全程自养颗粒污泥快速启动及混合营养型脱氮性能分析

在连续流条件下,基于颗粒污泥全程自养脱氮（CANON）工艺的快速启动和混合营养条件下高效脱氮,是CANON工程应用的重要环节.本研究在气提内循环反应器（AIR）中,以老化的CANON颗粒污泥经机械破碎至0.3 mm作为种泥,实现混合营养型单级颗粒污泥同步脱氮除碳.启动26 d,通过控制DO,系统出现稳定的部分硝化,再缩短HRT提升氨氮负荷至5.65 kg ·（m³ ·d）^-1,促进颗粒化和厌氧氨氧化;第68 d,总氮去除率达到58%之后,进水加入有机物,C/N从0提升到0.25和0.5,促进AOB、AMX和异养微生物的协同,氨氮去除率达95%,总氮去除率达85%,COD去除率达80%左右.COD浓度增加,能较好地抑制Nitrospira菌属等NOB的活性,q（NH₄⁺-N）和q（TN）稳定在0.4 g ·（g ·h）^-1和0.34 g ·（g ·h）^-1,q（NO₃^--N）约为0.02 g ·（g ·h）^-1.采用MiSeq高通量测序对微生物多样性分析,表明有机物对污泥中Nitrosomomas和Candidutus_Kuenenia丰度未产生显著影响,增加了Candidutus_Brocadia菌属以及具有反硝化功能Denitratisoma等菌属的丰度.这对于快速启动连续流CANON颗粒污泥工艺处理低C/N比废水提供思路.     

Membrane fouling control by ultrasound in an anaerobic membrane bioreactor

In this study, ultrasound was used to control the membrane fouling online in an anaerobic membrane bioreactor (AMBR). Short-term running experiments were carried out under different operating conditions to explore feasible ultrasonic parameters. The experimental results indicated that when the crossflow velocity was more than 1.0 m/s, membrane fouling could be controlled effectively only by hydrodynamic methods without ultrasound. When ultrasound was applied, an ultrasonic power range of 60–150 W was suitable for the membrane fouling control in the experimental system. The experimental results showed that the membrane fouling was controlled so well that membrane filtration resistance (ΣR) could stay at 5 × 10¹¹ m⁻¹ for more than a week with the crossflow velocity of 0.75 m/s, which equaled the effect of crossflow velocity of more than 1.0 m/s without ultrasound. Translated from Techniques and Equipment for Environmental Pollution Control, 2006, 7(4): 25–29 [译自: 环境污染治理技术与设备]     

膜生物反应器膜污染的水力学控制实验研究

叙述了膜污染是影响膜-生物反应器处理技术推广应用的关键因素，采用水动力学方法是控制膜污染的有效方法。在不同污泥浓度条件下。对不同曝气强度下膜污染的发展速率及其形成机理进行了试验研究，研究结果表明：对应于不同污泥浓度均存在一个经济曝气强度，其大小随污泥浓度升高呈线性增加，膜生物反应器在经济曝气强度条件下运行可控制膜污染的发展；并从理论上推导出一个临界污泥浓度，其值为5．15g／L。对应于临界污泥浓度，并且污泥絮体在膜面可形成比较稳定的动态膜，膜过滤压差上升的速率最慢，膜生物反应器在此临界污泥浓度条件下运行膜污染发展最为缓慢。     

产酸脱硫反应器中COD/SO_4~(2-)比制约的群落生态演替规律

通过产酸脱硫反应器的动态试验和配套的静态试验 ,考察致变因子COD/SO2 - 4比制约的乙酸型顶极群落的结构、优势种群的组成和生态演替的规律 ;阐明乙酸型代谢和乙酸型顶极群落是产酸脱硫生态系统的典型特征 ;揭示乙酸型顶极群落内平衡与反馈调节的生理代谢机制 ,并以因变因子 pH值、氧化还原电位和碱度来表征生态演替过程中优势种群的三维实现生态位     

膜生物反应器去除废水中阴离子表面活性剂的研究

阴离子表面活性剂是环境中分布广泛且具有代表性的一类有机污染物.采用分置式膜生物反应器(MBR)进行去除模拟废水中阴离子表面活性荆(LAS)的实验,结果表明:MBR对阴离子表面活性荆的去除率高于90%.同时考察了阴离子表面活性荆生物降解的影响因素,确定其适宜降解条件为:气体流量为0.3m3/h、活性污泥浓度为6948mg/L.初步探讨了降解动力学和降解机理,研究表明对阴离子表面活性剂的去除符合拟一级反应动力学过程,且生物降解对其去除起主要作用.     

