Feasibility of honeycomb monolith supported sugar catalyst to produce biodiesel from palm fatty acid distillate (PFAD)

Carbon coated monolith was prepared by sucrose solution 65 wt.% via dip-coating method. Sulfonation of incomplete carbonized carbon coated monolith was carried out in order to synthesize solid acid catalyst. The textural structure characteristics of the solid acid catalyst demonstrated a low surface area and pore volume. Palm fatty acid distillate (PFAD), a by-product of palm oil refineries, was utilized as oil source in biodiesel production. The esterification reaction subjected to different reaction conditions was performed by using the sulfonated carbon coated monolith as heterogeneous catalyst. The sulfonation process had been performed by using vapour of concentrated H₂SO₄ that was much easier and efficient than liquid phase sulfonation. Total acidity value of carbon coated monolith was measured for unsulfonated sample (0.5 mmol/g) and sulfonated sample (4.2 mmol/g). The effect of methanol/oil ratio, catalyst amount and reaction time were examined. The maximum methyl ester content was 89% at the optimum condition, i.e. methanol/oil molar ratio (15:1), catalyst amount (2.5 wt.% with respect to PFAD), reaction time (240 min) and temperature 80 °C. The sugar catalyst supported on the honeycomb monolith showed comparable reactivity compared with the sugar catalyst powder. However, the catalyst reusability studies showed decrease in FFA% conversion from 95.3% to 68.8% after four cycles as well as the total acidity of catalyst dropped from the value 4.2 to 3.1 mmol/g during these cycles. This might be likely due to the leaching out of SO₃H group from the sulfonated carbon coated monolith surface. The leaching of active species reached a plateau state after fourth cycle.     

Tolerance of calluna vulgaris and peatland plant communities to sulphuric acid deposition

Critical loads offer a unique way of evaluating impacts of acid deposition by quantifying environmental sensitivity. The critical loads of acidity for UK peat soils have been based upon an arbitrary reduction in pH of 0.2 units. This chemical shift needs to be better related to adverse effects on sensitive biological receptors. It is known that effective precipitation pH equates closely to soil solution pH, and the latter is directly linkable to biotic effects of pH change. On continuation of a long-term experiment assessing impacts of simulated acid rain on peat microcosms in a realistic outdoor environment, Calluna vulgaris continued to flourish at acid deposition loads well above the existing critical load. Calluna plants were harvested and analysed, and acid deposition treatments to the microcosms continued to allow natural vegetation to regenerate. A diverse mixture of moorland plants and bryophytes established at acidity treatments well above the existing critical load, and only a very high acid load resulted in no natural regeneration. A critical effective rain pH value of 3.6 is suggested as a basis for setting critical loads. At this pH, Calluna grows well, and a healthy diverse vegetation community re-establishes when harvested. It is suggested that the peat critical load should be set at the acid load that, at any specific site, would result in a mean effective precipitation pH of 3.6.     

Kinetics of photoelectrocatalytic degradation of humic acid using B_2O_3·TiO_2/Ti photoelectrode

IntroductionEightypercentoforganicsubstancesinthesourcewaterisfromcrudehumicacidthatisacrudeorganiccompoundcreatedbyrottinganddecomposinginnaturalcycle ,thehighercontentofhumicacidis ,theworsequalityofthewateris,notonlycanitcausechrominance,offensiveodor,…     

石油亚砜萃取巯基醋酸的研究

对石油亚砜(PSO)萃取巯基醋酸的条件和影响进行了实验研究,确定了石油亚砜通过氢键和巯基醋酸形成的萃合物的组成.为从废水中回收巯基醋酸以及石油硫醚的综合利用提供了依据.     

