Review: recent advances in biogas purifying technologies

Biomethane production through biogas upgrading is a promising renewable energy for some industries which could be part of the equilibrium needed with fossil fuels consumption to achieve a sustainable society. This paper presents a comprehensive list of biogas upgrading technologies focused on carbon dioxide removal as well as recent advances reported by researcher with wide expertise in this topic. Additionally, an extensive costs–performance comparison among the technologies studied is discussed. Among the different alternatives, chemical scrubbing stood out to achieve high biomethane purities while cryogenic technologies proved to be effective against methane losses. Regarding the different costs, water scrubbing and membrane separation seem to be the most affordable techniques.     

可张孔曝气器曝气能耗试验研究

通过试验研究，总结出可张孔曝气阻力损失的影响因素，以优化产品的结构设计参数，降低产品在工程应用中的能耗，获取更好的经济效益。     

Determination of organophosphorus pesticides and related compounds in water samples by membrane extraction and gas chromatography

A membrane extraction-gas chromatography method was developed fordetermination of organophosphorus pesticides and related compounds including methamidophos, DDVP, dimethoate, methyl parathion, parathion, thiophosphoric acid trimethyl ester, and thiophosphoramidic acid dimethyl ester in water samples. In thismethod, surface-modified acetic cellulose membranes were used to extract the target analytes in water samples, the extracted analytes were back-extracted into a small amount of methanol, andgas chromatography with pulsed flame photometric detector (GC-PFPD) was used to determine the concentrations of targetanalytes in the extracts. The recoveries obtained for thetarget analytes spiked into the water samples ranged from 66to 94%. The method detection limit for each target analyte was 0.05 g L^-1. The method developed in this study had shown the advantages of being cheap, simple, fast, and reliable. It had been used successfully to determine the concentrations of target analytes in river water samples.     

用液相催化法和脱硫除尘器脱除烟气中SO_2

在由旋风水膜和两块旋流塔板组成的处理气量为７５０ｍ￣３／ｈ的二级脱硫除尘器中，进行了用含催化剂Ｍｎ￣（２＋）的水溶液吸收ＳＯ_２的扩大试验。结果表明，在确定的条件下，脱硫率达到７３％，板效率为０．２５～０．２８。在同一设备中同时完成除尘与脱硫过程，设备投资少；以水为吸收剂，运行费用低；中性条件下吸收，长期运转不结垢，可靠性高。     

BOD微生物膜的再利用研究初探

对失去大部分活性的微生物膜进行再培养,以研究膜再利用的可能性。试验结果初部表明:在1/2MS培养基中加入一定量的植物激素,不仅可以使膜的电位值(I0)显著升高,且活性强,稳定性好,可使膜重复利用。     

采用钙钛矿型催化剂(La0.8K0.2Cu0.05Mn0.95O3)同时催化去除NOx和碳烟的研究

将钙钛矿型催化剂与碳烟均匀混合后置于固定床连续流动反应体系中,利用程序升温反应技术,在模拟柴油机尾气的情况下对同时催化去除氮氧化物(NOx)和碳烟的反应进行了实验研究.通过改变含Cu原料的用量,得到不同Cu取代量的催化剂La0.8K0.2CuxMn1-xO3,性能评价结果表明,La0.8K0.2Cu0.05Mn0.95O3催化剂的综合性能较好,碳烟的起燃温度及NO向N2的最大转化率分别为280℃和58.0%.采用该催化剂,进一步考察了进气中NO浓度、O2浓度、进气总流量及催化剂与碳烟的接触状况对反应的影响.研究结果表明,进气中NO浓度、O2浓度、气体总流量和催化剂与碳烟之间的接触状况对NO的去除率的影响比较明显,而对碳烟起燃温度的影响较小.O2浓度从5%变为7.5%时,碳烟的起燃温度及最大NO转化率分别从280℃和53.8%变为270℃和96.7%.碳烟与催化剂松散接触时,碳烟的起燃温度及最大NO转化率分别为290℃和48.4%,紧密接触时分别为275℃和70.4%.而进气中NO浓度、气体总流量的变化对碳烟的燃烧基本上没有影响,虽然NO的转化率有明显变化,但生成的N2总量基本不变.     

Membrane fouling control by ultrasound in an anaerobic membrane bioreactor

In this study, ultrasound was used to control the membrane fouling online in an anaerobic membrane bioreactor (AMBR). Short-term running experiments were carried out under different operating conditions to explore feasible ultrasonic parameters. The experimental results indicated that when the crossflow velocity was more than 1.0 m/s, membrane fouling could be controlled effectively only by hydrodynamic methods without ultrasound. When ultrasound was applied, an ultrasonic power range of 60–150 W was suitable for the membrane fouling control in the experimental system. The experimental results showed that the membrane fouling was controlled so well that membrane filtration resistance (ΣR) could stay at 5 × 10¹¹ m⁻¹ for more than a week with the crossflow velocity of 0.75 m/s, which equaled the effect of crossflow velocity of more than 1.0 m/s without ultrasound. Translated from Techniques and Equipment for Environmental Pollution Control, 2006, 7(4): 25–29 [译自: 环境污染治理技术与设备]     

A／O-化学除磷工艺中DMBR动态膜成膜条件研究

根据动态膜原理，将0．1mm孔径无纺布为膜材的动态膜反应器（Dynamic Membrane BioReactor，DMBR）应用于A／O-化学除磷工艺之中，在动态膜反应器内完成泥水分离。试验测试了曝气强度、初始膜通量和污泥浓度对动态膜成膜的影响。结果表明，曝气强度和初始膜通量是影响成膜的关键性参数。当曝气强度≥60m^3／m^2·h或初始膜通量≥70L／m^2·h，2h内均不能形成截留性能良好的动态膜。在VSS／SS较低的污泥系统中，适宜的成膜条件为：曝气强度≤40m^3／m^2·h；初始膜通量≤40L/m^2·h。     

生物膜反应器处理洗涤污水的试验

介绍了采用生物膜反应器处理洗涤污水的试验研究方法，研究了COD、LAS和NH3-N的去除效果。试验结果表明：整个系统出水稳定，水质良好（COD〈38．7mg／L、NH3-N〈1．1mg／L、LAS〈0．9mg／L，且无色无味、无SS），符合国家建设部生活杂用水回用水质标准，且具有较强的抗冲击负荷能力。在生物膜反应器中，微生物对污染物的去除起主要作用，而中空纤维膜对维持系统的稳定出水起重要作用。     

陶瓷微滤膜过滤黑液的清洗与再生

对无机陶瓷微滤膜过滤草桨黑液的膜清洗及再生的方法进行了研究。考察了物理和化学方法的再生效果、单种清洗剂的清洗效果、复合方法的清洗效果和效果的可重复性。结果表明物理冲洗、高温灼烧、单一的化学清洗剂清洗均可以提高陶瓷膜的再生通量；但是复合方法对陶瓷微滤膜的再生效果较好，其中按氢氧化钠溶液清洗、硝酸溶液清洗、次氯酸钠溶液清洗的实验步骤，膜的再生渗透通量高．且重复性强，可望在工业生产的在线清洗中应用。