垃圾焚烧烟气中HCl与消石灰的反应机理研究

测试了两种消石灰与垃圾焚烧烟气中HCl的反应率,得出了消石灰的反应率与反应时间的反应曲线,分析了消石灰与HCl的反应机理及影响消石灰最终反应率的因素。试验结果表明,消石灰与HCl反应初期按灰层扩散控制进行,两种消石灰的最终反应率分别为16％和36％。     

MnFe2O4磁性纳米棒非均相Fenton催化降解水中四环素的研究

采用水热合成法成功制备出MnFe₂O₄磁性纳米棒（s-MnFe₂O₄）,并考察了商品化的Fe₃O₄、MnFe₂O₄和合成的s-MnFe₂O₄纳米棒这3种磁性纳米颗粒作为非均相Fenton催化剂降解水中四环素抗生素的性能.同时,采用X射线衍射（XRD）、透射电镜（TEM）、N₂吸附-脱附、振动样品磁强计（VSM）及X射线光电子能谱（XPS）等技术对催化剂的理化性质进行了表征.非均相Fenton催化降解四环素的结果表明,s-MnFe₂O₄具有最高的催化活性,反应180 min,四环素的去除率可以达到87.6%,TOC的去除率达到47.5%.自由基捕获试验证实了羟基自由基（·OH）是非均相Fenton氧化过程中的主要活性物种.s-MnFe₂O₄磁性纳米棒的高催化活性归因于其表面拥有较高含量的Mn³⁺和Fe²⁺物种,它们的存在能加速界面电子的转移效率,从而促进·OH的生成.合成的s-MnFe₂O₄催化剂具有良好的稳定性,循环使用6次,四环素的去除率仅从87.6%降低到80.2%,且氧化过程中活性组分的流失很少.     

铝系混凝剂优势形态分析及其混凝特性

聚合氯化铝（PACl）是常用的水处理混凝剂,在应用过程中通常表现出比传统铝盐更为优异的效果.研究表明,这种优异性能主要得益于其特殊的组成,特别是高分子聚合物Al₁₃和Al₃₀独特的物化特性.Al₁₃和Al₃₀是铝离子水解过程中的中间产物,在地球科学和环境化学等领域有着重要的研究价值.于水处理而言,二者的结构和分子特性是研究者关注的重点,大量研究基于此展开,很多重要的发现为实际应用奠定了基础.基于对PACl及其组成性质的研究,本文对PACl的混凝特性及其优势形态分子的分析进行了综合阐述.     

深圳市秋季大气臭氧立体分布特征

利用大气O₃探测激光雷达在深圳市东部生态区和西部城区同步开展垂直观测,探究了2018年深圳市O₃立体分布在秋季光化学污染活跃期至冬季非活跃期的演变过程.结果表明：光化学反应活跃的10月,东部地面O₃浓度相对于西部地面高出约128%;地面向上至450m,O₃浓度在东部生态区发生快速降低,而在西部城区由于存在“滴定效应”,O₃浓度随高度升高而升高;450m~2km,东、西部O₃浓度均随高度升高而降低,西部城区O₃浓度水平超过东部生态区约30%;2km以上高空,东、西部O₃浓度趋同（70μg/m³）,并保持稳定,为具深圳市秋季O₃污染过程提供了较高的大气背景浓度.高污染期间,深圳市大气边界层内O₃浓度变化较为一致,西部高空的O₃区域传输作用更加显著.秋季至冬季光化学反应逐渐减弱,深圳市O₃浓度的水平和垂直空间差异逐渐减小,冬季的深圳市O₃污染基本受大气背景控制.     

Treatability studies of naphthalene in soil,water and air with persulfate activated by iron(Ⅱ)

Chemical oxidation was applied to an artificially contaminated soil with naphthalene (NAP). Evaluation of NAP distribution and mass reduction in soil, water and air phases was carried out through mass balance. Evaluation of NAP distribution and mass reduction in soil, water and air phases was carried out through mass balance. The importance of the air phase analysis was emphasized by demonstrating how NAP behaves in a sealed system over a 4 hr reaction period. Design of Experiments method was applied to the following variables: sodium persulfate concentration [SP], ferrous sulfate concentration [FeSO₄], and pH. The system operated with a prefixed solid to liquid ratio of 1:2. The following conditions resulted in optimum NAP removal [SP] = 18.37 g/L, [FeSO₄] = 4.25 g/L and pH = 3.00. At the end of the 4 hr reaction, 62% of NAP was degraded. In the soil phase, the chemical oxidation reduced the NAP concentration thus achieving levels which comply with Brazilian and USA environmental legislations. Besides the NAP partitioning view, the monitoring of each phase allowed the variabilities assessment over the process, refining the knowledge of mass reduction. Based on NAP distribution in the system, this study demonstrates the importance of evaluating the presence of semi-volatile and volatile organic compounds in the air phase during remediation, so that there is greater control of the system as to the distribution and presence of the contaminant in the environment. The results highlight the importance of treating the contaminant in all its phases at the contaminated site.     

GA-g-PAMPS/AA/ST凝胶的制备及对亚甲基蓝吸附性能

采用微波辐射技术,通过接枝共聚反应制备了阿拉伯胶（GA）-g-2-丙烯酰胺-2-甲基丙磺酸（AMPS）/丙烯酸（AA）/海泡石黏土（ST）（GA-g-PAMPS/AA/ST）复合水凝胶,利用FTIR、XRD、SEM对复合水凝胶进行了表征,研究了水凝胶对水溶液中亚甲基蓝（MB）染料的吸附性能.结果显示：GA、ST和AA与AMPS发生了接枝共聚反应,形成具有均匀三维网络结构的复合水凝胶.0.025g水凝胶可以使体积为50mL、pH值为6.4、浓度为600mg/L的MB溶液的吸附量和吸附率分别达1146mg/g和95.5%,水凝胶具有较好的重复利用性能.Freundlich等温模型和准二级动力学模型能更好地描述吸附过程.热力学研究表明水凝胶对亚甲基蓝吸附是自发、吸热和不可逆的过程.该水凝胶可用作阳离子染料和阳离子型污染物的潜在候选生物质吸附剂.     

