Nanoencapsulation of hexavalent chromium with nanoscale zero-valent iron: High resolution chemical mapping of the passivation layer

Solid phase reactions of Cr(Ⅵ) with Fe(0) were investigated with spherical-aberration-corrected scanning transmission electron microscopy(Cs-STEM) integrated with X-ray energy-dispersive spectroscopy(XEDS). Near-atomic resolution elemental mappings of Cr(Ⅵ)–Fe(0) reactions were acquired. Experimental results show that rate and extent of Cr(Ⅵ) encapsulation are strongly dependent on the initial concentration of Cr(Ⅵ) in solution. Low Cr loading in nZⅥ(1.0 wt%) promotes the electrochemical oxidation and continuous corrosion of n ZⅥ while high Cr loading(1.0 wt%) can quickly shut down the Cr uptake. With the progress of iron oxidation and dissolution, elements of Cr and O counter-diffuse into the nanoparticles and accumulate in the core region at low levels of Cr(Ⅵ)(e.g., 10 mg/L). Whereas the reacted n ZⅥ is quickly coated with a newly-formed layer of 2–4 nm in the presence of concentrated Cr(Ⅵ)(e.g., 100 mg/L). The passivation structure is stable over a wide range of pH unless pH is low enough to dissolve the passivation layer. X-ray photoelectron spectroscopy(XPS) depth profiling reconfirms that the composition of the newly-formed surface layer consists of Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxides with Cr(Ⅵ) adsorbed on the outside surface. The insoluble and insulating Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxide layer can completely cover the n ZⅥ surface above the critical Cr loading and shield the electron transfer. Thus, the fast passivation of nZⅥ in high Cr(Ⅵ) solution is detrimental to the performance of nZⅥ for Cr(Ⅵ) treatment and remediation.     

Stability analysis of alkaline nitrobenzene-containing wastewater by a catalyzed Fe-Cu treatment process

Iron and copper bimetallic system (catalyzed Fe-Cu process) is a promising technology for alkaline nitrobenzene-containing wastewater treatment. However, little is currently known about the changes of treatment efficiency with time going. This research investigated the long-term performance of the catalyzed Fe-Cu process to reduce nitrobenzene (NB) in alkaline wastewater. In addition, the changes of the metal surfaces morphologies and matters before and after the reaction were analyzed by scanning electron microscopy (SEM) in conjunction with energy-dispersion spectroscopy (EDS) and X-ray diffraction spectroscopy (XRD). The results showed that the surface properties of copper almost remained unchanged after weeks of operation, which spelled its strong chemical stability and resistance to poisoning. Moreover, the results indicated that there were two reasons for the treatment efficiency decreasing with time. One was the gradual iron element consumption due to corrosion. The other was iron reactivity weakened due to the precipitates accumulation on the surfaces that were mainly Fe₃O₄ and FeCO. __________ Translated from Environmental Pollution & Control, 2006, 28(10): 783–785 [译自: 环境污染与防治]     

多层阻尼复合板常温贮存5年性能研究

目的分析多层阻尼复合板常温贮存5年的性能变化。方法对多层阻尼复合板进行常温下贮存5年的减振性能研究,通过贮存前后的正弦扫描试验和随机振动试验,获得贮存前后多层阻尼复合板的减振性能和模态变化,进行对比分析。结果阻尼复合板常温贮存5年后,径向模态有较大的下降,法向模态变化较少,组件上的加速度响应基本无变化。结论该多层阻尼复合板常温贮存5年后仍然满足要求。     

摩擦清洗修复铅污染土壤的参数优化及清洗效率评价

采用摩擦清洗法修复铅污染场地土壤,主要目的是将细颗粒和铅污染物从砂粒表面去除.通过正交实验优化清洗参数,并对3份不同铅含量土壤进行摩擦清洗实验.优化的清洗参数为:水土比70%干物质、温度25℃、搅拌时间30 min、搅拌速率1 200 r.mim-1.摩擦清洗前土壤经过筛分化验分析表明,3份土壤铅主要富集在砂粒和粉黏粒中;铅的分布与有机质有极大相关性.结果表明,经过摩擦清洗后,3份原状铅污染土壤砂粒的清洗效率分别为:67.61%、31.71%、41.01%,摩擦清洗从砂粒表面去除一部分细粒土壤和铅污染物,使铅浓缩至粉黏粒中;扫描电镜(SEM)分析表明,摩擦清洗后砂粒表面变光滑.以上结论说明摩擦清洗对于铅污染场地的砂粒土壤具有较好的清洗效果.     

Use of reporter-gene based bacteria to quantify phenanthrene biodegradation and toxicity in soil

A phenanthrene-degrading bacterium, Sphingomonas paucimobilis EPA505 was used to construct two fluorescence-based reporter strains. Strain D harboring gfp gene was constructed to generate green fluorescence when the strain started to biodegrade phenanthrene. Strain S possessing gef gene was designed to die once phenanthrene biodegradation was initiated and thus to lose green fluorescence when visualized by a live/dead cell staining. Confocal laser scanning microscopic observation followed by image analysis demonstrates that the fluorescence intensity generated by strain D increased and the intensity by strain S decreased linearly at the phenanthrene concentration of up to 200 mg/L. Such quantitative increase and decrease of fluorescence intensity in strain D (i.e., from 1 to 11.90 ± 0.72) and strain S (from 1 to 0.40 ± 0.07) were also evident in the presence of Ottawa sand spiked with the phenanthrene up to 1000 mg/kg. The potential use of the reporter strains in quantitatively determining biodegradable or toxic phenanthrene was discussed.     

