From proposal to decision: Suggestions for tightening up the “NEPA process”

Although the process of documenting compliance with NEPA (the National Environmental Policy Act) requires no drastic revisions, it can be managed more rigorously. Suggestions for revision can be grouped under five major steps: 1) getting a complete proposal from the applicant; 2) getting the decision-making process onto the right decision-making path; 3) modifying the applicant's proposal 4) going down a shorter path through the EA/FONSI (environmental assessment and finding of no significant impact) or through categorical exclusion review; and 5) going down the longer path through the EIS. Step 2 is perhaps the most critical, because there a decision must be made whether to write an EA/FONSI or an EIS, on the basis of whether the proposal would “significantly affect … the … environment.” In the past, this decision has not always been made promptly or rigorously. Accordingly, we suggest that the agency responsible for NEPA compliance should develop a system (a “black box”), consisting of a core group of specialists working with an interdisciplinary team, using sophisticated techniques for modeling impacts and directing both their research and their writing according to the concept of significance. By determining more efficiently and reliably whether the impacts of a proposal would be significant, such an approach would improve management of the total process.     

直接法测定大气中的非甲烷烃

介绍了在２个监测点，用直接法测定大气中的非甲烷烃。测定方法的检出限可达０．００６５ｍｇ／ｍ＾３，在线性范围０－１０ｍｇ／ｍ＾３时，线性相关系数为０．９９９５，相对标准焦虑差为２．８％。结果表明，由于大气逆温层、工业排放源、汽车排气对非甲烷烃的浓度变化产生影响，其日变化曲线呈双峰形。     

铁阳极电解脱色直接黄11染料模拟废水

研究采用铁为阳极电化学法处理直接黄11染料模拟废水脱色性能的影响进行研究。影响因素包括:电流密度、pH值、染料浓度和电解质浓度。研究结果表明,电流密度大有利于染料废水脱色,但能耗消耗大;初始溶液在中性条件下不仅取得很好的处理效果,而且脱色能耗较低;随着染料初始浓度增加脱色率和脱色能耗降低的趋势;随着电解质浓度升高染料脱色率下降的趋势,脱色能耗先减少,然后缓慢增大。在染料初始浓度50 mg/L、pH值为7.11、电流密度2.083 mA/cm2、电解质Na2SO4浓度0.01 mol/L、温度20℃、搅拌速度600 r/min、电解时间60min条件下,脱色率达到92.2%,脱色能耗1.709 kW.h/kg染料。     

气袋直接进样法测定丙烯腈

采用气袋直接进样法测定环境和污染源空气中的丙烯腈。结果表明:丙烯腈在0.4～99.5 mg/m3浓度范围内具有良好的线性关系,相关系数为0.999 8。在低、中、高3个添加水平回收率为88.9%~100%,相对标准偏差为0.6%~4.7%,均能较好地满足实验室分析要求。     

汞分析仪直接测定土壤中总汞的方法研究

建立了利用RP91C-RA915M汞分析仪直接测定土壤中总汞的方法。该方法直接固体进样,省去了常规方法加酸消解、赶酸、定容等繁琐的前处理步骤;利用标准土壤绘制工作曲线,无需反复稀释标准储备液配制标准溶液,测定了方法检出限、精密度及准确度。结果表明此方法准确、可靠,是一个比较理想的分析方法。本方法的检出限为0.25μg/kg,相对标准偏差为1.98%~4.92%,标准样品测定准确,加标回收率为92.8%~106%。     

A new direct thermal desorption-GC/MS method: Organic speciation of ambient particulate matter collected in Golden, BC

Particulate matter having an aerodynamic diameter less than 2.5 μm (PM2.5) is thought to be implicated in a number of medical conditions, including cancer, rheumatoid arthritis, heart attack, and aging. However, very little chemical speciation data is available for the organic fraction of ambient aerosols. A new direct thermal desorption-gas chromatography/mass spectrometry (TD-GC/MS) method was developed for the analysis of the organic fraction of PM2.5. Samples were collected in Golden, British Columbia, over a 15-month period. n-Alkanes constituted 33–98% by mass of the organic compounds identified. PAHs accounted for 1–65% and biomarkers (hopanes and steranes) 1–8% of the organic mass. Annual mean concentrations were: n-alkanes (0.07–1.55 ng m⁻³), 16 PAHs (0.02–1.83 ng m⁻³), and biomarkers (0.02–0.18 ng m⁻³). Daily levels of these organics were 4.89–74.38 ng m⁻³, 0.27–100.24 ng m⁻³, 0.14–4.39 ng m⁻³, respectively. Ratios of organic carbon to elemental carbon (OC/EC) and trends over time were similar to those observed for PM2.5. There was no clear seasonal variation in the distribution of petroleum biomarkers, but elevated levels of other organic species were observed during the winter. Strong correlations between PAHs and EC, and between petroleum biomarkers and EC, suggest a common emission source – most likely motor vehicles and space heating.     

Loofa egyptiaca as a novel adsorbent for removal of direct blue dye from aqueous solution

In this paper, Loofa egyptiaca (LE), an agricultural plant cultivated in Egypt, was used to prepare low-cost activated carbon (LE_C1 and LE_C2) adsorbents. The adsorbents (LE, LE_C1 and LE_C2) were evaluated for their ability to remove direct blue 106 dye from aqueous solutions. Batch mode experiments were conducted using various parameters such as pH, contact time, dye concentration and adsorbent concentration. The surface chemistry of LE, LE_C1 and LE_C2 was analyzed by scanning electron microscopy (SEM). The experimental data were examined using Langmuir, Freundlich, Temkin and Harkins–Jura isotherms. The results showed that the adsorption of direct blue 106 was maximal at the lowest value of pH (pH = 2). Removal efficiency was increased with an increase in dye concentration and a decrease in amount of adsorbent. Maximum adsorption capacity was found to be 57.14, 63.3 and 73.53 mg/g for LE, LE_C1 and LE_C2 respectively. Kinetics were also investigated using pseudo-first-order, pseudo-second-order and intra-particle diffusion models. The experimental data fitted very well with the pseudo-first-order and pseudo-second-order kinetic models. The results indicate that LE, LE_C1 and LE_C2 could be employed as adsorbents for the removal of direct blue dye from aqueous solutions.     

环境空气中汞的直接测定方法研究与应用

研究了环境空气中汞浓度的直接测定方法。利用金汞齐富集－便携式测汞仪对环境空气中的汞进行直接测定,具有简便、快捷、不使用化学试剂的优点。经测试,该方法在0～180 ng／m^3范围内具有良好的线性关系,最低检出浓度为5 ng／m^3。     

直接测汞法和原子荧光法测定土壤中总汞的比对研究

采用DMA-80直接测汞技术,与国标方法原子荧光法对土壤中总汞的测定进行了方法比对研究。试验结果表明,直接测汞法的检出限优于原子荧光法,精密度和准确性能够满足土壤实际样品的测定,对30个实际样品分析结果的比对表明,方法间无显著差异,该方法快速、准确、无污染。     

Direct methanol fuel cell bubble removal mechanism using magnetic actuation

This article develops a direct methanol fuel cell (DMFC) with a magnet-actuated bubble removal mechanism. A micro-DC motor is used to control the bubble removal mechanism. The lower magnetic device is operated to extrude a Polydimethylsiloxane (PDMS) runner to compress the liquid fuel in the anode flow channel, forcing the CO₂ bubbles in the runner to flow toward the outlet end. The bubble retention in the anode flow channel is thereby improved, enhancing the cell performance. The proposed mechanism stability and performance and Polymethylmethacrylate (PMMA) runner are also discussed.