Nanoencapsulation of hexavalent chromium with nanoscale zero-valent iron: High resolution chemical mapping of the passivation layer

Solid phase reactions of Cr(Ⅵ) with Fe(0) were investigated with spherical-aberration-corrected scanning transmission electron microscopy(Cs-STEM) integrated with X-ray energy-dispersive spectroscopy(XEDS). Near-atomic resolution elemental mappings of Cr(Ⅵ)–Fe(0) reactions were acquired. Experimental results show that rate and extent of Cr(Ⅵ) encapsulation are strongly dependent on the initial concentration of Cr(Ⅵ) in solution. Low Cr loading in nZⅥ(1.0 wt%) promotes the electrochemical oxidation and continuous corrosion of n ZⅥ while high Cr loading(1.0 wt%) can quickly shut down the Cr uptake. With the progress of iron oxidation and dissolution, elements of Cr and O counter-diffuse into the nanoparticles and accumulate in the core region at low levels of Cr(Ⅵ)(e.g., 10 mg/L). Whereas the reacted n ZⅥ is quickly coated with a newly-formed layer of 2–4 nm in the presence of concentrated Cr(Ⅵ)(e.g., 100 mg/L). The passivation structure is stable over a wide range of pH unless pH is low enough to dissolve the passivation layer. X-ray photoelectron spectroscopy(XPS) depth profiling reconfirms that the composition of the newly-formed surface layer consists of Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxides with Cr(Ⅵ) adsorbed on the outside surface. The insoluble and insulating Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxide layer can completely cover the n ZⅥ surface above the critical Cr loading and shield the electron transfer. Thus, the fast passivation of nZⅥ in high Cr(Ⅵ) solution is detrimental to the performance of nZⅥ for Cr(Ⅵ) treatment and remediation.     

环境升温过程对常温固化环氧树脂热力学性能的影响

目的提高常温固化环氧树脂体系的高温使用性能。方法采用常温固化剂T31、中温固化剂IPDA以及高温固化剂DDM作为混合固化剂,对E-44型和AG-80型混合环氧树脂体系进行常温固化反应,并分析环境升温过程对固化物热力学性能的影响。通过DMA分析、热变形测量、固化度测试,分别评价室温固化环氧树脂在环境升温过程前后的玻璃化转变温度、热变形量及体系内部的固化反应程度变化,并通过吸水率测试和弯曲强度测试对玻璃纤维布增强常温固化环氧树脂基复合材料的耐湿热性能以及高温条件下的力学性能进行分析。结果环氧树脂常温固化物的tg为85.21℃,经1.5℃/min的平均升温速率加热至90℃之后,该环境升温过程使固化物的固化度增大至92%以上,tg增长为132.06℃的同时热变形温度增大。其复合材料耐湿热性能提高,且100℃时弯曲强度的保持率为65%,对于加热至120℃的环境升温过程,固化物的固化度接近96%,tg增长为144.45℃的同时热变形温度进一步提高,其复合材料耐湿热性能改善程度更加明显,且130℃时弯曲强度保持率仍接近60%。结论常温、中温、高温混合固化剂的合理复配有助于环氧树脂体系在环境升温变化的诱导条件下发生梯度式固化反应,使体系内部的交联固化程度迅速升至较高水平,可以有效提高其玻璃化转变温度,显著改善常温固化环氧树脂体系在高温条件下的热力学性能。     

环境样品中痕量锰的催化动力学测定法

对环境样品中痕量锰的催化动力学测定方法进行简要评述，引述文献１６篇。     

Biotreatability and kinetics of UASB reactor to mixtures of chlorophenol pollutants

In most natural ecosystems heterotrophic microorganisms encountercomplex mixtures of carbon sources, each of which is present at aconcentration of few micrograms per litre. This study examined the biotreatability and kinetics of an upflow anaerobic sludge blanket (UASB) reactor to complex mixtures of chlorophenols encountered in environmental conditions using on-line and off-line experimental studies. Results indicate that (1) steady-state concentration was quite lower (98.3 mg L^-1) with complex mixture of chlorophenols than steady-state concentration achieved when only 2.4 dichlorophenol (124 mg L^-1) was studied alone on the same reactor; (2) that toxiceffects of chlorophenols increase with increasing concentrationsof toxicant. (Onset of the inhibitory effect occurred at a lowerconcentration in multi-substrate than in single substrate utilization); (3) addition of alternative utilizable substrate can mitigate toxic effects and enhance degradation; (4) the relative concentration of substrate was critical in determiningutilization patterns. HPLC analysis of off-line experimental samples resulted in a steady-state treatment efficiency of68% for COD, 36% for 2-hlorophenol, 40.5% for 4-chlorophenol, 70.7% for 2,4-dichlorophenol, 53.2% for 2,4,6-trichlorophenol and 42% for pentachlorophenol in presence of glucose. Kinetic constant in terms of V _max and K _s were determined. K _s for the five chlorophenols ranged between 0.016 and 0.117 kg m^-3 day^-1 while V _max ranged between 0.056 and 0.244 kg m^-3 day^-1.