膜生物反应器中膜污染研究进展

膜生物反应器是近年新发展起来的高效废水处理工艺。本文综述了国内外对膜污染机理研究的最新成果 ,介绍了相应的解决措施 ,展望了今后的发展前景。     

膜生物反应器与传统活性污泥工艺除污特性比较

比较了膜生物反应器（MBR）和传统活性污泥工艺（CAS）在相同运行条件下对生活污水的除污特性.结果表明,MBR系统对COD、NH3-N和TN的平均去除率比CAS分别高14.4%、51.2%和37.3%.但MBR中膜的截留使系统相对比较封闭,制约了通过排放高磷污泥的生物法除磷,除磷效率仅为32.9%,低于CAS工艺（43.0%）;将MBR与化学除磷工艺相结合,MBR系统除磷效率可达93.3%.     

Treatment of a dyeing wastewater from a woolen mill using an A/O membrane bio-reactor

ＩｎｔｒｏｄｕｃｔｉｏｎＴｈｅｄｙｅｉｎｇｗａｓｔｅｗａｔｅｒｏｆｗｏｏｌｅｎｍｉｌｌｃｏｎｔａｉｎｓａｌｏｔｋｉｎｄｓｏｆｐｏｌｌｕｔａｎｔｓ,ｓｕｃｈａｓａｃｉｄｉｃｄｙｅｓ,ｄｉｓｐｅｒｓｅｄｙｅｓ,ｍｏｒｄａｎｔｄｙｅｓ,ａｕｘｉｌｉａｒｉｅｓ,ｓａｌｔｓａｎｄｓｏｏｎ .Ｔｈｅｅｆｆｌｕｅｎｔｓｆｒｏｍｗａｓｔｅｗａｔｅｒｔｒｅａｔｍｅｎｔｐｌａｎｔｓｆｏｒｔｒｅａｔｍｅｎｔｏｆｔｈｅｄｙｅｉｎｇｗａｓｔｅｗａｔｅｒｏｆｗｏｏｌｅｎｍｉｌｌｓｗｉｔｈｎｏｒｍａｌｂｉｏｌｏｇｉｃａｌｐｒｏｃｅ…     

Test of membrane bioreactor for waste water treatment in a petrochemical complex

Membrane bioreactor (MBR) used in water and waste water treatment is a developing technique for water pollution control and water reuse. This paper describes a membrane-bioreactor for treatment of waste water in a petrochemical complex. The experimental MBR was a lab scale one composed of an activated sludge bioreactor unit and an ultrafiltration membrane unit. The relationship of COD removal with MLSS and HRT in this MBR was studied. The effects of crossflow velocity, backwash interval and volume of flush liquid on the flux were discussed. The results showed that average removal of COD, oil, SS and turbidity in petrochemical waste water by the MBR was 91%, 86%, 92% and 99% respectively. The average removal of NH₃-N and total phosphorous was 85% and 82%. A coefficient of COD removal, k, was 0.017-0.080 L/(mg.d). The membrane flux maintained higher than 60 L/hm2 bar for 34 days without chemical cleaning when the velocity of crossflow was 3.5-3.9 m/s and the backwash interval was 30 minutes and backwash duration at 20 seconds. The results indicated that it is feasible for MBR technology to be used in petrochemical waste water treatment. The treated water could be considered as a source used to make up water for industrial cooling system or to be reused for other purposes.     

膜生物反应器运行中的膜污染问题

这了各国研究者针对膜生物反应器中的膜污染问题所作的工作，认为膜本身的性质以及废水组成和工艺条件都是造成膜污染的主要原因，利用反冲洗和清洗手段，可以有效地改善膜的性能，以提高膜的寿命，膜生物反应器技术的改进是避免膜污染的新思路。