Review: recent advances in biogas purifying technologies

Biomethane production through biogas upgrading is a promising renewable energy for some industries which could be part of the equilibrium needed with fossil fuels consumption to achieve a sustainable society. This paper presents a comprehensive list of biogas upgrading technologies focused on carbon dioxide removal as well as recent advances reported by researcher with wide expertise in this topic. Additionally, an extensive costs–performance comparison among the technologies studied is discussed. Among the different alternatives, chemical scrubbing stood out to achieve high biomethane purities while cryogenic technologies proved to be effective against methane losses. Regarding the different costs, water scrubbing and membrane separation seem to be the most affordable techniques.     

Effects of SO2 and H2O on low-temperature NO conversion over F-V2O5-WO3/TiO2 catalysts

F-V_2 O_5-WO3/Ti02 catalysts were prepared by the impregnation method.As the content of F ions increased from 0.00 to 0.35 wt.%,the NO conversion of F-V_2 O_5-WO_3/TiO_2 catalysts initially increased and then decreased.The 0.2 F-V_2 O_5-WO_3/TiO_2 catalyst(0.2 wt.% F ion)exhibited the best denitration(De-NOx) performance,with more than 95% NO conversion in the temperature range 160-360℃,and 99.0% N2 selectivity between 110 and 280℃.The addition of an appropriate amount of F ions eroded the surface morphology of the catalyst and reduced its grain size,thus enhancing the NO conversion at low temperature as well as the sulfur and water resistance of the V_2 O_5-WO3/Ti02 catalyst.After selective catalytic reduction(SCR) reaction in a gas flow containing SO_2 and H_2 O,the number of NH3 adsorption sites,active component content,specific surface area and pore volume decreased to different degrees.Ammonium sulfate species deposited on the catalyst surface,which blocked part of the active sites and reduced the NO conversion performance of the catalyst.On-line thermal regeneration could not completely recover the catalyst activity,although it prolonged the cumulative life of the catalyst.In addition,a mechanism for the effects of S02 and H_2 O on catalyst NO conversion was proposed.     

硅胶表面TEOS疏水化改性及吸附VOCs特性

以正硅酸乙酯（TEOS）为疏水改性剂,通过硅胶表面的羟基接枝反应,得到具备一定疏水性的改性硅胶;利用BET、FT-IR、XRD和TG-DTG等手段对改性硅胶的结构及稳定性进行了表征;在此基础上考察了改性硅胶对各类有机废气的吸附性能.结果表明,TEOS成功接枝在了硅胶表面,改性硅胶不仅具备一定的疏水性,而且机械强度增加到原来的66.85%,稳定性也都得到了提高; 550℃空气下焙烧后的改性硅胶仍具有疏水性且吸附容量是焙烧之前的2倍;在高湿度高浓度的废气治理中,TEOS改性硅胶表现出更高的吸附能力和优良的热再生性能.高浓度下改性硅胶的吸附容量是低浓度下的10倍且不受水汽的影响;改性硅胶循环10次的吸附/脱附几乎不变,且在一定条件下,15~30min就达到90%的脱附率.     

磁性氧化石墨处理乳化含油废水及磁致增强效应

以高铁酸钾为氧化剂,基于改进Hummers法制备了新型磁性氧化石墨材料,在SEM、FTIR、氮气吸脱附和表面接触角表征基础上,探究了该材料处理乳化含油废水的效果及磁致增强效应.结果表明：相较于石墨,磁性氧化石墨比表面积增大,表面有卷曲结构并负载着Fe₃O₄颗粒,具有含氧官能团,存在疏水性较强的微观孔隙结构.在外加磁场条件下,磁性氧化石墨团聚,形成疏水性宏观孔隙结构,利于乳化油滴的吸附和附着.磁性氧化石墨处理乳化含油废水的能力远好于石墨与粉末活性炭,且处理效率与磁场强度成正相关,COD去除率可达95%以上.使用后的磁性氧化石墨进行溶剂萃取或热处理,可以循环使用.磁性氧化石墨经过4次循环使用,热再生效率为92%,溶剂萃取再生效率为86%.以上研究为乳化含油废水的处理提供了一种有效的方法.     

螯合树脂在线富集——火焰原子吸收光度法测定水中微量Cu,Pb,Zn,Cd

对螯合树脂在线富集，火焰原子吸收光度法进行了条件试验。试验证实方法对Ｃｕ、Ｐｂ、Ｚｎ、Ｃｄ４个元素检出浓度可达μｇ／Ｌ级，校准曲线性、样品重现性及准确度可满足测定要求。     

火焰原子吸收分光光度法测定鱼内脏及河流底泥中的铜

采用火焰原子吸收分光光度法测定鱼内脏及河流底泥中的铜。鱼内脏经组织捣碎机捣成匀浆后，加硝酸消解；底泥则经氢氟酸和高氯酸消化。该方法具有灵敏度高，精密度和回收率较好等特点。     

Comparison of Two Manual Methods of Nitrogen Dioxide Determination in Ambient Air

Sodium arsenite (modified Jacobs and Hochheiser method; hereafter referred as SA), the most widely used manual monitoring method for determination of nitrogen dioxide (NO₂) in ambient air, particularly in developing countries has been evaluated and compared with US EPA recommended equivalent method of TGS-ANSA (hereafter referred as ANSA). NO₂ concentrations generated from laboratory test atmosphere were analyzed by these two methods and were compared statistically. Laboratory evaluations showed that SA method has high sensitivity to different sampling conditions, which normally vary during actual field monitoring. Hence, correction factors for absorption efficiency were estimated for SA and ANSA methods. Absorption efficiency of NO₂ in SA method was found to be much lower (64%) as against the reported value of 82% at the method recommended sampling conditions, whereas for ANSA method, it was found 1.0 as against the reported value of 0.93. After applying derived correction factors, both the methods produced almost similar concentration values of NO₂.     

过硫酸钾氧化-紫外光度法测定总氮方法的改进

过硫酸钾氧化紫外光度法测定总氮的空白吸光度高的主要原因是：K2S2O3是220nm波长上有特征吸收，适当降低K2S2O3、NaOH的用量，延长消解时间，使用二次蒸馏水，用低浓度亚砷酸钠溶液，还原消解后剩余的极少量的K2S2O3，可以降低空白吸光度。K2S2O3-NaOH碱溶液不稳定，使用期短，三天后氧化能力迅速降低，原因是：K2S2O3溶液中，加入NaOH，加速了K2S2O3的分解。K2S2O3和NaOH分别配制，并在K2S2O3溶液中，加入少量HCl，抑制其水解。两种溶液可使用半年以上时间。     

恶臭污染防治技术及工程实践

目前，恶臭污染对人类生活的危害日益加剧，文中介绍了几种恶臭污染物的防治技术。对生物滴滤池 活性炭吸附工艺进行了探讨，工程实例表明具有良好的治理效果。     

废旧塑料回收利用技术

从我国废塑料回收利用的现状出发 ,分析了今后我国废塑料回收利用技术的发展趋势和应采取的措施 ,指出了废塑料回收利用的重要性。