基于PSD法的船载雷达随机振动响应分析

目的 优化以经验为主的船载雷达结构设计流程,缩短设计周期,提高设计的准确性。方法 提出基于模态分析和PSD法的新的设计流程,利用ANSYS软件对雷达天线和转台结构进行系统的随机振动分析,得到其模态、应力分布、位移云图及响应谱曲线,验证设计的准确性、合理性。结果 得到雷达系统在1σ下的最大应力值和最大变形量分别为14.847 MPa和0.367 mm。结论 新的设计流程可以得到可靠性更高的产品,能有效缩短产品的设计周期,具有重要的借鉴意义。     

曝气强度对膜生物反应器污泥混合液可滤性的影响

主要研究了曝气强度对膜生物反应器(MBR)膜污染的影响.2套MBR采用恒流出水模式连续运行60 d,曝气强度分别为500及100 L/h,应用死端过滤装置来检测不同阶段污泥混合液的可滤性.实验中对不同曝气强度下的溶解性微生物代谢产物(SMP)分子质量分布、颗粒粒径分布、胞外聚合物(EPS)含量进行了测定.结果表明,过高的曝气强度将恶化污泥混合液的可滤性,增加了膜污染速率.进一步研究表明,曝气强度的增加导致了污泥混合液上清液中相对分子质量>10000的SMP浓度的增加,此部分大分子有机物浓度直接影响了污泥混合液的可滤性.过高的曝气强度也导致了污泥絮体中1～10μm细小颗粒和EPS含量的增加.     

随机振动加速度响应谱及与冲击等效性分析

目的 获得随机振动的加速度响应谱,提升随机振动与冲击的等效性分析精度。方法 首先,基于维纳-辛钦定理,推导单自由度系统在随机振动基础激励作用下加速度响应均方值的通用表达式;其次,分别推导单自由度系统在理想白噪声和限带非均匀谱随机振动基础激励作用下的加速度响应均方值;再次,基于3σ准则,推导限带非均匀谱随机振动的3σ加速度响应谱;最后,基于加速度响应等效,通过将装备随机振动条件的3σ加速度响应谱与冲击条件的冲击响应谱进行等效性分析,对GJB 150.18A—2009中的冲击试验剪裁条件进行精细优化。结果 精细优化后,可有效改善冲击试验剪裁条件的工程实施精度。结论 获得了限带非均匀谱随机振动的3σ加速度响应谱,并基于此对GJB 150.18A—2009中的冲击试验剪裁条件进行了精细优化,对于装备合理剪裁冲击试验具有借鉴意义。     

随机振动的描述及其试验与仿真

阐述了随机振动的描述方法,随机振动试验条件和相关参数的计算等。并结合实例,介绍了随机振动有限元仿真的流程及其工程意义,以便在深入了解随机振动原理的基础上,指导随机振动试验和有限元仿真的开展。     

Influence of MBBR carrier geometrical properties and biofilm thickness restraint on biofilm properties, effluent particle size distribution, settling velocity distribution, and settling behaviour

The relatively poor settling characteristics of particles produced in moving bed biofilm reactor (MBBR) outline the importance of developing a fundamental understanding of the characterization and settleability of MBBR-produced solids. The influence of carrier geometric properties and different levels of biofilm thickness on biofilm characteristics, solids production, particle size distribution (PSD), and particle settling velocity distribution (PSVD) is evaluated in this study. The analytical ViCAs method is applied to the MBBR effluent to assess the distribution of particle settling velocities. This method is combined with microscopy imaging to relate particle size distribution to settling velocity. Three conventionally loaded MBBR systems are studied at a similar loading rate of 6.0 g/(m² •day) and with different carrier types. The AnoxK™ K5 carrier, a commonly used carrier, is compared to so-called thickness-restraint carriers, AnoxK™ Z-carriers that are newly designed carriers to limit the biofilm thickness. Moreover, two levels of biofilm thickness, 200 μm and 400 μm, are studied using AnoxK™ Z-200 and Z-400 carriers. Statistical analysis confirms that K5 carriers demonstrated a significantly different biofilm mass, thickness, and density, in addition to distinct trends in PSD and PSVD in comparison with Z-carriers. However, in comparison of thickness-restraint carriers, Z-200 carrier results did not vary significantly compared to the Z-400 carrier. The K5 carriers showed the lowest production of suspended solids (0.7 ± 0.3 g-TSS/day), thickest biofilm (281.1 ± 8.7 µm) and lowest biofilm density (65.0 ± 1.5 kg/m³). The K5 effluent solids also showed enhanced settling behaviour, consisting of larger particles with faster settling velocities.     