H酸综合废水治理工艺试验研究及工程应用

针对H酸母液及T酸一次洗水高含盐量有机废水进行系统的实验研究，结果表明：废水经冷却、结晶、过滤后，用铁屑过滤，石灰乳、PAM处理．使废水COD去除率为50％，脱色率为7O％，BOD／CODcr提高到0．2以上，预期COD去除率达60％以上，BOD去除率达85％以上，NH3—N去除率达80％以上．     

A novel technology for quick acclimation of an anaerobic microbial consortia used for biodegrading teraphthalic acid (TA)

ＩｎｔｒｏｄｕｃｔｉｏｎＴｅｒａｐｈｔｈａｌｉｃａｃｉｄ (ＴＡ)ｉｓｏｎｅｏｆｔｈｅｐｅｔｒｏｃｈｅｍｉｃａｌｓｗｉｄｅｌｙｕｓｅｄｉｎｔｈｅｓｙｎｔｈｅｓｉｓｏｆｐｏｌｙｅｓｔｅｒｆｉｂｅｒ,ｖｉｄｅｏｆｉｌｍｓａｎｄｏｔｈｅｒａｐｐｌｉｃａｔｉｏｎｓ .Ｓｉｎｃｅｂｉｓ (2 ｅｔｈｙｌｈｅｘｙｌ)ｐｈｔｈａｌａｔｅ ,ｄｉｅｔｈｙｌｐｈｔｈａｌａｔｅａｎｄｄｉｍｅｔｈｙｌｐｈｔｈａｌａｔｅｈａｖｅｂｅｅｎｃｌａｓｓｉｆｉｅｄａｓｐｒｉｏｒｉｔｙｈａｚａｒｄｏｕｓｃｏｍｐｏｕｎｄｓｂｙＥＰＡｏｆｔｈｅ…     

UASB-BIOFOR滤池组合工艺处理柠檬酸废水的中试研究

采用UASB-BIOFOR滤池组合工艺处理柠檬酸废水,对其中的操作步骤及注意事项进行了详细介绍.实验结果表明,该组合工艺对柠檬酸废水处理效果良好,系统出水能够达到GB 8978-1996《污水综合排放标准》中的一级标准.     

从自燃煤矸石中提取聚合铝铁(PAFC)的试验研究

采用盐酸酸浸的方法从自燃煤矸石中提取聚合铝铁，对煤矸石的粉碎粒径、酸浸盐酸的浓度及用量、酸浸的温度等工艺条件进行了试验研究。结果表明，从100g自燃煤矸石中，可提取19．85g固体聚合铝铁，成品的Al2O3含量33％、Fe2O3含量16％、盐基度70％。     

岩溶山区雨水资源有效利用研究——以贵州省普定县马官地下水库为例

以贵州省普定县马官地下水库为例,从区域岩溶地质概况、成库条件、库容分析和降雨量及补给量计算、工程效益等方面,对马官地下水库进行了研究,阐述了马官地下水库是岩溶山区雨水资源有效开发利用的典型,具有推广意义。     

Fulvic acid removal by nanoparticle TiO2 using a submerged membrane photocatalysis reactor

The degradation of fulvic acid（FA） by nanoparticle TiO2 in a submerged membrane photocatalysis（SMPC） reactor was studied. In this reactor, photocatalytic oxidation and membrane separation co-occured. The continuous air supplier provided O2 for the photocatalytical reaction and mixed the solution through an airflow controller. The particle TiO2 could automatically settle due to gravity without particle agglomeration so it could be easily separated by microfiltration（MF） membrane. It was efficient to maintain high flux of membranes. The effects of operational parameters on the photocatalytic oxidation rate of FA were investigated. Results indicated that photocatalyst at 0.5 g/L and airflow at 0.06 m^3/h were the optimum condition for the removal of fulvic acid, the removal efficiency was higher in acid media than that in alkaline media. The effects of different filtration duration on permeate flux rate of MF with P25 powder and with nanoparticle TiO2 were compared. Experimental results indicated that the permeate flux rate of MF was improved and the membrane fouling phenomenon was reduced with the addition of nanoparticle TiO2 catalyst compared with conventional P25 powder. Therefore, this submerged membrane photocatalysis reactor can faciliate potential application of photocatalytic oxidation process in drinking water treatment.