沼液回流对秸秆与污泥混合中温厌氧消化的影响

为了提高秸秆与市政污泥混合厌氧消化的消化产率,以秸秆污泥混合物作为底物,在批次实验中研究不同沼液回流对中温（35 ℃）混合厌氧消化过程的影响。实验采用0% 、20%、30%、40%、50%和60%等6种不同的沼液回流量,分析不同沼液回流量下产气量、甲烷含量、发酵过程氨氮含量、sCOD、总挥发酸（VFAs）的变化情况。结果表明：50%的沼液回流产气量和甲烷产量均最大,分别是1 645 mL和797.5 mL,TS和VS去除率达到17.5%和47.8%,单位VS甲烷产量为613.45 mL·g-1,较未加沼液的发酵瓶提高了37.7%,且无VFAs积累。过高的沼液回流量提升了厌氧反应的氨氮浓度,对厌氧产气过程产生了抑制。50%沼液回流量可以作为秸秆污泥混合厌氧消化最佳回流量。     

UASB反应器降解活性染料废水的特性

中温（35±1）℃条件下,采用上流式厌氧污泥床（upflowanaerobicsludgebed,简称UASB）反应器处理了含蒽醌类-活性艳蓝（c．I．ReactiveBlue5,简称K—GR）或偶氮类-活性艳红（C．I．ReactiveRed20,简称KD-8B;C．I．ReactiveRed2,简称X-3B）模拟染料废水,重点研究了回流比对染料脱色率和COD去除率的影响,在最佳回流比的条件下,探讨HRT（hydraulicretentiontime）对脱色的影响和不同结构染料的脱色效果,并初步分析了脱色机理。结果表明,适宜的回流比有利于提高系统的脱色率;控制回流比和HRT分别为2和24h,当模拟废水中染料的浓度为100mg／L时,COD去除率和脱色率分别为90％～96％和85％～92％;蒽醌和偶氮类染料的脱色是通过偶氮键和葸醌共轭结构的断裂来实现的。     

Performances of mesophilic anaerobic digestion systems treating poultry mortalities

Abstract

A closed‐loop anaerobic digestion system consisting of a leachbed (LB) and an upflow anaerobic sludge blanket (UASB) was tested as an alternative for the disposal of poultry mortalities. This paper compares the performances of three LB‐UASB treatment systems with different initial moisture contents in the LBs. Each LB was loaded with one chicken and 5, 10 or 18 liters of water. The LBs initially carried out the hydrolysis/acidification phase while the UASBs the methanogenesis phase. Due to repeated inoculation by the UASBs, the LBs with 10 and 18 liters of water started producing methane on day 5, while the one with 5 liters of water on day 19. However, methane production rates were low before day 40 for the LB with 10 liters of water and day 60 for the other LBs. Methane production gradually improved as the LBs continued to receive ungranulated sludge from the UASBs. The LBs eventually became balanced methane reactors. Continued balanced fermentation in the LBs resulted in leachates with very low substrate concentrations that could no longer support high‐rate methanogenesis in the UASBs. Consequently, methane production rates from the UASBs decreased quickly while that from the LBs reached peak levels. Cumulative methane production from each LB eventually exceeded that from its connecting UASB. After 118 days of digestion, 414, 437 and 470 liters of methane were produced from the three systems, respectively. Cumulative methane production from the LBs with 5 and 18 liters of water accounted for 63% of the total methane produced from their respective systems. The LB with 10 liters of water produced 75% of the total methane from that system. Methane yields ranged from 0.485 to 0.554 m³ (Kg TS) ¹. About 86% of the initial dry weight was biodegraded. All three systems performed very well with little operational problems. Overall, the system that started with 10 liters of water in the LB performed the best. Strategy for enhancing system performances and implementing farm applications are discussed.     

垃圾填埋场中真细菌群落16S rRNA基因的分析

回灌式垃圾填埋场渗滤液中真细菌群落的多样性同样通过不依赖于微生物培养的分析而获得。利用特异性的引物对,选择性地扩增渗滤液DNA中的真细菌16S rRNA基因片断(16S rDNA),并用于构建16S rDNA克隆文库。文库内真细菌16S rDNA的遗传多样性通过限制片断长度多态性分析(RFLP,限制性内切酶Hin PII和Msp I)而获得。初步的结果表明,随机选出的200个真细菌克隆子被分为147个不同的RFLP型(组),当中丰度最高的两个型均仅含有9个克隆子,两者共占所有被分析克隆子的不到10%;克隆子数≥2的型共有21个(包括以上2个丰度最高的型),它们共代表74个克隆子,占所有被分析克隆子的37%;而剩下的126个型均只含有1个克隆子,它们共占整个基因文库的63%。由此可见,李坑垃圾渗滤液中的真细菌具有非常复杂的群落结构。     

渗滤液回流对不同填埋结构甲烷变化规律的影响研究

建立了大型模拟填埋试验装置,研究了渗滤液回流对不同填埋结构甲烷变化规律的影响.每周对填埋气体中甲烷浓度进行监测.结果表明:厌氧填埋中回流操作使甲烷浓度峰值提前了147 d,峰值为59.6%(体积分数,下同);准好氧填埋中回流操作使甲烷浓度峰值提前259 d,峰值为44.7%.回流操作使甲烷产气高峰提前,增加产气量,加快填埋垃圾稳定,减轻渗滤液污染.厌氧填埋中进行回流操作有利于甲烷的回收利用;准好氧填埋结构可有效减少甲烷的排放,减小对环境的危害.稳定期的垃圾填埋体进行回流产生一定的甲烷,但浓度较低,最高仅26.0%,没有利用价值.     

发酵液回流对餐厨垃圾厌氧消化的影响

针对厌氧发酵液回流可提高厌氧系统性能,而不适的回流比例又会造成系统酸化的现象,采用单相连续反应器研究了发酵液回流及不同回流比对餐厨垃圾厌氧消化过程的影响。结果表明:在1 gVS/L的有机负荷下进行三种比例(10%、30%、50%)的发酵液回流使系统日平均产气量比不回流阶段分别提高0.7%、13.0%、4.9%,且对气体甲烷含量无显著影响。回流使VFA降解更充分,也使系统缓冲能力得到调节,但在较高的回流比(50%)下会造成Na+积累从而抑制系统产气性能。     

用纳滤膜分离技术处理发电厂循环冷却水

简要介绍了纳滤膜的定义和原理,并且对用纳滤膜处理厂循环冷却水进行工艺和经济技术分析。     

渗滤液回灌对填埋垃圾含水率的影响研究

文章通过模拟实验研究了不同的渗滤液回灌频率、回灌量和回灌速率对压实密度不同的垃圾的含水率的影响。研究表明,由于通道流的存在和影响,渗滤液的产生时间提前于填埋垃圾达到其有效贮水率的时间;渗滤液回灌频率越高、回灌量越大、回灌速率越慢、垃圾体温度越低、垃圾压实密度越高,则填埋垃圾的有效贮水率越大、含水率越高。在实施渗滤液回灌操作时,须综合考虑滤液回灌频率、回灌量、回灌速率、垃圾温度和垃圾压实密度等影响因素。     

回灌运行参数对新鲜垃圾渗滤液的影响研究

采用模拟试验装置考察回灌频率与回灌水力负荷对新鲜垃圾柱渗滤液的影响,试验结果表明:高频率回灌将导致新鲜垃圾柱渗滤液初期酸化阶段的低pH值和甲烷化阶段的高pH值。高水力负荷将导致新鲜垃圾柱渗滤液pH值下降。因此在新鲜垃圾填埋单元自身回灌初期应采取低频率小水力负荷。