From proposal to decision: Suggestions for tightening up the “NEPA process”

Although the process of documenting compliance with NEPA (the National Environmental Policy Act) requires no drastic revisions, it can be managed more rigorously. Suggestions for revision can be grouped under five major steps: 1) getting a complete proposal from the applicant; 2) getting the decision-making process onto the right decision-making path; 3) modifying the applicant's proposal 4) going down a shorter path through the EA/FONSI (environmental assessment and finding of no significant impact) or through categorical exclusion review; and 5) going down the longer path through the EIS. Step 2 is perhaps the most critical, because there a decision must be made whether to write an EA/FONSI or an EIS, on the basis of whether the proposal would “significantly affect … the … environment.” In the past, this decision has not always been made promptly or rigorously. Accordingly, we suggest that the agency responsible for NEPA compliance should develop a system (a “black box”), consisting of a core group of specialists working with an interdisciplinary team, using sophisticated techniques for modeling impacts and directing both their research and their writing according to the concept of significance. By determining more efficiently and reliably whether the impacts of a proposal would be significant, such an approach would improve management of the total process.     

直接法测定大气中的非甲烷烃

介绍了在２个监测点，用直接法测定大气中的非甲烷烃。测定方法的检出限可达０．００６５ｍｇ／ｍ＾３，在线性范围０－１０ｍｇ／ｍ＾３时，线性相关系数为０．９９９５，相对标准焦虑差为２．８％。结果表明，由于大气逆温层、工业排放源、汽车排气对非甲烷烃的浓度变化产生影响，其日变化曲线呈双峰形。     

在线树脂富集流动注射法测定水中痕量酚

研究了用流动注射分析中的流体动力学注入技术与在线树脂富集相结合的方式，富集水中痕量苯酚，以４－氨基安替比林比色法测定的方法。结果表明，当进样频率为２４个样品每小时时，方法的检出限为０．０５ｍｇ／Ｌ，线性范围为０．０５～７ｍｇ／Ｌ；对水中苯酚重复测定１０次，相对标准偏差小于２％；回收率为９９％～１０５％。     

Kinetic-spectrophotometric determination of free cyanide by stopped-flow reversed flow injection analysis

A stopped-flow reversed flow injection method for the determination of free cyanide is proposed. Pyridine-barbituric acid mixture is injected in the flow system as reagent to form the colour species with cyanide. The flow is stopped when the reagent zone comes in the flow cell, where absorbance-time data are collected at 580nm wavelength. The linear range of the determination is 0.1 -10μg/ml CN-. The sampling rate is 60h-1 and the relative standard deviation is 1.6% (n=16) at 5.0 μg/ml CN-1 level. With satisfactory results, the proposed method was applied to the determination of free cyanide in wastewater without sample pretreatment.     

VE泵端面凸轮冷/温复合成形技术研究

采用温锻制坯与冷摆辗相结合的复合成形工艺生产VE泵端面凸轮精密成形件,不仅材料利用率可达到95%左右;而且成形件的尺寸精度高,表面光洁度高,能有效地减少后续仿形磨削加工的余量,从而降低了生产成本,提高了生产效率。采用该工艺可以进行大批量生产,能满足我国轻型汽车VE泵的生产需要。     

化学发光流动注射法测定雨水中过氧化氢

用化学发光流动注射分析装置,将16孔阀连接成异步双流路,以过氧化氢-鲁米诺-钴(Ⅱ)为化学发光体系,建立了快速测定雨水中过氧化氢的方法,最低检测限为0.1ng/ml,在0.1—400ppb范围内有良好的线性关系,相对标准差为0.78—3.03％,每小时可分析480个以上的样品.     

主汽管噪声原因分析及处理对策

随着环保要求的日益严格，工业噪声作为一大污染源越来越受到人们的关注。通过对噪声产生机理的分析，确定了主汽管噪声的生成原因，介绍了几种降噪措施及其效果，对电厂管道设计和阀门选型具有借鉴意义。     

预防煤炭自燃的注砂技术实验研究

山砂是我国西北部矿区地表的主要自然资源之一,但如用其直接作为煤矿注浆防灭火的原料,不仅会造成输送管路的堵塞,还会引起输送管路的严重磨损。为此,首先研究了常见增稠剂羧甲基纤维素、聚丙烯酰胺和聚丙烯酸钠等对砂粒的悬浮性能,实验结果表明它们只能延缓砂粒的沉降。进而从理论上分析了砂粒悬浮的条件,发现具有一定屈服应力的假塑性流体特性的液体才能悬浮砂粒;并且悬浮砂粒粒径越大,所需屈服应力也越大。基于理论分析,研制了具有该特性的浆液,山砂在该浆液中不仅具有良好的悬浮性能,浆液还具有输送阻力小的特性。管道输送试验表明,浆液稳定性和流动阻力符合实际要求。     

燃煤电厂烟塔合一排烟风洞试验与数值模拟对比分析

近年来,燃煤电厂烟塔合一烟气排烟对近距离环境影响的不确定性,使其在国内的推广过程受到一定限制。准确判断烟塔合一排烟的环境影响,对于我国现有燃煤电厂烟气污染物的排放有着巨大的工程价值和明显的现实意义。利用国家环境保护某重点实验室中风洞试验平台,对燃煤电厂烟塔合一烟气污染物在近距离的扩散和传输行为,进行物理风洞试验以及数值模拟计算,并进行对比分析。结果表明:德国Austal2000模式的浓度预测并不精确;数值风洞也有其差异性,而物理风洞的结果在很大程度上符合现有的理论及国内工程实际。     

铁阳极电解脱色直接黄11染料模拟废水

研究采用铁为阳极电化学法处理直接黄11染料模拟废水脱色性能的影响进行研究。影响因素包括:电流密度、pH值、染料浓度和电解质浓度。研究结果表明,电流密度大有利于染料废水脱色,但能耗消耗大;初始溶液在中性条件下不仅取得很好的处理效果,而且脱色能耗较低;随着染料初始浓度增加脱色率和脱色能耗降低的趋势;随着电解质浓度升高染料脱色率下降的趋势,脱色能耗先减少,然后缓慢增大。在染料初始浓度50 mg/L、pH值为7.11、电流密度2.083 mA/cm2、电解质Na2SO4浓度0.01 mol/L、温度20℃、搅拌速度600 r/min、电解时间60min条件下,脱色率达到92.2%,脱色能耗1.709 kW.h/kg染料。