长江三峡柑桔的冻害和热害（二）

本文从柑桔冻害和热害的危害因子和指标等级划分的研究和选取入手,着重探讨了长江三峡地区(湖北境内)两害显著的时空变化特征、差异与关联性及对柑桔生产的影响;揭示了80年代以来冬暖春热的重大气候变化是使两害向“两极分化”的根本原因;讨论了三峡水利工程对两害时空格局的可能调整及减灾原理;最后提出了可能的对策。     

三峡库区中低产土壤重金属含量及其与小麦吸收的关系

三峡库区中低产土壤的Hg,As,Cr,Pb,Cu五个重金属含量（除渝北区外），均在国家土壤环境质量标准内，属自然背景值一级标准。Cd和Zn高于全国土壤中的平均含量和背景值含量，属二级标准。土壤的重金属含量与土壤母质类型，pH值，阳离子交换量，有机质，无定形铁和物理性粘粒有关，同时存在一定的地域分布。重庆近郊的土壤所有重金属含量相对较高。土壤重金属的可给态或有效性含量极低，锌和铜不是过量，而是不足。小麦籽粒中As,Cr,Pb,Zn,Cu含量低于国家食品对重金属限量标准和小麦籽粒背景值标准，Hg,Cd含量高于国家规定标准。籽粒中的Cu,Zn含量是小麦茎叶中的2.0-2.2倍，而茎叶中的Hg,Pb,As,Cr,Cd含量明显高于籽粒。     

长江三峡地区坡地发育初步研究

坡地发育是地貌学研究的基本问题之一。三峡地区坡地发育的研究对三峡库岸稳定性的评估和三峡移民的土地开发具有十分重要的意义。首先从概括坡地发育的研究进展，阐述科学家们对坡地发育的不同看法入手，引出三峡地区坡地发育的特殊性。初步研究三峡地区的坡地发育具有分段式分进的特点，包括中山峰陡坡的剥蚀后退过程，山顶缓坡的风化剥蚀夷平的过程，上段斜坡的片流坡地侵蚀过程，下段陡坡的剥坡后退过程，山麓堆积缓坡的剥蚀过程等。通过分析三峡地区坡地的五种坡段的成因、现状、发展趋势以及它们对三峡库区的稳定性和三峡移民的土地开发的影响，预测未来的三峡库岸，大部分为剥蚀陡坡，部分为崩塌滑坡陡坡，三峡沿岸城镇开发建设的重点将是库岸有坡地的防护工程。     

Acceleration of floc-water separation and floc reduction with magnetic nanoparticles during demulsification of complex waste cutting emulsions

Waste cutting emulsions are difficult to treat efficiently owing to their complex composition and stable emulsified structure. As an important treatment method for emulsions, chemical demulsification is faced with challenges such as low flocs–water separation rates and high sludge production. Hence, in this study, Fe₃O₄ magnetic nanoparticles (MNPs) were used to enhance chemical demulsification performance for treating waste cutting emulsions under a magnetic field. The addition of MNPs significantly decreased the time required to attain sludge–water separation and sludge compression equilibrium, from 210 to 20 min. In addition, the volume percentage of sludge produced at the equilibrium state was reduced from 45% to 10%. This excellent flocculation–separation performance was stable over a pH range of 3–11. The magnetization of the flocculants and oil droplets to form a flocculant–MNP–oil droplet composite, and the magnetic transfer of the composite were two key processes that enhanced the separation of cutting emulsions. Specifically, the interactions among MNPs, flocculants, and oil droplets were important in the magnetization process, which was controlled by the structures and properties of the three components. Under the magnetic field, the magnetized flocculant–MNP–oil droplet composites were considerably accelerated and separated from water, and the sludge was simultaneously compressed. Thus, this study expands the applicability of magnetic separation techniques in the treatment of complex waste cutting emulsions.     

