Regulated emission characteristics of in-use LNG and diesel semi-trailer towing vehicles under real driving conditions using PEMS

On-road driving emissions of six liquefied natural gas(LNG) and diesel semi-trailer towing vehicles(STTVs) which met China Emission Standard IV and V were tested using Portable Emission Measurement System(PEMS) in northern China.Emission characteristics of these vehicles under real driving conditions were analyzed and proved that on-road emissions of heavy-duty vehicles(HDVs) were underestimated in the past.There were large differences among LNG and diesel vehicles, which also existed between China V vehicles and China IV vehicles.Emission factors showed the highest level under real driving conditions, which probably be caused by frequent acceleration, deceleration, and start-stop.NOx emission factors ranged from 2.855 to 20.939 g/km based on distance-traveled and 6.719–90.557 g/kg based on fuel consumption during whole tests, which were much higher than previous researches on chassis dynamometer.It was inferred from tests that the fuel consumption rate of the test vehicles had a strong correlation with NOx emission, and the exhaust temperature also affected the efficiency of Selected Catalytic Reduction(SCR) aftertreatment system, thus changing the NOx emission greatly.THC emission factors of LNG vehicles were 2.012–10.636 g/km, which were much higher than that of diesel vehicles(0.029–0.185 g/km).Unburned CH_4 may be an important reason for this phenomenon.Further on-road emission tests, especially CH_4 emission test should be carried out in subsequent research.In addition, the Particulate Number(PN) emission factors of diesel vehicles were at a very high level during whole tests, and Diesel Particulate Filter(DPF)should be installed to reduce PN emission.     

潜流人工湿地水力学特性及工程设计

以净化低污染水体的潜流人工湿地水力学特性工程设计为重点,系统开展了室内外实验研究,并利用Peelet数分析了水平潜流人工湿地碎石床渗流返混程度。结果表明,潜流人工湿地集水花管孔口出流计算、基质填料内渗流计算、碎石床平均水力停留时间计算可分别借鉴薄壁孔口恒定淹没出流、线性或非线性渗流、活塞流理论;但受工程实际条件及运行淤堵等影响,工程实测结果均小于理论计算值。基于室内外实验成果,提出一套包括集配水系统水力计算、填料内渗流计算、平均水力停留时间计算在内的潜流人工湿地水力学特性计算方法和参数选择,可为人工湿地技术的工程设计提供借鉴。     

复合微生物菌剂强化堆肥技术研究

采用复合微生物菌剂对生活垃圾的接种堆肥技术进行了实验研究。通过测定堆肥过程中反应器出口O2、CO2与H2S气体浓度及对堆肥样品扫描电镜照片分析，比较了3个接种组与1个对照组中堆料中微生物总数变化、种群结构演替及堆肥腐熟速度。试验结果表明，在原料成分为：生活垃圾／成熟堆肥=80／20，有机物约为60％，初始含水率为55％，初始C／N-30时，对于不同接种量的复合微生物接种系统堆料中分别接种0．2％、0．3％、0．5％(质量百分含量)，与加入0．3％灭活菌的对照组进行对比实验，接种复合微生物菌剂堆肥系统不仅微生物总数高于对照组，而且其种群结构合理，能明显提高堆肥效率，有效控制臭气的产生，提高堆肥腐熟度。     

Determinants of male mating success in the red bishop (Euplectes orix)

We studied sexual selection in the red bishop, Euplectes orix, a colonial, polygynous weaverbird widely distributed over sub-Saharan Africa. Male reproductive success measured in terms of the number of nests accepted by females and the number of eggs and nestlings in all the nests on a male's territory varied considerably. The standardized variance (variance/mean²) in male reproductive success ranged from 0.505 to 1.737 in different years, indicating a high potential for sexual selection in this species. An analysis of genetic parentage for 432 nestlings by non-radioactive, multilocus DNA fingerprinting confirmed that male reproductive success (number of young sired on the territory) in this species can be reliably estimated by the measures introduced above. In all 4 study years there was a strong positive correlation between male mating success and the total number of nests that males built in their territories. The number of nests built can be partitioned into the number of weeks a male held a territory and his nest-building performance. Both factors exert a significant positive effect on male mating success and in combination explained between 53.3 and 86.3% of the variation in male reproductive success. Male morphological characters were found to be of no importance. Males that established a territory in the following season built more nests and held their territories for longer than males that did not establish a territory in the following season, suggesting that these measures might be indicators of male condition and quality. Male nest-building performance (number of nests built per week) seems to be unrelated to male condition or quality. Received: 8 January 1999 / Received in revised form: 7 June 1999 / Accepted: 13 June 1999     

A spatial clustering perspective on autocorrelation and regionalization

We revisit one of the classical problems in geography and cartography where multiple observations on a lattice (N) need to be grouped into many fewer regions (G), especially when this number of desired regions is unknown a priori. Since an optimization through all possible aggregations is not feasible, a hierarchical classification scheme is proposed with an objective function sensitive to spatial pattern. The objective function to be minimized during the assignment of observations to regions (classification) consists of two terms: the first characterizes accuracy and the second, model complexity. For the latter, we introduce a spatial measure that characterizes the number of homogeneous patches rather than the usual number of classes. A simulation study shows that such a classification procedure is less sensitive to random and spatially correlated error (noise) than non-spatial classification. We also show that for conditional autoregressive error (noise) fields the optimal partitioning is the one that has the highest within-units generalized Moran coefficient. The classifier is implemented in ArcView to demonstrate both a socio-economic and an environmental application to illustrate some potential applications.

