过氧化氢催化氧化难降解废水的研究

文章以过氧化氢为氧化剂,以γ-Al2O3为载体采用浸渍法制得不同金属含量的九种催化剂进行催化氧化实验,并优选出以5.0%Co、2.5?(质量百分含量)催化剂CODcr去除率较好,并确定此催化剂在常温常压下,反应时间为30 min,pH=6,氧化剂用量为30g/L时,CODcr的去除率最高为83%,这样不仅提高了BOD5/CODcr值,而且有利于后续生化处理,减轻后续处理装置负荷.     

复合混凝剂处理印染废水

为了处理高浓度、高色度、高COD的印染废水，利用硫酸亚铁、工业废酸和金属下脚料自行配制了复合混凝剂，并将其与聚合双酸铝铁、聚合氯化铝铁、硫酸亚铁对印染废水的混凝效果进行对比。研究表明，复合混凝剂处理印染废水具有成本低、效果好的特点。当硫酸亚铁的投加量为200mg/L，复合混凝剂的投加量为1280mg／L，PAM的用量为2mg／L时，脱色率达94．9％，COD去除率达78．1％，悬浮固体（SS）去除率达90．9％。     

亚铵制浆黑液非无菌操作连续发酵生产酵母

从土壤中筛选出能在亚铵黑液中生长的毕赤酵母菌株（Ｐｉｃｈｉａ ｓｐ．Ｎｏ．１）经耐毒驯化后，可接种于酸析脱木素和汽提脱毒后的亚铵黑液中，在非无菌操作条件下连续发酵生产酵母菌体，该菌生产迅速，连续培养衡释率达０．２６ｈ＾－１，总糖的酵母得率为０．４８ｇ／ｇ（ＴＳ），ＣＯＤ去除２３％，菌体易絮凝，可自然沉降分离。     

生物活性炭投加量对垃圾渗滤液处理效果的影响

试验对比了不同生物活性炭(biological activated carbon,BAC)投加量对垃圾渗滤液去除COD效果的影响.每升活性污泥中活性炭投加量为0、100、300 g的反应器处理垃圾渗滤液100个周期平均COD去除率分别为12.9%、19.6%、27.7%,表明BAC可以去除部分难降解有机物,并且COD去除率与投加量呈正相关关系.曝气8 h反应器中二氧化碳(CO2)产生量依次为109、193、306 mg,表明生物分解量也与投加量呈正相关关系.分析认为COD去除率与投加量的正相关关系是由于吸附与生物再生的共同作用导致,生物再生是BAC能够生物分解难降解有机物的根本原因.     

浅析废烟气脱硝催化剂环境管理

随着"十二五"期间国家对氮氧化物排放的控制越来越严格,选择性催化还原(SCR)烟气脱硝技术被广泛应用于火电厂的脱硝工程。本文介绍我国目前废烟气脱硝催化剂的产生情况、存在的环境风险以及发达国家的管理经验,从而提出我国将废烟气脱硝催化剂纳入危险废物管理,推行危险废物经营许可证制度,加强产生和经营单位的日常监督管理,从而促进行业的健康可持续发展。     

废旧锌锰电池生物淋滤-水热法制备纳米锰锌铁氧体

以氧化硫硫杆菌(A.thiooxidans)和氧化亚铁钩端螺旋菌(L.ferrooxidans)为混合淋滤菌株对废旧锌锰电池进行了生物浸提,并以获取的淋滤液为前驱体,采用水热法制备出系列锰锌铁氧体软磁材料(Mn_(1-x)Zn_xFe_2O_4,x=0.2~0.8);结合X射线衍射(XRD)、扫描电镜-能谱(SEMEDX)、振动样品磁强计(VSM)、透射电镜(TEM)、红外光谱(FT-IR)、热重-差热分析(TG-DTA)等表征手段对制备材料的结构、形貌、磁学性能和稳定性进行分析.结果表明,在5%固液比(质量体积比,5 g/100 mL,以下均表述为"5%固液比")下,经过5 d的外源酸调控生物浸提,分别获得了84.5%、63.2%的Zn、Mn浸出效率;当Zn∶Mn∶Fe=0.4∶0.6∶2.0(物质的量比,即x=0.4)时,制备的纳米级Mn_(0.6)Zn_(0.4)Fe_2O_4性能最优,属纯相的立方尖晶石结构,颗粒分布均匀,饱和磁化强度(M_s)、剩余磁化强度(M_r)和矫顽力(H_c)分别为68.9 emu·g~(-1)、4.7 emu·g~(-1)和53.6 Oe,具有热稳定性和耐酸碱性,有望成为一种新型的水处理磁性材料.     

