乙醇汽油与普通汽油非常规污染物排放特性对比研究

在一台满足国Ⅴ排放标准的双喷射(气口喷射+缸内直喷)汽油机上开展了燃用E10乙醇汽油(乙醇体积比为10%)对发动机非常规排放特性影响的试验研究.使用傅里叶变换红外分析仪(FTIR)测量了饱和烃、不饱和烃、芳香烃及醇、醛等非常规污染物排放量,对比分析了双喷射模式时各工况下E0和E10两种燃料的非常规排放水平.结果表明,双喷射模式下,加入乙醇有效降低了乙烯、1,3-丁二烯、苯和甲苯的排放量,但会导致乙醛排放升高.双喷射模式下,随着负荷增加,两种燃料下的1,3-丁二烯和甲苯排放呈现先升高后降低的趋势,乙烯、甲醛和苯排放则先降低后升高.乙醇能抑制1,3-丁二烯、乙烯生成,抑制效果为PFI模式优于双喷射模式,GDI模式抑制量最低.PFI和GDI模式下E10的甲醛排放均显著升高,但双喷射模式有效抑制了甲醛排放的增加.     

Investigation to meet China II emission legislation for marine diesel engine with diesel methanol compound combustion technology

In order to reduce the pollutant emission and alleviate the pressure of petroleum resources shortage and greenhouse gas emission at the same time, the use of clean and renewable alternative fuel for marine engines is a promising option. In this study, a marine diesel engine, which was modified to run in diesel methanol compound combustion (DMCC) mode, was investigated. After the diesel injection parameters were calibrated, and combined with a sample after-treatment device DOC (diesel oxidation catalyst), the engine could meet the requirements of China II legislation. The overall MSP (methanol substitute percent) reached 54.1%. The value of each pollutant emission was much lower than that in China II emission legislation, and there was almost no methanol and formaldehyde emissions. When methanol was injected into the inlet manifold, the intake air temperature decreased a lot, as well as the exhaust gas temperature, which were beneficial to increase engine thermal efficiency and improve engine room environment. Compared with the engine running in pure diesel mode, when the engine ran in diesel/methanol dual fuel mode, the combustion phase was advanced, and the combustion duration became shorter. Therefore, the engine thermal efficiency increased, and fuel consumption decreased significantly.     

芳纶纤维对飞机尾翼结构抗鸟撞性能影响研究

目的研究飞机尾翼结构采用芳纶纤维复合材料的抗鸟撞性能。方法根据芳纶纤维夹芯和芳纶纤维层合板两种飞机尾翼前缘构型,分别建立有限元模型进行仿真计算,分析两种构型鸟撞后的损伤和变形,并对两种构型进行抗鸟撞性能研究试验。结果芳纶夹芯前缘构型前缘凹陷,前梁没有破裂;芳纶层合板前缘构型前缘破裂,前梁有破损。试验结果与仿真分析结果高度吻合。结论芳纶夹芯前缘构型比芳纶层合板前缘构型具有更好的抗鸟撞性能。芳纶纤维层合板构型会造成前缘蒙皮变形过大,前梁腹板破损,导致飞机鸟撞后维修成本较高。     

飞机用铝合金腐蚀行为和腐蚀预测研究现状及问题分析

针对不同的航空铝合金结构及部位,从腐蚀机理、腐蚀行为和腐蚀预测技术三方面较为系统地分析了研究现状及进展。在此基础上,明确了航空铝合金腐蚀预测技术需要进一步研究的问题,分别为飞机结构表面腐蚀环境的确定问题,材料在海洋大气环境下腐蚀电化学性能的准确测量问题,腐蚀预测模型的选取问题。     

Multipoint source method in air pollution modelling of cold start emission

The paper presents a new method of air pollution modelling on a micro scale. For estimation of concentration of car exhaust pollutants, each car is treated as an instantaneous moving emission source. This approach enables us to model time and spatial changes of emission, especially during cold and cool start of an engine. These stages of engine work are a source of significant pollution concentration in urban areas. In this work, two models are proposed: one for the estimation of emission after cold start of the engine and another for the prediction of pollutant concentration. The first model (defined for individual exhaust gas pollutants) enables us to calculate the emission as a function of time after the cold or cool start, ambient temperature and average speed of motion. This model uses the HBEFA database. The second mathematical model is developed in order to calculate the pollutant dispersion and concentrations. The finite volume method is applied to discretise the set of partial differential equations describing wind flow and pollutant dispersion in the domain considered. Models presented in this paper can be called short-term models on a small spatial scale. The results of numerical simulation of pollutant emission and dispersion are also presented.     

中国华北地区冬季大气污染物航空测量(Ⅰ)——空中气态污染物污染特征研究

为掌握致酸大气污染物ＳＯ２ 和ＮＯｘ 的空间浓度分布，并探讨上述污染物扩散、迁移和传输规律，进而研究其在酸性降水形成过程中的作用，在“八五”期间酸性降水的研究中，针对中国华北地区城市和工业集中以及ＳＯ２ 和ＮＯｘ 等酸性大气污染物排放量大的特点，以石家庄及其以东地区为飞行区域，进行了华北地区冬季空中ＳＯ２ 和ＮＯｘ 污染特征的航空测量。通过测定发现在华北地区１－５ ｋｍ 左右的空中存在着ＳＯ２ 和ＮＯｘ 高浓度污染空域，同时ＳＯ２ 存在着高浓度汇集区     

A comparison of hydrocarbons emission from engine running 85# gasoline and M-100 methanol fuel

Increasing global interest in methanoi fuel has led us to investigate the exhaust emissionsof its engine. Analysis of its inorganic and organic emissions. such as CO. NO_x and hydrocarbons(total HC) have been widely reported. This paper presents an analysis of more than 20 kinds ofhydrocarbons in the emissions obtained from a spark-ignition Shanghai car running 85^# gasoline anda comparison with emission from a Santana test car running M-100 methanol fuel. A set ofenrichment method has also been described. Test results show that at the current stage of methanolengine development the concentration of individual hydrocarbon including some poisonous substancesis lower than those of normal gasoline engine.     

船舶柴油机NOx后处理技术的进展

根据国内外的降低NOx排放方面最新的成果和科研动态，主要介绍了当前正在研究或者已经应用于实际的有效降低柴油机NOx排放的技术措施，并分析了各种技术方法的特点和在实际应用过程中面临的问题。     

柴油发动机隔振方面的仿真研究

本文主要研究模糊控制技术在柴油发动机隔振系统中的应用，将模糊控制技术引入柴油发动机隔振主动控制系统，针对柴油发动机隔振模拟实验台架的振动特点，建立了控制系统数学模型，进行了柴油发动机隔振模拟实验台架垂直方向的仿真研究。     

柴油汽车掺烧LPG降低黑烟排放技术

研究了柴油机掺烧液化石油气(LPG)以降低黑烟排放的技术方案，并开发出了一种以独特型板调节装置为特征的机械控制式柴油/LPG双燃料供给系统。发动机不改变原有结构加装该系统后即成为柴油/LPG双燃料发动机，可以同时燃烧柴油和LPG两种燃料，并且在整个工作范围内，随着工况变化能够按照预先优化设定的型板型线规律而自动调节柴油／LPG供给量比例，使烟度降低50％以上，同时满足经济性、动力性以及操作性能等要求，此外，也可以切换为单独燃烧柴油，而不改变发动机的原有性能。该系统结构简单、成本低廉，非常适合于改装城市在用公交车，降低其黑烟排放。