共生细菌SB1降解聚乙烯醇的研究Ⅱ．共生细菌SB1聚乙烯醇氧化酶的产生、纯

共生细菌ＳＢ１接种在０．３％聚乙烯醇培养堪中，３０℃摇床振荡培养或发酵罐通气培养时，ＰＶＡ氧化酶产生的高峰在４８ｈ或４０ｈ。离心收集的上清液采用４０％－５０％饱和度的硫酸铵分级沉淀ＤＥＡＤ－Ｓｅｐｈａｄｅｘ离子交换柱和Ｃｉｂａｃｒｏｎ蓝Ｓ－Ｓｅｐｈａｒｏｓｅ４Ｂ亲和柱层析等纯化步骤。ＰＶＡ氧化酶收得率３０％，比活力提高３０倍。     

Starch- polyvinyl alcohol crosslinked film— performance and biodegradation

Starch-PVOH cast films were prepared with and without crosslinking agent (hexamethoxymethylmelamine) in the absence of plasticizer. Moisture absorption in films without crosslinking agent at a low relative humidity was similar to that of PVOH and increased as the relative humidity increased. Films with crosslinking agent showed moisture absorption linearly proportional to the relative humidity. Significant improvement in resistance to water disintegration for crosslinked starch-PVOH films was observed. While the tensile strength decreased with increased relative humidity, crosslinking significantly improved the tensile strength. Increased PVOH content improved elongation of films even when the relative humidity was 80% or higher. Biodegradation studies revealed that the degradation rate was negatively correlated with the PVOH content in films and crosslinking generated more converged degradation curves. Names are necessary to report factually on available data; however, the USDA neither guarantees nor warrants the standard of the product, and the use of the name by USDA implies no approval of the product to the exclusion of others that may also be suitable.     

Supercritical water oxidation of polyvinyl alcohol and desizing wastewater：Influence of NaOH on the organic decomposition

Polyvinyl alcohol is a refractory compound widely used in industry. Here we report supercritical water oxidation of polyvinyl alcohol solution and desizing wastewater with and without sodium hydroxide addition. However, it is difficult to implement complete degradation of organics even though polyvinyl alcohol can readily crack under supercritical water treatment. Sodium hydroxide had a significant catalytic effect during the supercritical water oxidation of polyvinyl alcohol. It appears that the OH ion participated in the C-C bond cleavage of polyvinyl alcohol molecules, the CO2-capture reaction and the neutralization of intermediate organic acids, promoting the overall reactions moving in the forward direction. Acetaldehyde was a typical intermediate product during reaction. For supercritical water oxidation of desizing wastewater, a high destruction rate (98.25%) based on total organic carbon was achieved. In addition, cases where initial wastewater was alkaline were favorable for supercritical water oxidation treatment, but salt precipitation and blockage issues arising during the process need to be taken into account seriously.     

活性污泥的固定化及其性能研究

用改进聚乙烯醇-硼酸法将活性污泥制成固定化颗粒,考察了改进聚乙烯醇-硼酸法的最佳条件及固定化颗粒的性能。实验结果表明：改进聚乙烯醇-硼酸法的最佳条件为聚乙烯醇质量分数6．5％、包泥比（包埋剂与活性污泥质量比）1．2：1、二氧化硅质量分数1．5％、活性炭质量分数0．3％、海藻酸钠质量分数0．6％;用最佳条件下制得的固定化颗粒处理模拟化工废水,连续运行15d后的COD去除率达90％以上,且固定化颗粒耐冲击负荷和pH变化能力强;固定化颗粒对模拟化工废水的COD去除速率随进水COD的变化曲线类似于米氏方程所描述的反应初速度随底物浓度的变化规律。     

Fenton法氧化降解聚乙烯醇的机制

为深入了解Fenton法氧化降解聚乙烯醇（PVA）的机制,通过考察反应过程中COD、BOD5、总有机碳及pH等随反应时间的变化,研究了聚乙烯醇Fenton氧化降解过程的特点,结果表明,当PVA被Fenton试剂氧化时,可生成大量CO2,同时生成酸性中间产物。进一步分析认为,当Fenton试剂中H2O2不足景时PVA氧化的中间产物以醛为主,而当H2O2足量时醛会被继续氧化生成有机酸,最终COD去除率达到80％。     