Characterization of coffee residues pellets and their performance in a residential combustor

Spent coffee grounds (SCG) and coffee husks (CH) were evaluated as biofuels, after densification, for energy production. CH represent a specific problem for the coffee industry due to a low calorific value, high ash content, and a very low bulk density. Hence, the energetic potential of SCG (95 wt%)/CH (5 wt%) blend and pure SCG (100%) were examined. The blend of SCG and CH was limited to 5 wt% of CH because of the low bulk density of CH. Therefore, physicochemical and energetic characterizations of the produced pellets were performed. Thermogravimetric analyses were performed under nitrogen and air atmospheres to evaluate the CH behavior in the blend. Characterization study shows that both produced pellets could reach the French Agropellets standard (AQI). Thermal degradation showed that the mean reactivity of the SCG/HC pellets was higher than pure SCG. Then, combustion experiments were performed in a domestic combustor, after modification of the boiler power in order to improve its energetic performances. The presence of CH led to a rise of CO, NOx, VOC’s, and particle emissions. Nevertheless, the performances of the biofuels are almost in agreement the NF EN 12809 standard.     

Application of 1D and 2D MFR reactor technology for the isolation of insecticidal and anti-microbial properties from pyrolysis bio-oils

Valuable chemicals can be separated from agricultural residues by chemical or thermochemical processes. The application of pyrolysis has already been demonstrated as an efficient means to produce a liquid with a high concentration of desired product. The objective of this study was to apply an insect and microorganism bioassay-guided approach to separate and isolate pesticidal compounds from bio-oil produced through biomass pyrolysis. Tobacco leaf (Nicotianata bacum), tomato plant (Solanum lycopersicum), and spent coffee (Coffea arabica) grounds were pyrolyzed at 10°C/min from ambient to 565°C using the mechanically fluidized reactor (MFR). With one-dimensional (1D) MFR pyrolysis, the composition of the product vapors varied as the reactor temperature was raised allowing for the selection of the temperature range that corresponds to vapors with a high concentration of pesticidal properties. Further product separation was performed in a fractional condensation train, or 2D MFR pyrolysis, thus allowing for the separation of vapor components according to their condensation temperature. The 300–400°C tobacco and tomato bio-oil cuts from the 1D MFR showed the highest insecticidal and anti-microbial activity compared to the other bio-oil cuts. The 300–350 and 350–400°C bio-oil cuts produced by 2D MFR had the highest insecticidal activity when the bio-oil was collected from the 210°C condenser. The tobacco and tomato bio-oil had similar insecticidal activity (LC₅₀ of 2.1 and 2.2 mg/mL) when the bio-oil was collected in the 210°C condenser from the 300–350°C reactor temperature gases. The 2D MFR does concentrate the pesticidal products compared to the 1D MFR and thus can reduce the need for further separation steps such as solvent extraction.     

生物难降解有机污染物的治理对策

针对废水中难降解化学合成有机污染物的种类和数量不断增加，生物处理出水达标困难的现状，总结了国内外的经验和研究成果，对现有处理装置改造提出了若干建议，并介绍了几种国外废水处理新技术。     

膜电解技术处理含氯及重金属的废酸

采用离子交换膜电解技术处理铜冶炼过程产生的含氯及重金属的废酸。考察了废酸处理工艺、电解温度、电解时间、电流密度和催化剂的添加等条件对处理效果的影响。实验结果表明：采用先沉淀重金属后脱氯的废酸处理工艺,氯离子和铜离子的去除效果均较好;当以钛盐为催化剂时,在电解温度为40 ℃、电解时间为2.0 h、电流密度为825 A/m²的最佳工艺条件下,处理后废酸中的氯离子质量浓度为0.22 g/L,氯离子去除率为98.59%,铜离子质量浓度为0.45 g/L,铜离子去除率为95.08%,其他重金属大部分也得到有效去除。净化后的废酸可回用至铜冶炼的生产过程中。