分层开采工艺对地表沉降的影响研究

分层开采是厚煤开采的经典工艺,这种工艺对地表沉降的影响比较复杂。通过测试原岩物理力学参数,利用有限元软件flac3D对分层和一次采全高时地表沉降进行了数值模拟。结果表明,如果采高较小,砌体梁距煤层较近,且采完上分层后长时间停采,给顶板再生留足时间,分层开采较一次采全高对地表沉降影响要小。     

Stability of a Coal Waste Artificial Reef

The feasibility of using U.K. coal-fired power station waste materials for artificial reef production is being examined. in June, 1989, an experimental artificial reef was constructed in Poole Bay, off the central south coast of the U.K., using three different mixtures of pulverised fuel ash (PFA), flue gas desulphurisation (FGD) gypsum and slurry, stabilized with cement and formed into blocks. Fifty tonnes of 40 × 20 × 20 cm blocks were formed into eight conical reef units replicating three different PFA/gypsum mixtures and one concrete control. the reef structure is 10m below chart datum on a flat sandy sea-bed.

Combustion of coal concentrates the heavy metal content in the resultant ash. the purpose of stabilization of the ash as blocks is twofold: to immobilize heavy metals (or other components) and to provide hard substratum for the attachment of organisms. to examine the effectiveness of this stabilization and hence the environmental compatibility of the block materials, heavy metal (Cd, Cr, Cu, Pb, Mn, Ni, Zn) content of the blocks has been monitored routinely over two years, to determine leaching rates. Sectional profiles indicate partial replacement of calcium content by magnesium. Associated with this there has also been some redistribution of heavy metals. Only in the case of cadmium has there been a detectable loss from the surface of blocks. Chromium and manganese concentrations appear to have increased. the metal content of the reef epibiota (including ascidians, Ascidia mentula; hydroids, Halecium spp.; bryozoans, Bugula spp. and red algae) growing on the ash blocks has been compared to that of epibiota attached to the concrete controls and surrounding sea-bed. to date no evidence of excess bioaccumulation of metals has been detected.

The physical integrity of the ash reef blocks has been maintained. There is evidence that the blocks are increasing in compressive strength.

An indication of the fishery enhancement potential of the experimental structure is given by the presence of eight commercially fished species (crustaceans and molluscs) including lobsters (Homarus gammarus).     

滇池鲤鱼的背景元素调查

通过滇池鲤鱼与松花坝水库和国内外同类鲤鱼的元素含量对比,确认滇池鲤鱼受工业污水的危害影响主要是As、Se。鱼体As、Se含量目前已经超过正常值,Ni、Cr、Cu、Fe、Pb比正常值偏低,其它元素属正常值范围。为了避免过多的元素富集,建议滇池鲤鱼以半年到一年为生长捕捞期为宜。     

可靠性强化试验技术在某型伺服作动器研制中的适用性探索

目的探索可靠性强化试验技术在典型机电液一体化产品伺服作动器研制过程中的适用性。方法以某型伺服作动器为研究对象,从故障激发的角度对可靠性强化试验技术的应用进行可行性分析,在响应调查和应力分析的基础上,结合产品的工作特点设计适用于该类伺服作动器的可靠性强化试验方案,包含低温步进应力试验、高温步进应力试验、快速温度循环试验10个循环、振动步进应力试验(包含气锤式三轴向六自由度超高斯随机振动方式及电磁振动台随机振动方式)及综合环境应力试验5个循环,并依此进行试验。结果在快速温度循环试验及综合环境应力试验过程中,均有效地激发出了产品的漏油故障,与相似产品外场暴露的漏油故障模式相吻合。结论可靠性强化试验技术可有效地应用于典型机电液一体化产品伺服作动器的研制过程,设计的可靠性强化试验方案可有效地激发外场出现频率较高的故障,可作为该类产品研制的试验手段之一。     

