Particulate matter exchange between atmosphere and roads surfaces in urban areas

The deposition and the re-suspension of particulate matter (PM) in urban areas are the key processes that contribute not only to stormwater pollution, but also to air pollution. However, investigation of the deposition and the re-suspension of PM is challenging because of the difficulties in distinguishing between the resuspended and the deposited PM. This study created two Bayesian Networks (BN) models to explore the deposition and the re-suspension of PM as well as the important influential factors. The outcomes of BN modelling revealed that deposition and re-suspension of PM10 occurred under both, high-traffic and low-traffic conditions, and the re-suspension of PM2.5 occurred under low-traffic conditions. The deposition of PM10 under low-volume traffic condition is 1.6 times higher than under high-volume traffic condition, which is attributed to the decrease in PM10 caused by relatively higher turbulence under high-volume traffic conditions. PM10 is more easily resuspended from road surfaces compared to PM2.5 as the particles which larger than the thickness of the laminar airflow over the road surface are more easily removed from road surfaces. The increase in wind speed contributes to the increase in PM build-up by transporting particulates from roadside areas to the road surfaces and the airborne PM2.5 and PM10 increases with the increase in relative humidity. The study outcomes provide a step improvement in the understanding of the transfer processes of PM2.5 and PM10 between atmosphere and urban road surfaces, which in turn will contribute to the effective design of mitigation measures for urban stormwater and air pollution.     

矿物材料吸附去除污水中磷的试验研究

采用粉煤灰、高岭土、泥渣(取电厂澄清池排泥作脱水干燥处理)作为吸附剂深度处理污水中的磷,对比分析了3种吸附剂的吸附速度、吸附性能及除磷效果。结果表明:粉煤灰和高岭土用时20 min完成对磷的有效吸附,沉降泥渣用时5 min即可实现同等吸附效果;沉降泥渣对污水中磷的吸附能力较好,投加量为0.2 g/L的泥渣对磷的去除率可达98.1%,而投加量为0.2 g/L粉煤灰或高岭土对磷的去除率仅达到77.2%。     

Relationship between physicochemical properties and dewaterability of hydrothermal sludge derived from different source

Sewage sludge (SS) and deinking sludge (DS) were used to comparatively study the hydrothermal dewatering of sludge with different components. For a better overview, an insight into the relationship between physicochemical properties and dewaterability of hydrothermal sludge was provided. Results found that not all kinds of sludge were suitably conditioned by hydrothermal treatment (HT) in term of the elevation of dewaterability. Higher hydrothermal temperature tended to enhance the dewaterability of SS rather than DS, which was supported by the variation of their physicochemical properties (including water distribution, bonding energy, extracellular polymeric substance (EPS), particles size, acid functional groups and zeta potential in this study). In addition, the changes in surface morphology suggested that the reverse effect of HT on sludge dewaterability was mainly due to their dewatering behavior. For SS, the destruction of EPS structure leaded to the release of bound water, thereby strengthening sludge dewatering. Conversely, “Bridging effect” generated by lignocellulose in DS was beneficial for sludge dewatering; however, the increasing hydrothermal temperature degraded part of lignocellulose and weakened “bridging effect”, finally resulting in worse dewaterability of DS.     

SBR法处理中药材有机废水工艺研究

应用ＳＢＲ法对中药材有机废水进行了研究。考察了ＣＯＤＣＲ、ＢＯＤ５、ＳＳ、ＮＨ３－Ｈ的处理效果，以及ＰＨ、水温、污泥负荷等条件对去除率的影响。运行结果表明，ＰＨＯ ６．０－９．０、ｔ为１５－３０℃、污沁荷０．３ｋｇＢＯＤ５／ｋｇＭＬＳＳ．ｄ，运行程序：进水０．５ｈ（限制曝气）、曝气１０ｈ、脱氮１．５ｈ，沉降０．５ｈ，排水０．５ｈ、闲置１１ｈ，周期时间２４ｈ时ＣＯＤＣＲ去除率８８％、ＢＯＤ５９４％、     

生活垃圾生物处理的研究与展望

综述了国内外生活垃圾生物处理的研究进展和目前生活垃圾微生物研究水平，以及生活垃圾处理发展趋势与新动向，在此基础上提出了生活垃圾处理的建议和展望。     

ASM1中废水和污泥组分浓度的测定方法研究

对呼吸计量法应用于校准ASM1作了简明的阐述。在呼吸速率与模型组分关系的基础上,介绍了ASM1中废水与污泥各组分浓度的测定方法,并指出模型组分细化的意义。     

污泥综合处理技术系统的可行性分析

通过对污泥处理技术现状与污泥组成的分析，认为降低污泥的含水率是改善污泥可处理性的关键。以机械脱水加工热干燥过程可达到充分降低污泥含水率的目的。以此为主干所形成的污泥综合处理系统经能量与经济平衡分析，发现其能量输出大于输入，经济成本合理，有一定的技术经济可行性。     

厌氧-混凝工艺处理造纸厂终端废水试验研究

本文报告了用厌氧 -混凝工艺处理造纸厂终端废水的实验情况 ,在最佳实验条件下 ,废水从CODcr80 6 . 7m g/ L、BOD52 10 . 5 m g/ L、SS2 15 . 7m g/ L、OD4 650 . 35 0降至 CODcr6 1. 5 m g/ L、BOD52 7. 4m g/ L、SS17.3mg/ L、OD4 650 .0 11。实验结果表明对造纸厂终端废水的治理 ,本工艺是很有实用价值的一种方法     

粉煤灰/工业污泥烧结陶粒的制备与应用

以粉煤灰和工业污水处理站的剩余污泥为主要原材料，采用烧结法研制复合陶粒。分析了不同配方和不同烧结温度对陶粒性能的影响，以陶粒吸水率．容重为评价指标确定最佳配比和最佳烧结温度。提出用陶粒铺设景观水底，治理城市水体．并对其进行了可行性分析。粉煤灰／污泥陶粒的容重为0．79～0．9g／cm^3，吸水率为68．95％-80．01％。陶粒对水中氨氮和总磷吸附容量分别为0．03～0．05mg／g和0．01-0.02mg／g。     

A2/O工艺处理氨纶废水的应用研究

介绍了采用厌氧-缺氧-接触氧化(即A2/O)组合工艺处理氨纶生产废水的流程和设计参数,通过近半年的调试数据,反应季节对A2/O组合工艺处理氨纶生产废水的影响和可行性。提出运行过程中需要控制的参数,提供设计和运行参考。