混凝沉淀-酸化水解-接触氧化工艺处理聚苯乙烯生产废水

采用混凝沉淀酸化水解生物接触氧化工艺处理聚苯乙烯生产废水,通过治理工程实际运行,结果表明:当废水CODCr平均浓度为1160mg/L时,CODCr去除率为882%,出水水质稳定,能达到设计要求。     

海洋现代沉积速率~（210）Pb－~（210）Bi法的射线测定研究

本文主要介绍了用~（２１０）Ｐｂ─~（２１０）Ｂｉ法测定海洋现代沉积速率和数据处理方法的研究。该方法测定的结果与~（２１０）Ｐｂ─~（２１０）Ｐｏ法和阴离子交换－ＥＤＴＡ纯化－硫酸钡镭沉淀－α计数法（简称~（２２６）Ｒａ法）以及厦门大学海洋系经研究改进的分离、纯化~（２１０）Ｐｂ的离子交换法的测定结果相当吻合。     

石材废水集约化处理工程实例

介绍了一个石材废水集约化处理的成功实例，分析、总结了混凝沉淀法处理石材废水的可行性及注意事项，并通过比较得出石材废水集约化处理较分散治理具备明显优势的结论。     

印刷线路板厂含铜污泥固化处理工艺研究

研究采用水泥作固化基材固化处理某印刷线路板厂酸性废水用石灰混凝所产生的含铜、锡、金的污泥 ,对固化块在不同 pH的水中重金属Cu2 +的浸出实验结果表明 :水泥固化处理该混凝污泥效果良好 ,控制合适的条件 ,可得到混合性能好、初凝时间适当、抗压强度较好的固化块。Cu2 +的浸出率低于允许浸出浓度。混凝过程中加入硫脲硅酸钠等助剂 ,可提高固化效果。研究还对几种不同配比的固化块抗压强度进行了探讨。     

对硝基氯苯废气治理研究

冷却凝固法处理含对硝基氯苯废气 ,用水作冷却剂直接冷却、冷凝、凝固、凝华废气中对硝基氯苯蒸气 ,废气中的升华物、粉尘和水蒸汽同时被分离 ,处理后的废气达到很高的净化程度。在此根据实验结果 ,得到在水蒸汽存在时对硝基氯苯蒸气分压和温度之间的关系     

污水处理厂沉淀池改进方案

根据某污水处理场沉淀池的COD和SS去除率较低的情况，文中着重探讨了问题的产生原因，并针对平流式沉淀池及斜管式沉淀池提出了相应的改进方案，实践证明改进后提高了COD和SS去除率30％，并明显降低了二级生物处理阶段的有机物负荷，节省了大量的暴气量通过改进达到了降低处理场其它环节的负荷和降低污水处理成本的目的。     

HISTORICAL TRENDS IN SEDIMENTATION RATES AND SEDIMENT PROVENANCE,FAIRFIELD LAKE,WESTERN NORTH CAROLINA1

Sedimentation rates and sediment provenance were examined for lacustrine sediments deposited in Fairfield Lake, western North Carolina, during the past 111 years. Stratigraphic, radionuclide, and cartographic data indicate that sedimentation rates have increased several fold during the past three decades in response to localized development. The magnitude of increased sedimentation was surprising given limited development within the basin: 0.12 to 0.68 buildings/ha in 2000 in those parts directly delivering sediment to the dated cores. Thus, the analysis illustrates the potential sensitivity of watersheds in the southern Appalachians to changes in land cover. An approach that combined geochemical fingerprinting with sediment mixing models was subsequently evaluated to determine its ability to accurately estimate the contribution of sediment from (1) major bedrock formations that underlie the watershed and (2) potential sources associated with four land cover categories. Sediment sources in both analyses proved difficult to geochemically fingerprint to greater than 90 percent accuracy using data on acid‐soluble metals and selected isotopes of lead (Pb). The relative contributions of sediment from delineated sources, estimated by the mixing models, generally corresponded with known temporal and spatial patterns of land cover. However, the models were plagued by two significant problems — the chemical alteration of sediments as they were transported through upland streams to depositional sites within the lake and the loss of elemental mass. Thus, future investigations using the fingerprinting approach in this area of intense weathering, and presumably others, will need to modify the existing methods to more accurately elucidate changes in sediment provenance related to development.     

铁盐与铝盐对腈纶废水生化出水混凝特性的对比

针对腈纶废水生化单元出水,对比研究了Al2(SO4)3和Fe2(SO4)3在不同絮凝剂投量和pH时的混凝处理效果,并利用紫外-可见分光光度法(UV-Vis)、三维荧光光谱(EEM)、凝胶渗透色谱(HPSEC)等对混凝特性进行了初步探讨。研究显示,2种混凝剂在投量为63.5 mg/L时可获得30%以上的COD去除率,且最佳pH为中性附近。当投量小于32 mg/L时,Al2(SO4)3较Fe2(SO4)3具有更高的COD去除率,进一步增大混凝剂的投量很难提高Al2(SO4)3对COD的去除率,而Fe2(SO4)3则在有限范围内能持续提高COD去除率。EEM光谱分析显示,与Al2(SO4)3相比,Fe2(SO4)3对有机物具有更广的处理范围和更好的去除效果。HPSEC分析表明,Fe2(SO4)3相对于Al2(SO4)3在去除重均分子量为2 776、1 856和1 325 Da的有机物组分方面具有优势。铁盐或铝盐混凝是深度净化腈纶废水生化单元出水的可行方案之一。     

聚合铁钛混凝剂对印染废水的处理

采用钛铁矿为主要原料,以硫酸溶出部分铁和钛,并调节Ti/Fe比、碱化度制备高效的新型含钛聚合硫酸铁混凝剂(T-PSF),将其用于分散兰和活性黄2种模拟印染废水的脱色处理并研究其混凝去除机理。实验结果表明,在Ti/Fe为1∶6和碱化度为2.0时,制备出的T-PSF混凝效果最好。T-PSF对分散兰的去除率为94.3%,比FeCl3的去除率提高53.8%;对活性黄的去除率为34.0%,比FeCl3提高12.7%。T-PSF处理分散兰和活性黄的最佳投加量均为0.3 mmol·L-1,最佳水样初始pH分别为6和8。絮体粒径及结构分析结果表明,T-PSF处理分散兰过程中形成的絮体粒径较FeCl3大,处理活性黄过程中所形成的絮体粒径较FeCl3小,但絮体结构均比FeCl3更密实。结合T-PSF的表征、Zeta电位及絮体特性分析表明,在分散染料去除过程中,T-PSF产生的多羟基钛铁聚合物的电中和及吸附架桥起主要作用;对于活性染料的去除,主要机制为T-PSF水解产生的带正电的多羟基钛铁聚合物的吸附络合作用。     

低温低浊微污染水源水预氧化处理工艺设计

选用预氧化处理工艺以提高混凝絮凝效果,减少停留时间从而实现在小型设备中较高的处理量;占地面积小且速度快的气浮池代替了普通的沉淀池,并在混凝沉淀处理药剂和消毒处理药剂上选择了在低温条件下效果好的.