Influence of new town development on the urban heat island - The case of the Bundang area

Five new towns have been developed around the Seoul metropolitan area since 1996. However, these new towns generate lots of traffic and related problems in the areas including those new towns and Seoul as a result of increases in population and a lack of ecological-self-sufficiency. Currently, construction of another new town is under deliberation, and what should be a major consider is the notion that the new town be located within a wide, green zone. Many studies have revealed that green space can play an important role in improving urban eco-meteorological capability and air quality. In order to analyze the urban heat island which will be created by the new urban development, and to investigate the local thermal environment and its negative effects caused by a change of land use type and urbanization, Landsat TM images were used for extraction of urban surface temperature according to changes of land use over the last 15 years. These data are analyzed together with digital land use and topographic information. As a study result, it was found the urban heat island of the study area from 198.5 to 1999 rapidly developed which showed a difference of mean temperature above 2.0. Before the Bundang new town construction the temperature of the residential area was the same as a forest, but during the new town construction in 1991 analysis revealed the creation of an urban heat island. The temperature of a forest whose size is over 50% of the investigation area was lowest, and thus the presence of a forest is believed to have a direct cooling effect on the urban environment and its surroundings. The mean temperature of the residential and commercial areas in the study was found to be 4.5 higher than the forest, and therefore this part of land use is believed to be the main factor causing the temperature increase of the urban heat island.     

Sanfilippo D syndrome: Correction of glucosamine-6-sulphatase deficiency following fibroblast culture in chang's media

The de-O-sulphation of α-linked glucosamine-6-sulphate residues in heparan sulphate requires a specific sulphatase, glucosamine-6-sulphatase, which has been shown to be deficient in tissues of Sanfilippo D, or mucopolysaccharidosis type IIID (MPS IIID), patients. MPS IIID fibroblasts cultured in Basal Eagle's medium supplemented with either fetal calf serum or heat-inactivated fetal calf serum, MDCB or Ultraserg media had residual glucosarnine-6-sulphatase activities towards a heparin-derived trisaccharide substrate, O-(α-N-acetylglucosamine-6-sulphate)-(1→4)-L -O-(α-iduronic acid-2-sulphate)-(1→4)-D -O-2,5-anhydro [1-³H]mannitol-6-sulphate, GlcNAc6S-IdoA2S-anM6S, which were less than 1 per cent of the normal range for fibroblasts cultured in Basal Eagle's medium supplemented with fetal calf serum. However, the glucosamine-6-sulphatase activities of MPS IIID fibroblasts grown in Chang's medium were similar to the activities in normal control fibroblasts which were cultured in Basal Eagle's medium. These results indicate that caution is required for prenatal diagnosis of MPS IIID patients using chorionic villi or amniotic cells cultured in Chang's medium.     

冠醚-离子液体体系对水相中铀酰离子的萃取

以二环己基-18-冠醚-6（DCH18C6）为萃取剂,一系列离子液体为溶剂的冠醚-离子液体萃取体系对水相中铀酰离子（UO22+）进行萃取实验。结果表明：UO22+在1-丁基-3-甲基咪唑双三氟磺酰亚胺盐（NTf2）体系的去除效率明显高于六氟磷酸盐类（PF6-）离子液体。在水相中当硝酸浓度在3 mol·L-1左右时萃取效率最高,体系的萃取效率随着萃取剂浓度的增加而变大,共存离子的加入会降低体系的萃取效率,但是当加入的是硝酸根离子时,萃取率会相应增大。根据实验结果分析可以判断此萃取体系主要为阳离子交换过程。     

6-苄氨基腺嘌呤对江汉平原小麦开花后渍害的缓减效应研究

于2011~2012年度及2012~2013年度开展小麦开花后渍水试验,研究开花后渍水对小麦产量的影响及渍水前喷施6-苄氨基腺嘌呤(6-BA)对产量的效应。结果表明,2011~2012年度及2012~2013年度江汉平原小麦开花期至成熟期均有持续降水分布,其中2011年4~5月累计降雨量达1941 mm,2012年同期累计降雨量达2855 mm,表明江汉平原小麦生殖生长期有较大渍害风险。本试验研究表明,开花后渍水,小麦植株衰老进程加速,叶片严重早衰失绿,旗叶光合速率降低;渍水前喷施6-BA,可缓减叶片衰老趋势,缩小旗叶光合速率降低幅度。开花后渍水亦导致根系活力降低,渍水前喷施6-BA可缓减根系活力降低,其中至灌浆中期,渍水处理根系活力仅为对照的563%,6-BA+渍水处理根系活力较渍水处理提高66%,差异达显著水平。渍水处理生物产量及籽粒产量均显著低于对照,渍水前喷施6-BA,生物产量、籽粒产量较渍水处理比较均有所提高,其中生物产量较渍水处理提高77%,籽粒产量提高137%。总之,在本试验条件下,开花后渍水导致光合速率、根系活力、生物产量、籽粒产量等显著降低,渍水前喷施6-BA可在一定程度上缓减渍害效应,在渍害发生后促进籽粒产量形成,据2011~2012年度及2012~2013年度产量结果估算,渍水前喷施6-BA相当于每6667 m2可减少427 kg 产量损失,即约1/3以上的田块未发生渍害     

