜和硫酸盐,而EM则被氧化为磺酸和单齿硫酸盐。     

Potential particulate pollution derived from UV-induced degradation of odorous dimethyl sulfide

UV-induced degradation of odorous dimethyl sulfide (DMS) was carried out in a static White cell chamber with UV irradiation. The combination of in situ Fourier transform infrared (FT-IR) spectrometer, gas chromatograph-mass spectrometer (GC-MS), wide-range particle spectrometer (WPS) technique, filter sampling and ion chromatographic (IC) analysis was used to monitor the gaseous and potential particulate products. During 240 min of UV irradiation, the degradation e ciency of DMS attained 20.9%, and partially oxidized sulfur-containing gaseous products, such as sulfur dioxide (SO2), carbonyl sulfide (OCS), dimethyl sulfoxide (DMSO), dimethyl sulfone (DMSO2) and dimethyl disulfide (DMDS) were identified by in situ FT-IR and GC-MS analysis, respectively. Accompanying with the oxidation of DMS, suspended particles were directly detected to be formed by WPS techniques. These particles were measured mainly in the size range of accumulation mode, and increased their count median diameter throughout the whole removal process. IC analysis of the filter samples revealed that methanesulfonic acid (MSA), sulfuric acid (H2SO4) and other unidentified chemicals accounted for the major non-refractory compositions of these particles. Based on products analysis and possible intermediates formed, the degradation pathways of DMS were proposed as the combination of the O(1D)- and the OH- initiated oxidation mechanisms. A plausible formation mechanism of the suspended particles was also analyzed. It is concluded that UV-induced degradation of odorous DMS is potentially a source of particulate pollutants in the atmosphere.     

钢铁企业富余煤气制甲醇与二甲醚的研究

利用钢铁联合企业的富余煤气,制甲醇与二甲醚.提出合理可行的工艺方案,进行主要物料消耗计算和成本估算,得出在工艺上和经济上可行的结论.项目的实施,能实现钢铁联合企业资源综合利用,提高企业的经济效益,同时对实现能源的多样化、发展新型清洁能源、改善生态环境都具有重要意义,其经济效益和社会效益显著.