Low level radioactivity measurements with phoswich detectors using coincident techniques and digital pulse processing analysis

A new system has been developed for the detection of low radioactivity levels of fission products and actinides using coincidence techniques. The device combines a phoswich detector for alpha/beta/gamma-ray recognition with a fast digital card for electronic pulse analysis. The phoswich can be used in a coincident mode by identifying the composed signal produced by the simultaneous detection of alpha/beta particles and X-rays/gamma particles. The technique of coincidences with phoswich detectors was proposed recently to verify the Nuclear Test Ban Treaty (NTBT) which established the necessity of monitoring low levels of gaseous fission products produced by underground nuclear explosions. With the device proposed here it is possible to identify the coincidence events and determine the energy and type of coincident particles. The sensitivity of the system has been improved by employing liquid scintillators and a high resolution low energy germanium detector. In this case it is possible to identify simultaneously by alpha/gamma coincidence transuranic nuclides present in environmental samples without necessity of performing radiochemical separation. The minimum detectable activity was estimated to be 0.01 Bq kg(-1) for 0.1 kg of soil and 1000 min counting.     

微粒尺寸分布(PSD)在污水处理研究中的应用

介绍了污水中微粒的分类、尺寸分布(PSD)和检测PSD的方法。PSD与污水化学成分相关,不同来源的污水PSD各不相同,且PSD会随着污水处理流程变化。PSD可对污水进行表征,对传统方法进行辅助和补充。在生物处理中,微粒尺寸与BOD降解速率呈反比例关系,PSD可提供COD组分迁移变化的必要信息,直接影响着生物处理的效果。无论是对传统活性污泥法还是对生物膜法中的PSD进行研究,均可评估生物处理中碳源是否足够,分析去除机理,优化处理效果。PSD对痕量物质的去除和迁移具有重要意义,在深度过滤中,污水中PSD呈幂函数关系,PSD可研究雌激素等痕量物质的去除机理。PSD作为一个新型的研究工具,可以进一步深入应用于污水处理领域,对该领域的研究和技术升级具有重要意义。     

阜山金矿进回风巷粉尘孔粒径分布及其分形特征

为探究金属矿井下粉尘孔粒径特征,以阜山金矿为例,系统研究其进风巷粉尘(IAD)、回风巷粉尘(RAD)的孔粒径分布(PSD)情况.首先,利用激光粒度分析仪与扫描电子显微镜(SEM)、低温液氮吸附仪分别测试粉尘粒径与孔参数,然后利用分形理论计算并分析其粒度分形维数与孔分形维数.结果 表明:RAD粒径比IAD粒径小,两者最可...     

Effects of a dynamic membrane formed with polyethylene glycol on the ultrafiltration of natural organic matter

The formation of a dynamic membrane (DM) was investigated using polyethylene glycol (PEG) (molecular weight of 35000 g/mol, concentration of 1 g/L). Two natural organic matters (NOM), Dongbok Lake NOM (DLNOM) and Suwannee River NOM (SRNOM) were used in the ultrafiltration experiments along with PEG. To evaluate the effects of the DM with PEG on ultrafiltration, various transport experiments were conducted, and the analyses of the NOM in the membrane feed and permeate were performed using high performance size exclusion chromatography, and the effective pore size distribution (effective PSD) and effective molecular weight cut off (effective MWCO) were determined. The advantages of DM formed with PEG can be summarized as follows: (1) PEG interferes with NOM transmission through the ultrafiltration membrane pores by increasing the retention coefficient of NOM in UF membranes, and (2) low removal of NOM by the DM is affected by external factors, such as pressure increases during UF membrane filtration, which decreases the effective PSD and effective MWCO of UF membranes. However, a disadvantage of the DM with PEG was severe flux decline; thus, one must be mindful of both the positive and negative influences of the DM when optimizing the UF performance of the membrane.     

履带车辆特殊路面谱实车测试与分析

基于GB/T 7031—2005建立了路面谱模型,分析了加速度法测试履带车辆特殊路面路面谱的基本原理,并以此为理论依据,设计出在第一、五负重轮轮轴处安装加速度传感器并得出时域曲线的测试方案,分别记录了不同速度下长度为4 m的长波路和越野土路的加速度时域曲线,利用Matlab分析软件生成位移功率谱密度,并拟合出标准路面谱,计算出特征值。