Toxicological Assessment of Wastewater and Runoff from the Baikal Pulp and Paper Mill

Russian Journal of Ecology -     

矿物材料吸附去除污水中磷的试验研究

采用粉煤灰、高岭土、泥渣(取电厂澄清池排泥作脱水干燥处理)作为吸附剂深度处理污水中的磷,对比分析了3种吸附剂的吸附速度、吸附性能及除磷效果。结果表明:粉煤灰和高岭土用时20 min完成对磷的有效吸附,沉降泥渣用时5 min即可实现同等吸附效果;沉降泥渣对污水中磷的吸附能力较好,投加量为0.2 g/L的泥渣对磷的去除率可达98.1%,而投加量为0.2 g/L粉煤灰或高岭土对磷的去除率仅达到77.2%。     

Relationship between physicochemical properties and dewaterability of hydrothermal sludge derived from different source

Sewage sludge (SS) and deinking sludge (DS) were used to comparatively study the hydrothermal dewatering of sludge with different components. For a better overview, an insight into the relationship between physicochemical properties and dewaterability of hydrothermal sludge was provided. Results found that not all kinds of sludge were suitably conditioned by hydrothermal treatment (HT) in term of the elevation of dewaterability. Higher hydrothermal temperature tended to enhance the dewaterability of SS rather than DS, which was supported by the variation of their physicochemical properties (including water distribution, bonding energy, extracellular polymeric substance (EPS), particles size, acid functional groups and zeta potential in this study). In addition, the changes in surface morphology suggested that the reverse effect of HT on sludge dewaterability was mainly due to their dewatering behavior. For SS, the destruction of EPS structure leaded to the release of bound water, thereby strengthening sludge dewatering. Conversely, “Bridging effect” generated by lignocellulose in DS was beneficial for sludge dewatering; however, the increasing hydrothermal temperature degraded part of lignocellulose and weakened “bridging effect”, finally resulting in worse dewaterability of DS.     

SBR法处理中药材有机废水工艺研究

应用ＳＢＲ法对中药材有机废水进行了研究。考察了ＣＯＤＣＲ、ＢＯＤ５、ＳＳ、ＮＨ３－Ｈ的处理效果，以及ＰＨ、水温、污泥负荷等条件对去除率的影响。运行结果表明，ＰＨＯ ６．０－９．０、ｔ为１５－３０℃、污沁荷０．３ｋｇＢＯＤ５／ｋｇＭＬＳＳ．ｄ，运行程序：进水０．５ｈ（限制曝气）、曝气１０ｈ、脱氮１．５ｈ，沉降０．５ｈ，排水０．５ｈ、闲置１１ｈ，周期时间２４ｈ时ＣＯＤＣＲ去除率８８％、ＢＯＤ５９４％、     

ASM1中废水和污泥组分浓度的测定方法研究

对呼吸计量法应用于校准ASM1作了简明的阐述。在呼吸速率与模型组分关系的基础上,介绍了ASM1中废水与污泥各组分浓度的测定方法,并指出模型组分细化的意义。     

污泥综合处理技术系统的可行性分析

通过对污泥处理技术现状与污泥组成的分析，认为降低污泥的含水率是改善污泥可处理性的关键。以机械脱水加工热干燥过程可达到充分降低污泥含水率的目的。以此为主干所形成的污泥综合处理系统经能量与经济平衡分析，发现其能量输出大于输入，经济成本合理，有一定的技术经济可行性。     

清洁生产工艺在造纸工业中的应用

介绍了清洁生产这个新概念,清洁生产工艺在造纸工业中的应用,实例表明:造纸废水再循环,不准能节约水资源,节约能源,防止环境污染,而且可以取得良好的经济效益和社会效益,为造纸废水在2000 年前达到国家排准排放奠定了良好基础     

粉煤灰/工业污泥烧结陶粒的制备与应用

以粉煤灰和工业污水处理站的剩余污泥为主要原材料，采用烧结法研制复合陶粒。分析了不同配方和不同烧结温度对陶粒性能的影响，以陶粒吸水率．容重为评价指标确定最佳配比和最佳烧结温度。提出用陶粒铺设景观水底，治理城市水体．并对其进行了可行性分析。粉煤灰／污泥陶粒的容重为0．79～0．9g／cm^3，吸水率为68．95％-80．01％。陶粒对水中氨氮和总磷吸附容量分别为0．03～0．05mg／g和0．01-0.02mg／g。     

Analysis of the hydrocyclone stock cleaning process for wasted fibre in a paper mill

The main objective of this project was to evaluate the possibility of reducing the quantity of fibre wasted at one of many hydrocyclone (centrifugal) cleaning processes in a paper mill. It was found that the application of elutriation water to both the tertiary and quaternary cleaners was essential to minimise the fibre discharged to the sewer, and the pressure of this elutriation water had a dramatic effect of reducing the fibre wastage. Accordingly, it has been shown that 150–160 kPa as the optimum pressure range to apply elutriation water to minimise the product grade fibre wasted whilst sending undesired shive fibre to the sewer. Also, monitoring of the press uhle box wastewater revealed that the paper mill has the potential to make substantial cost savings by reducing the waste stream. Further investigation is necessary to determine the types of fibre that are being wasted, and the viability of a screen to recycle the wasted fibre to the process. However, these fibres may be unsuitable to reuse in the process and alternative uses must be found.     

生物固体在高速公路建设中的资源化应用

生物固体主要指城市污水污泥和部分生活垃圾，其丰富的有机质和干化固化后的稳定性，为应用于高速公路提供了条件。中文介绍了生物固体在路面结构填充和土地施肥复垦两方面的应用方式，并对应用过程中的环境风险及对策进行分析，最后提出应用前景展望。