Using chemical process simulation to design industrial ecosystems

Chemical process simulation (CPS) software has been widely used by chemical (process) engineers to design, test, optimise, and integrate process plants. It is expected that industrial ecologists to bring these same problem-solving benefits to the design and operation of industrial ecosystems can use CPS. This paper provides industrial ecology researchers and practitioners with an introduction to CPS and an overview of chemical engineering design principles. The paper highlights recent research showing that CPS can be used to model industrial ecosystems, and discusses the benefits of using CPS to address some of the technical challenges facing companies participating in an industrial ecosystem. CPS can be used to (i) quantitatively evaluate and compare the potential environmental and financial benefits of material and energy linkages; (ii) solve general design, retrofit, or operational problems; (iii) help to identify complex and often counter-intuitive solutions; and (iv) evaluate what-if scenarios. CPS should be a useful addition to the industrial ecology toolbox.     

安徽月山地区闪长岩类地质地球化学研究

安徽月山地区是长江中下游地区的重要成岩-成矿区段。本文通过岩石学、岩石化学和同位素地球化学等方面的研究，探讨和阐明了月山地区闪长岩类的形成环境、物质来源、源区特征、岩浆形成与演化机理等。     

从动力地质作用原理探讨沙漠化成因

大规模沙漠化从岩石记录中可以追溯到中生代中期，第四纪以来南北两半球各存在一条中纬度沙漠带，中国的沙漠化是这个全球沙漠化进程的一个组成部分。沙漠化是在地质演化过程中受内、外动力地质作用联合控制的地质事件。是岩石圈与大气圈、生物圈及水圈强烈作用在地壳表层形成的一种特殊地质现象。这种现象的形成与演化是漫长的和具有周期性的，不会因为局部的条件变化而发生整体意义上的突变。人类活动是局部的，在整个地球沙漠化进程中只是起到一个加速剂的作用。沙漠化过程可分为3个阶段，即物理风化与沙源积聚阶段、风沙作用阶段和沙漠化阶段。沙漠期后沙丘沙经过固化生草、胶结成岩阶段后即形成风成砂岩。     

The influence of sewage sludge properties on sludge-borne metal availability

With the advent of more stringent controls on wastewater treatment, sewage sludge production in Europe and many parts of the world is increasing. With this increase comes the problem of sludge disposal, and recycling to land arguably offers an economically and environmentally sustainable option. However, a major limitation of sewage sludge reuse is the potential release of heavy metals from the sludge and heavy metal accumulation to toxic levels in topsoils. The properties of the sludge play a crucial role in determining the initial release and subsequent availability of heavy metals in amended soils. Bioavailable forms of heavy metals in recently amended soils are most likely to be those that are bioavailable in the sewage sludge. In this paper, published research on the importance of sewage sludge characteristics on metal release and bioavailability will be reviewed and contrasted with original research. A selection of sludges from around Australia has been collected for this purpose. Through the use of incubation studies, isotope dilution techniques, ion-selective electrode measurements and ¹³C-NMR spectroscopy, the importance of a range of sludge properties on heavy metal behaviour in sludges and sludge-amended soils is addressed.     

厌氧升流式污泥层反应器内污泥颗粒化对固液分离效果的影响

厌氧升流式污泥层反应器在较高的COD容积负荷和水力负荷下稳定运行的关键是要有良好的固液分离,而固液分离的必要条件是污泥的沉降速度大于混合液在三相分离器的沉降区的最小断面上的向上流速。通过小型装置的试验表明,污泥的沉降速度与污泥的性状和浓度有关,使反应器内的污泥颗粒化能改善污泥沉降性、提高固液分离效果,使反应器能在相当高的COD容积负荷(20—30kgCOD/m~3·d)和水力负荷(0.8m~3/m~2·h)下稳定运行。本文叙述了厌氧升流式污泥层反应器内的污泥颗粒化过程,并简要地讨论了培养颗粒污泥的基本条件。     

活性污泥生长的控制

在污水处理过程中，针对不同的运行环境，我们选择适当的运行工艺和参数。通过控制菌胶团细菌和丝状菌平衡生长，或者是使固着型原生动物占优势，来获得良好的活性污泥，保证出水达标排放。     

转炉污泥干法脱硫新技术应用

采用转炉污泥取代铸铁屑配制焦炉煤气脱硫剂,转炉污泥与稻壳体积配比为1∶2,水分30%～40%,pH值8～10。经过生产实践证明,脱硫效率达到996%～998%。既降低了煤气生产成本,减轻工人劳动强度,又提高了民用煤气质量,具有可观的环境效益与经济效益。     

二沉池漂泥原因及控制措施

二级污水处理厂二沉池漂泥有反硝化漂泥、活性污泥老化漂泥、生物泡沫导致的漂泥。最终的解决办法是：分析漂泥原因、对症下药、改善工艺运行状况、采取有效的控制措施.     

生物作用强化城市污水一级处理工艺研究

提出生物作用强化城市污水一级处理工艺 ,探讨利用生物絮凝吸附作用独立承担城市污水处理任务的可行性、影响因素及运行参数。试验证明 ,处理城市污水 ,当HRT为 1 1h ,DO为 1 0mg L ,CODCr污泥负荷为 3 4～ 4 0kg kg·d时 ,CODCr、BOD5和SS去除率分别为 6 8%～ 78%、6 5 %～ 72 %和 75 %～ 85 %。     

加压活性炭生物膜法处理DSD有机废水

采用加压活性炭生物膜法处理以对硝基甲苯磺酸盐为主的难降解的有机废水的研究,是在活性炭生物膜法处理有机废水基础上发展起来的新技术。本实验结果表明,在加压9.8×10~4Pa(1kgt/cm~2)的条件下,COD_(Cr)去除率为62％～70％,比常压活性炭生物膜法高20％～25％;其容积负荷Nv=1.7～2.9kgCOD/m~3·d,比一般活性污泥法高3～6倍。