清洁生产工艺在造纸工业中的应用

介绍了清洁生产这个新概念,清洁生产工艺在造纸工业中的应用,实例表明:造纸废水再循环,不准能节约水资源,节约能源,防止环境污染,而且可以取得良好的经济效益和社会效益,为造纸废水在2000 年前达到国家排准排放奠定了良好基础     

Synergistic effect of F and triggered oxygen vacancies over F-TiO2 on enhancing NO ozonation

Oxidation-absorption technology is a key step for NO_x removal from low-temperature gas. Under the condition of low O₃ concentration (O₃/NO molar ratio = 0.6), F-TiO₂ (F-TiO₂), which is cheap and environmentally friendly, has been prepared as ozonation catalysts for NO oxidation. Catalytic activity tests performed at 120°C showed that the NO oxidation efficiency of F-TiO₂ samples was higher than that of TiO₂ (about 43.7%), and the NO oxidation efficiency of F-TiO₂-0.15 was the highest, which was 65.3%. Combined with physicochemical characteristics of catalysts and the analysis of active species, it was found that there was a synergistic effect between F sites and oxygen vacancies on F-TiO₂, which could accelerate the transformation of monomolecular O₃ into multi-molecule singlet oxygen (¹O₂), thus promoting the selective oxidation of NO to NO₂. The oxidation reaction of NO on F-TiO₂-0.15 follows the Eley-Rideal mechanism, that is, gaseous NO reacts with adsorbed O₃ and finally form NO₂.     

Comparison of mesophilic and thermophilic anaerobic digestions of thermal hydrolysis pretreated swine manure: Process performance, microbial communities and energy balance

Anaerobic digestion (AD) of swine manure (SM) commonly shows low biogas output and unsatisfactory economic performance. In this study, thermophilic AD (TAD, 50 ± 1 °C) was combined with thermal hydrolysis pretreatment (THP, 170 °C/10 bar), to investigate its potential for maximizing biogas yield, securing successful digestion and microbial diversity, as well as improving energy balance. Four lab-scale continuously stirred tank reactors were operated for 300 days and compared with each other, i.e., reactor 1 (raw SM fed in mesophilic AD: RSM-MAD), reactor 2 (THP-treated SM fed in MAD: TSM-MAD), reactor 3 (RSM-TAD), and reactor 4 (TSM-TAD). The results showed that THP was efficient to increase methane production of SM, TSM-TAD mode led to the highest methane yield (129.8 ± 40.5 mL-CH₄/g-VS/day) among the tests (p < 0.05). Although TAD was more likely to induce free ammonia (> 700 mg/L) or volatile fatty acids (> 6000 mg/L) accumulation compared with MAD in start-up phase, TSM-TAD treatment mode behaved a sustainable digestion process in a long-term operation. For TSM-TAD scenario, higher Shannon–Weaver (3.873) and lower Simpson index (0.061) indicated this mode ensured and enlarged the diversity of bacteria communities. Phylum Bathyarchaeota was dominant (59.3%−90.0%) in archaea community, followed by Euryarchaeota in the four reactors. RSM-MAD treatment mode achieved the highest energy output (4.65 GJ/day), TSM-TAD was less effective (−17.38 GJ/day) due to increased energy demands. Thus improving the energetic efficiency of THP units is recommended for the development of TSM-TAD treatment mode.     

SBR滗水器的结构原理及应用

文中系统讲述了SBR旋转式滗水器的结构、工作原理及运行特点，列举了SBR旋转式滗水器的应用实例，使人们对SBR旋转式滗水器有更深的认识，使这种新型的污水处理设备得到更广泛的应用。     

两相UASB反应器处理含高浓度硫酸盐黑液

两相UASB反应器处理含高浓度硫酸盐黑液,酸化相为8.87L的普通升流式反应器,甲烷相为28.75L的UASB反应器,系统温度(35±1)℃。当酸化相进水COD为(6.771～11.057)g/L,SO42-为(5.648～8.669)g/L,pH值为5.5时,整个系统COD去除率平均值为74.42%;系统对负荷的冲击有较强的耐受能力。     

宁安市污水处理厂一体化工艺应用的探讨

通过一体化A/O改良工艺应用,分析其去除COD效果.     

防止井下作业污染环境的工艺技术应用

分析了井下作业施工对环境造成污染的因素，介绍江苏油田在井下作业过程中进行污染防治的措施及其相关配套新工艺、新技术的应用和效果。     

低温A/O-MBR工艺启动试验研究

研究了A/O-MBR工艺低温(水温在5~12℃)启动效能,结果表明,低温下A/O-MBR工艺启动迅速,活性污泥的培养驯化时间较短。启动过程中根据出水水质情况,逐渐提高负荷,运行34 d,系统对COD的去除率能达到90%以上,系统对氨氮的去除率能达到96%以上,至稳定运行后氨氮的负荷平均可达到0.419kg/(m3.d),反硝化效果系统去除率基本能稳定在60%左右。     

SBR法处理低C/N污水的工程应用——以某基地污水处理站改造工程为例

低C/N污水的生化处理过程中,由于碳源不足,不能满足硝化和反硝化的要求,造成出水NH3-N超标。采用SBR工艺对某基地污水处理站厌氧处理后的低C/N污水进行改造,处理后出水COD去除率达到97%以上,NH3-N去除率达到93%以上。     

The role of analogues in radioecology

If no data are available for a specific radionuclide its analogue could be used in radioecological models. They might be used not only in the frame of screening modelling. Relevant processes and features have to be known, such as time scales of these processes, physical, chemical and biological properties of the environment and relevant media. An analogue could only be proven to be valid by comparing its behaviour in the conditions of interest, while confidence in the validity of an analogue will increase as the quality of the justification increases, there will always be some residual uncertainty. Several main types of analogy can be used when measured or recommended values are not available: the same parameter obtained for another isotope of the same element; the same parameter obtained for another element; a different parameter obtained for the same element. There are several cases, when analogues might be applied as indicators of the determining processes in the radioecological studies.