高压实新疆阿尔泰膨润土微观结构随吸力变化特征

采用压汞法(MIP)和扫描电镜(SEM)法,在自由和侧限状态下,试验研究了高压实新疆阿尔泰膨润土在不同吸力条件下的微观结构变化特征。吸力的控制采用了气相法和渗析(液相)法。研究结果表明:(1)低吸力范围内,自由膨胀和侧限条件下的高压实膨润土土水特征存在明显差异;(2)膨润土在自由和侧限状态下的水化过程中呈现出了截然不同的微结构变化特征。自由膨胀条件下,土的吸水膨胀量主要来自土中大孔隙的逐渐膨胀。侧限状态下,随着控制吸力的降低,膨润土的大孔隙逐渐被压缩,较小孔隙的数量不断增加,土中孔隙分布变得更加均匀。     

Factors influencing on the bioaccessibility of polybrominated diphenyl ethers in size-specific dust from air conditioner filters

Size-specific concentrations and bioaccessibility of polybrominated diphenyl ethers (PBDEs) in dust from air conditioner filters were measured, and the factors influencing the PBDE bioaccessibility were determined. Generally, the PBDE concentrations increased with decreasing dust particle size, and BDE209 (deca-BDE) was generally the predominant congener. The bioaccessibility ranged from 20.3% to 50.8% for tri- to hepta-BDEs, and from 5.1% to 13.9% for BDE209 in dust fractions of varied particle size. The bioaccessibility of most PBDE congeners decreased with increasing dust particle size. The way of being of PBDE (adsorbed to dust surface or incorporated into polymers) in dust significantly influenced the bioaccessibility. There was a significant negative correlation between the tri- to hepta-BDE bioaccessibility and organic matter (OM) contents in dust. Furthermore, tri- to hepta-BDE bioaccessibility increased with increasing polarity of OMs, while with decreasing aromaticity of OMs. The tri- to hepta-BDE bioaccessibility significantly positively correlated with the surface areas and pore volumes of dust. Using multiple linear regression analysis, it was found that the OM contents and pore volumes of dust were the most important factors to influence the tri- to hepta-BDE bioaccessibility and they could be used to estimate the bioaccessibility of tri- to hepta-BDEs according to the following equation: bioaccessibility (%) = 45.05 − 0.49 × OM% + 1.79 × pore volume. However, BDE209 bioaccessibility did not correlate to any of these factors.     

The Characterisation of Settled Dust by Scanning Electron Microscopy and Energy Dispersive X-ray Analysis

Settled dust has been collected inside the main foyers ofthree University buildings in Wolverhampton City Centre,U.K. Two of the three buildings are located in a streetcanyon used almost exclusively by heavy duty dieselvehicles. The dust was collected on adhesive carbonspectro-tabs to be in a form suitable for analysis byscanning electron microscope and energy dispersive X-rayanalysis. Using these analytical techniques, individualparticle analysis was undertaken for morphology andchemistry. Seasonal variations and variations due tolocation were observed in both the morphologicalmeasurements and chemical analysis. Many of the differencesappear attributable to the influence of road traffic, inparticular, the heavy duty diesel vehicles, travellingalong the street canyon.     

Ce-MCM-22分子筛的合成与吸附动力学研究

采用静态水热晶化法,以硅溶胶为硅源、六亚甲基亚胺(HMI)为模板剂,通过掺杂Ce合成了具有MWW层状结构的Ce-MCM-22分子筛。并利用粉末X-射线衍射(XRD)、扫描电镜(SEM)、透射电镜(TEM)等方法对其进行了表征,对其进行了吸附动力学的研究。研究表明,Ce-MCM-22吸附动力方程拟一级方程为y=-0.028 1x-0.136,R2=0.983 4。Ce-MCM-22吸附动力方程拟二级方程为y=0.465 7x+1.2005,R2=0.999 5,说明拟二级反应模型更能真实地反映分子筛吸附亚甲蓝溶液的反应机理。     

便携式GC/MS对空气中苯系物的定量分析方法研究

文章采用简单快速的采气袋配气方式,以苯系物为例,研究了便携式GC/MS对大气中痕量有机污染物的快速定量测定方法。分别在Full scan和建立的SIM扫描方式下对苯系物标准样品进行了测定。对比实验结果表明,Full scan和SIM两种扫描方式下苯系物测定结果的相对标准偏差分别在5.1%~28.4%和13%~19%之间,回收率范围分别为46%~186%和60%~110%,方法检出限范围分别为2.504~10.63μg/m3和0.494~2.399μg/m3。总体而言,SIM方式在测定结果的精密度与准确度上均优于Full scan方式。室内外空气样品的测试结果映证了SIM方式在对痕量有机污染物测定的优势。