空间站控制力矩陀螺微振动测试技术

目的分析控制力矩陀螺的微振动扰动特性。方法通过获取陀螺连接点对结构的扰振力输出、关键部位的微振动响应来获取产品的微振动扰动特性,通过隔振的方式对外部环境的干扰进行隔离,进而降低测试的背景噪声,通过运用高精度测试传感器来实现微小扰动力信号、加速度信号的测量,利用结构有限元法及单点激励多点响应的模态分析方法校核系统刚度,进而确定测试频率范围是否满足需求。结果可同时获得空间站控制力矩陀螺连接点处的输出扰振力、质心处的输出扰振力合力、合力矩以及关键部位的微振动响应,可有效隔离外部干扰,扰振力背景噪声的时域信号最大值可控制在0.07 N以内,RMS值在0.02 N以内,加速度信号的时域背景噪声最大值可控制在1.5 mg以内,RMS值在0.1 mg以内。可识别微小扰振信号,加速度传感器分辨率为5×10-5 grms,力传感器的测量分辨率为1×10-2 N,力矩测量分辨率小于1×10-2 N·m。测试频带在320 Hz以内。结论满足型号需求,并投入型号使用。     

基于有限元分析的橡胶减振器优化设计

目的加快橡胶减振器的设计过程。方法分析橡胶材料及Mooney-Rivllin橡胶本构模型特点,介绍橡胶减振器应用特点及隔振设计的相关理论,采用Mooney-Rivllin模型模拟橡胶材料的力学特性,通过引进有限元优化技术,在设计初期保证减振器的刚度特性。结果在某设备减振设计中,采用单轴拉压曲线获取了橡胶材料的Mooney-Rivllin模型参数,以减振器的部分结构尺寸为设计参数,减振器的三向刚度为设计目标,获取了三轴向频率近似相等的隔振系统(轴向频率40 Hz、径向频率40.9 Hz)。通过试验测试,减振系统频率与试验值差别较小,其中轴向差别为2%,径向差别为1%。结论通过引进有限元优化技术,采用合理的橡胶本构模型,可以满足工程精度要求,加速了橡胶减振器的设计过程。     

黔西南喀斯特地区红色风化壳的物源及元素迁移特征

南方喀斯特地区广泛分布着大量的红色风化壳,其成因及形成机制目前还存在争议。本文以贵州黔西南布依族苗族自治州泥凼石林的两处红色风化壳剖面(ND和YK)为研究对象,来探讨风化剖面上覆红土的物源问题,并计算其主、微量元素及稀土元素的迁移规律,认为本研究两处风化壳上覆红土为下伏基岩原位风化形成的,而且两剖面土壤均继承各自基岩的地球化学特征,并由于pH、风化强度等因素的影响表现出了元素迁移特征上的差异性。     

螯合树脂在线富集——火焰原子吸收光度法测定水中微量Cu,Pb,Zn,Cd

对螯合树脂在线富集，火焰原子吸收光度法进行了条件试验。试验证实方法对Ｃｕ、Ｐｂ、Ｚｎ、Ｃｄ４个元素检出浓度可达μｇ／Ｌ级，校准曲线性、样品重现性及准确度可满足测定要求。     

Trace Metal Concentration in Roadside Surface Soil and Tree Back: A Measurement of Local Atmospheric Pollution in Abuja, Nigeria

Cadmium, copper, lead, nickel and zinc concentrations were analysed by atomic absorption spectrophotometry in surface soil and tree bark from different districts of Abuja, Nigeria, in order to determine the atmospheric trace metal input in the area.Elevated concentrations of some of the studied metals were observed in the soil and tree bark samples from the commercial/high traffic areas of the city compared to backgroundvalues. In soil samples, the average concentration of the metals were 0.6±0.4, 18.0±4.0, 281±39, 16±4 and66±23 g g^-1 dry weight for Cd, Cu, Pb, Ni and Zn, respectively, whilst the average concentrations in tree bark were 0.3±0.2, 12±4, 133±32, 13±3 and 61±10 g g^-1 dry weight for Cd, Cu, Pb, Ni and Zn, respectively. The trend in trace metal levels suggested that automobile emissions are a major source of these metals as the highest concentrations of Pb and Zn were recorded in the commercial areas of the city known for their high traffic densities. The levels of metal in the study area were relativelylow compared to levels found in some larger and older cities in various countries worldwide.