电弧离子镀HY11涂层的1200℃高温氧化行为研究

目的研究真空电弧镀方法制备的超高温金属涂层HY11在1200℃下的高温氧化行为。方法用真空电弧镀技术(AIP)在单晶镍基高温合金DD6上制备超高温金属涂层HY11,采用HB 5258循环氧化方法进行1200℃循环氧化试验,通过试验过程中试样质量变化评价涂层氧化寿命。通过扫描电镜(SEM)分析氧化后的试样显微形貌,用X-射线衍射仪分析涂层材料的相结构,通过氧化速率对涂层材料抗氧化性能进行表征。结果采用单靶真空电弧镀技术制备的HY11涂层,经过1050℃真空条件下扩散2h,涂层厚度为50～60?m,扩散区厚度为10～15μm,涂层微观组织均匀致密,涂层合金界面清晰平整。DD6合金的1200℃循环氧化寿命仅仅为4 h,HY11涂层在1200℃的循环氧化寿命近300 h。沉积态涂层HY11相结构主要以Al_2O_3和Ni3Al为主。氧化后涂层材料表面形成的氧化膜以Al_2O_3为主。结论 HY11涂层在1200℃的循环氧化寿命为298 h,极大地提高了DD6合金在1200℃的循环氧化寿命。     

热障涂层对DD6单晶高温合金高周疲劳性能的影响

目的研究电子束物理气相沉积热障涂层对单晶高温合金高周疲劳性能的影响,为热障涂层在涡轮叶片上的应用提供技术支持。方法采用真空电弧镀和电子束物理气相沉积工艺制备YSZ热障涂层,进行900℃条件下高周疲劳性能测试,采用扫描电镜对测试后的试样表面、断口形貌进行观察与分析。结果在900℃、380 MPa条件下,带涂层的DD6单晶试棒循环次数(Nf)超过了107,420 MPa条件下超过了106。通过对DD6单晶试棒断口分析,失效后的带涂层试棒仍以DD6单晶常见滑移解离形式发生破坏。结论高周疲劳性能测试条件下,带YSZ热障涂层的试棒中粘结层率先产生垂直微裂纹,但是裂纹扩展延伸中发生氧化钝化,之后DD6基体沿正常的滑移方向从表面向内部疲劳扩展,带涂层的试棒疲劳裂纹并非由涂层微裂纹直接扩展形成,热障涂层对DD6单晶高温合金高周疲劳性能影响较小。     

SAFUIT/UF6环境评价模型验证与应用

作为核燃料循环过程中一种兼具辐射危害和化学毒性的中间产物,UF6的泄漏事故,特别是事故的环境评价技术越来越受到人们的重视.SAFUIT/UF6是专门针对此类事故的环境评价模型,目前已经开展了初步的验证工作.根据1987年法国UF6释放实验条件,对SAFUIT/UF6模型计算结果进行了误差分析,并与HG-SYSTEM/UF6模型进行了对比.初步认为SAFUIT/UF6模型可准确地模拟UF6扩散.此外,SAFUIT/UF6模型在某设施核事故应急评价系统中也得到了应用.     

基于格网GIS的重点生态功能区生态系统敏感性研究:以贵州省雷山县为例

为了科学地诊断出存在的环境问题,实现对生态环境的保护,以重点生态功能区雷山县为例,结合地形、地貌与气候等数据,以格网为评价单元,构建生态系统敏感性评价指标体系。采用层次分析法、区域综合法及格网GIS技术,对评价体系中各指标进行10 m×10 m尺度下的格网化表达,运用栅格数据的空间叠加方法及生态系统敏感性评价模型,综合评价雷山县生态系统敏感性空间格局。结果表明:雷山县生态系统敏感性较高,其中非敏感区和轻度敏感区面积较小,仅占总面积的5%和13.4%;其次是中度敏感区和极度敏感区,分别占总面积的26.3%和17%;高度敏感区面积最大,占总面积的38.3%。     

水钠锰矿的Mn（Ⅲ）分布及Na4P2O7溶液处理对其铅吸附性能的影响

以深入理解水钠锰矿结构中低价锰离子的含量及分布对其铅吸附性能的影响为目的,通过不同pH（pH为2、4、5）的焦磷酸钠溶液络合浸提酸性水钠锰矿结构中的Mn（Ⅱ）和Mn（Ⅲ）,研究了浸提锰离子的形态、含量、矿物的锰平均氧化度和Pb2＋的吸附量及其伴随Mn2＋、H＋释放量的变化.结果表明,锰平均氧化度为3.670的酸性水钠锰...     

六价铬对玉米种子萌发及生理特性的影响

主要研究了不同浓度六价铬胁迫对不同玉米种子萌发和部分生理特性的影响。结果表明：六价铬胁迫下,玉米的生长受到一定程度的抑制,并随溶液中六价铬浓度的增加,抑制加重。玉米幼苗植株吸收六价铬的量随其胁迫浓度的增加而增加。超氧化物歧化酶（SOD）、过氧化物酶（POD）活性随六价铬浓度的增加而增加,丙二醛（MDA）含量同样呈上升趋势。