Development of a static test apparatus for evaluating the performance of three PM2.5 separators commonly used in China

PM_(2.5) separator directly affects the accuracy of PM_(2.5) sampling.The specification testing and evaluation for PM_(2.5) separator is particularly important,especially under China's wide variation of terrain and climate.In this study,first a static test apparatus based on polydisperse aerosol was established and calibrated to evaluate the performance of the PM_(2.5) separators.A uniform mixing chamber was developed to make particles mix completely.The aerosol concentration relative standard deviations of three test points at the same horizontal chamber position were less than 0.57%,and the particle size distribution obeyed logarithmic normal distribution with an R~2 of 0.996.The flow rate deviation between the measurement and the set point flow rate agreed to within ± 1.0% in the range of -40 to 50℃.Secondly,the separation,flow and loading characteristics of three cyclone separators(VSCC-A,SCC-A and SCC112) were evaluated using this system.The results showed that the 50% cutoff sizes(D_(50)) of the three cyclones were 2.48,2.47 and 2.44 μm when worked at the manufacturer's recommended flow rates,respectively.The geometric standard deviation(GSD) of the capture efficiency of VSCCA was 1.23,showed a slightly sharper than SCC-A(GSD = 1.27),while the SCC112 did not meet the relevant indicator(GSD = 1.2 ± 0.1) with a GSD = 1.44.The flow rate and loading test had a great effect on D_(50),while the GSD remained almost the same as before.In addition,the maintenance frequency under different air pollution conditions of the cyclones was summarized according to the loading test.     

Analytical methods and environmental processes of nanoplastics

The degradation of plastic debris may result in the generation of nanoplastics (NPs). Their high specific surface area for the sorption of organic pollutions and toxic heavy metals and possible transfer between organisms at different nutrient levels make the study of NPs an urgent priority. However, there is very limited understanding on the occurrence, distribution, abundant, and fate of NPs in the environment, partially due to the lack of suitable techniques for the separation and identification of NPs from complex environmental matrices. In this review, we first overviewed the state-of-the-art methods for the extraction, separation, identification and quantification of NPs in the environment. Some of them have been successfully applied for the field determination of NPs, while some are borrowed from the detection of microplastics or engineered nanomaterials. Then the possible fate and transport of NPs in the environment are thoroughly described. Although great efforts have been made during the recent years, large knowledge gaps still exist, such as the relatively high detection limit of existing method failing to detect ultralow masses of NPs in the environment, and spherical polystyrene NP models failing to represent the various compositions of NPs with different irregular shapes, which needs further investigation.     

无机痕量分析中预富集技术的应用现状及前景

综述了预富集技术在无机痕量分析中的应用，概述了国内外最新进展，介绍了主要技术及方法的特点，大量文献表明预富集技术用于痕量分析取得满意的效果，降低了检测限，提高了灵敏度。     

三峡大坝对重庆城区水环境的影响及对策

本文在假定城区排污量维持1990年水平的条件下,用计算机模拟了三峡大坝建成后重庆城区长江、嘉陵江岸边污染带增宽的情况。同时,借助水质模型模拟的2000年时城区的水质状况和城区两个控制断面上的多年监测浓度值,用灰色理论预测了三峡水库形成后重庆城区的实际岸边污染带宽度和九种污染物的断面平均浓度。最后,提出一套最佳的对策方案及投资估算。     

1000t/d含油废水旋流分离技术及设备研究

将实验室研制的 HL 型旋流器用压力容器式方式并联起来 ,建立 10 0 0 t/ d规模的示范装置 ,并进行试验。示范装置的试验结果表明 ,与工业测试比较 ,HL型旋流器并没有因为规模的放大而造成性能下降 ,它能取代石化行业目前采用的“一隔二浮”流程中的大部分装置 ,具有明显的经济效益和广阔的应用前景     

皮革废水物化处理工艺整改的试验研究

在扬州某皮革厂原有的废水处理设施基础上，采用浓淡分流，药剂调整等方法。对其物化处理部分进行整改。结果表明，用Fe2SO4作混凝剂处理浓废水及用复合混凝剂处理淡废水，效果较好。处理后，可减少排放废水CODcr约1252t／a。处理成本从原来的4.03元／t降到1.30元／t。同时，降低了加药量的控制难度与加药频率，减轻了工人的劳动强度。