臭氧氧化法降解聚氯乙烯离心母液废水中3种有机物

以聚氯乙烯离心母液废水中含量较高的3种有机物(聚乙烯醇、异辛醇和α-甲基苯乙烯)作为目标物,考察臭氧氧化工艺对3种有机物的去除效果,同时考察反应时间、臭氧投加量和初始pH对处理效果的影响。实验结果表明,臭氧氧化处理3种废水的最佳反应时间和臭氧投加量分别为:聚乙烯醇25 min,136 mg/L;异辛醇60min,312 mg/L;α-甲基苯乙烯60 min,32 mg/L。在此条件下,3种有机物的去除率分别为98%、85%和95%。此外,碱性条件有助于臭氧氧化工艺对3种有机物的降解。产物分析结果表明,经臭氧氧化,聚乙烯醇断链后进一步反应生成了草酸单乙酯,异辛醇和α-甲基苯乙烯分别生成了和苯乙酮。     

退浆废水中聚乙烯醇的分析检测研究

建立了紫外可见分光光度法检测退浆废水中聚乙烯醇(PVA)含量的方法。以硼酸为介质,碘化钾—碘溶液为显色剂,检测波长为680 nm,测定退浆废水中PVA含量的线性方程为Y=0.018 8X+0.003 2,相关系数R2=0.999 3,平均加标回收率为97.6%;方法精密度(RSD=1.5%)、重现性(RSD=1.8%)均较好。该方法操作简单、准确度高、测定快速,适用于测定退浆废水中PVA的含量。     

Fe(Ⅲ)/Fe(Ⅱ)铁氧体工艺原位处理PVA废水及其沉淀物回收利用

为了评价Fe（Ⅲ）/Fe（Ⅱ）铁氧体工艺对PVA（聚乙烯醇）废水处理的可行性,采用Fe（Ⅲ）/Fe（Ⅱ）铁氧体工艺原位处理PVA模拟废水,考察不同作用时间、总铁投加量、初始ρ（PVA）和废水硬度对该工艺处理效果的影响.利用XRD（X射线衍射）、FT-IR（傅里叶转换红外光谱）、BET比表面积、VSM（磁滞回线测试）对沉淀物进行表征,解析该工艺原位处理PVA模拟废水的主要机理,并以该工艺沉淀物为吸附剂,通过锑吸附试验,探讨该工艺沉淀物的回用性.结果表明:①Fe（Ⅲ）/Fe（Ⅱ）铁氧体工艺对PVA模拟废水具有良好的处理能力,初始ρ（PVA）为1 000 mg/L时,该工艺在20 min以内即可达到80%以上的去除率,并且基本没有金属铁的残余,该工艺对PVA的去除率随总铁投加量的增加而提高且基本不受水体硬度影响. ②在Fe（Ⅲ）/Fe（Ⅱ）铁氧体工艺对PVA的原位去除过程中,PVA作为一种反应物参与沉淀物Fe₃O₄的生成,并促进纳米Fe₃O₄比表面积增大,最终形成一种类似于凝胶的Fe₃O₄聚合物. ③Fe（Ⅲ）/Fe（Ⅱ）铁氧体工艺可高效处理模拟PVA-MB（亚甲基蓝）染料废水.对于含有100 mg/L MB（亚甲基蓝三水）和500 mg/L PVA的混合溶液,MB和COD_Cr去除率在1 min时分别达到97.37%和89.47%.沉淀物通过磁分离、乙醇和水清洗后,在水中浸出的ρ（TOC）和ρ（COD_Cr）很低,分别为0.86和2 mg/L,可作为吸附剂直接使用,得益于其具有较高的比表面积,对金属锑的拟合吸附量可达71.94 mg/g. ④Fe（Ⅲ）/Fe（Ⅱ）铁氧体工艺具有一定的实际应用价值.对东莞某实际印染废水处理5 min,COD_Cr和染料的去除率分别为85.71%和98.98%.研究显示,Fe（Ⅲ）/Fe（Ⅱ）铁氧体工艺可高效去除PVA,沉淀物为易回收的磁性Fe₃O₄,可作为吸附剂直接使用.      

超滤法回收PVA并回用于生产的扩大实验

本工作采黑由美国引进的超滤装置,在湖南湘潭纺织印染厂进行了从退浆废水中回收pVA的生产性扩大试验,探讨了料液温度、浓度,操作压力等因素对超滤性能的影响,并简单介绍了回收浆料回用于浆纱,织布及印染生产的情况。     

测定氨氮的经验点滴

用纳氏比色法测定NH3-N时,在保证斜率不变(b=0.0037)的条件下,减少显色剂中HgCI2-KI三分之二的含量,聚乙烯醇做胶体稳定剂,显著提高了显色剂和显色的稳定度,并大大降低了空白吸光度.以KOH和酒石酸钾纳做缓冲溶液,并增加KOH一倍的含量,保持恒定的显色碱度,同时也掩蔽了金属离子的干扰.测定废水,先做一条件试验,确定氨氮废水的稀释比,是测定氨氮的重要步骤.