汶川地震灾区小流域洪水计算方法初探

汶川地震灾区小流域山洪不仅造成巨大损失,同时也是泥石流等灾害的激发因素,探寻一种准确且可操作的洪水峰值流量计算方法对防灾减灾具有重要意义。本文选择不同产流和汇流计算方法,组合成不同水文模型,进行小流域洪水过程计算,对模拟结果和参数选择进行对比,旨在探究最适合该地区的小流域水文计算方法。分别选择SCS曲线法、Green-Ampt入渗法、初损稳渗法进行坡面产流计算,应用SCS单位线法、Snyder单位线法和运动波方程进行坡面和沟道汇流计算,组合成5种小流域产汇流计算模型,利用6场洪水进行参数率定和结果验证。模拟结果对比分析,得出SCS曲线法是最适宜的产流模型,其与SCS单位线、运动波汇流计算方法组合而成的SCS和SKK模型,峰现时间的模拟误差最小,在0~25 min之间;洪峰流量模拟的相对误差较小,平均误差不超过4%;洪水总量模拟误差在10%左右。另外,这两种模型参数设置及确定较简单,更适合在数据稀缺的小流域中进行洪水模拟应用。研究可为汶川地震灾区小流域山洪和泥石流等灾害的流量估算提供方法和参数借鉴。     

A Fuzzy Logic Approach to Assess Groundwater Pollution Levels Below Agricultural Fields

A fuzzy logic approach has been developed to assess the groundwater pollution levels below agricultural fields. The data collected for Kumluca Plain of Turkey have been utilized to develop the approach. The plain is known with its intensive agricultural activities, which imply excessive application of fertilizers. The characteristics of the soils and underlying groundwater for this plain were monitored during the years 1999 and 2000. Additionally, an extensive field survey related to the types and yields of crops, fertilizer application and irrigation water was carried out. Both the soil and groundwater have exhibited high levels of nitrogen, phosphorus and salinity with considerable spatial and temporal variations. The pollution level of groundwater at several established stations within the plain were assessed using Fuzzy Logic. Water Pollution Index (WPI) values are calculated by Fuzzy Logic utilizing the most significant groundwater pollutants in the area namely nitrite, nitrate and orthophosphate together with the groundwater vulnerability to pollution. The results of the calculated WPI and the monitoring study have yielded good agreement. WPI indicated high to moderate water pollution levels at Kumluca plain depending on factors such as agricultural age, depth to groundwater, soil characteristics and vulnerability of groundwater to pollution. Fuzzy Logic approach has shown to be a practical, simple and useful tool to assess groundwater pollution levels.     

Number concentration and size distributions of submicron particles in Jinan urban area： Characteristics in summer and winter

The aerosol number concentration and size distribution were measured with the newly developed Wide-range Particle Spectrometer in summer and winter of 2006 at the urban site of Jinan City.Here reported the characteristics of fine particles of the different observation seasons.Relative high number concentrations for the particles in the diameter range of 10-500 nm were observed in both seasons.It was found that the dominant number distributed in particle diameter smaller than 100 nm and the percentage over the number concentration of all air particles is much higher than what has been measured in other urban sites over the world.The number mean diameter in summer was much smaller than in winter,strongly suggesting the different origin of ultrafine particles in different seasons.That is, particles in ultrafine mode mainly came from nucleation and new particle formation in summer while from traffic emission in winter. The diurnal variation also supported this point.Number concentration in the diameter range of 10-200 nm got their peak values at noontime,well correlated with the mixing ratio of SO_2 and the intensity of solar radiation in summer.While in winter,those in the same diameter range showed the main peaks during the traffic hours happened in the morning and evening.     

Indoor Air Quality at Rural and Urban Sites in Pakistan

In the developing world, the vast majority of people rely on solid biomass fuels for cooking and heating which results in poor indoor air quality. The present study determined indoor air quality in some rural and urban areas of Pakistan. Measurements were made of particulate mass (PM10, PM2.5 and PM1), number concentration and bioaerosols in different micro environments. PM10 concentrations of up to 8,555 μg/m³ were observed inside the kitchens where biofuels were used as energy source. Cleaning and smoking was identified as a major source of indoor particulate pollution and concentrations of more than more than 2,000 μg/m³ were recorded in the living room during these activities. Indoor number concentrations in Lahore were typically greater than those observed outdoors in European cites. At a rural site the highest Colony Forming Units (CFUs) were in the 0.5 μm–2 μm size fraction, while at the urban location CFUs were dominant for 2 μm–16 μm. It was observed that CFUs(Colony Forming Units) counts were higher inside living rooms than kitchens. It is important to note that women and children were exposed to extremely high levels of particulates during cooking. Overall, indoor air quality in Pakistan was poor and there is a dire need to take a serious step to combat with it.