The Impact of Agriculture On Dissolved Nitrogen and Phosphorus Cycling in Temperate Ecosystems

Although most research has focussed on inorganic nutrient forms of nitrate (NO^-₃) and phosphorus (PO³₄) in runoff and receiving waters, nitrogen loss from agricultural land can also occur in organic and ammonium-nitrogen form; phosphorus losses, although often dominated by particulate transport, may occur in soluble organic and inorganic form. Furthermore, fluxes between different species may take place during transport from the land to the stream and as a result of in-stream, in-river or in-lake transformations. Knowledge of the spatial and temporal variation in all nitrogen species and phosphorus fractions in a drainage basin is therefore essential if the wider environmental significance of elevated nutrient concentrations in natural waters are to be assessed. This paper reviews recent work on N and P losses from agricultural land and presents some results from two intensive agricultural catchments: Slapton, Devon and the river Windrush catchment in the Cotswolds.     

Treatability studies of naphthalene in soil,water and air with persulfate activated by iron(Ⅱ)

Chemical oxidation was applied to an artificially contaminated soil with naphthalene (NAP). Evaluation of NAP distribution and mass reduction in soil, water and air phases was carried out through mass balance. Evaluation of NAP distribution and mass reduction in soil, water and air phases was carried out through mass balance. The importance of the air phase analysis was emphasized by demonstrating how NAP behaves in a sealed system over a 4 hr reaction period. Design of Experiments method was applied to the following variables: sodium persulfate concentration [SP], ferrous sulfate concentration [FeSO₄], and pH. The system operated with a prefixed solid to liquid ratio of 1:2. The following conditions resulted in optimum NAP removal [SP] = 18.37 g/L, [FeSO₄] = 4.25 g/L and pH = 3.00. At the end of the 4 hr reaction, 62% of NAP was degraded. In the soil phase, the chemical oxidation reduced the NAP concentration thus achieving levels which comply with Brazilian and USA environmental legislations. Besides the NAP partitioning view, the monitoring of each phase allowed the variabilities assessment over the process, refining the knowledge of mass reduction. Based on NAP distribution in the system, this study demonstrates the importance of evaluating the presence of semi-volatile and volatile organic compounds in the air phase during remediation, so that there is greater control of the system as to the distribution and presence of the contaminant in the environment. The results highlight the importance of treating the contaminant in all its phases at the contaminated site.     

中国乳腺癌与土壤环境中化学元素的相关性研究

利用土壤元素资料２０６９４４８个数据、乳腺癌死亡调查资料３１３２０例，研究了乳腺癌死亡率与人群生存的土壤环境中64个元素的相关性。结果表明，砷、汞、钡、铊、钕、铀、锆、锑等元素与乳腺癌死亡率有相关性。等级相关系数分别为－０．６８２０（Ｐ〈０．０００５）、０．４５６７（Ｐ〈０．０１）、－０．３７７３（Ｐ〈０．０２５）、－０．３８５２（Ｐ〈０．０２５）、０．３１７９（Ｐ〈０．０５）、－０．４３７７（Ｐ〈     

SBR-COR工艺处理高浓度、多品种混合化工污水

介绍了ＳＢＲ－ ＣＯＲ 工艺处理高浓度、多品种混合化工污水的工艺流程、工作原理及闲置保养情况，详细地阐述了活性污泥生物相与运行状况的关系。实际运行表明，ＳＢＲ－ ＣＯＲ 具有重新启动所需时间短、微生物激活快，对浓度高、毒性大的化工污水具有耐冲击特性，外理效果显著。     

Using chemical process simulation to design industrial ecosystems

Chemical process simulation (CPS) software has been widely used by chemical (process) engineers to design, test, optimise, and integrate process plants. It is expected that industrial ecologists to bring these same problem-solving benefits to the design and operation of industrial ecosystems can use CPS. This paper provides industrial ecology researchers and practitioners with an introduction to CPS and an overview of chemical engineering design principles. The paper highlights recent research showing that CPS can be used to model industrial ecosystems, and discusses the benefits of using CPS to address some of the technical challenges facing companies participating in an industrial ecosystem. CPS can be used to (i) quantitatively evaluate and compare the potential environmental and financial benefits of material and energy linkages; (ii) solve general design, retrofit, or operational problems; (iii) help to identify complex and often counter-intuitive solutions; and (iv) evaluate what-if scenarios. CPS should be a useful addition to the industrial ecology toolbox.     

颗粒物质金属形态逐级提取技术问题的探讨

本文综述了国内外对颗粒物质中金属形态逐级提取测定技术方面的研究情况，重点阐述了颗粒物质金属形态分离方法，并对各相态的浸取技术和金属总量提取方法进行了讨论．从而为开展颗粒物质的金属化学形态的分析和研究，提出几点认识．     

化学絮凝—SBR法处理味精废水的研究

利用化学絮凝联用 SBR法对味精废水进行处理 ,该方法比较符合味精生产厂家的实际并取得了较好的初步结果     

HBCOD-1型COD在线自动监测仪的应用

介绍了HBCOD-1型COD在线自动监测仪的测定原理、分析流程和性能特点。仪器采用重铬酸钾氧化水中有机物和还原性无机物，通过分光光度法测定水中化学耗氧量（COD值）。与国标方法进行线性回归校正后，仪器测定值与国标方法测得的CODCr，值具有较好的一致性。     

含CM,TMP及SMZ的化学合成制药废水研究

含有氯霉素(CM)、抗菌素增效剂(TMP)和磺胺新诺明(SMZ)的合成制药废水对生物处理有较强的抑制作用.研究表明,通过对厌氧菌和好氧菌的驯化、筛选和复配采用吹脱-厌氧-好氧串联工艺可有效降低废水的有机污染指标:经吹脱和厌氧水解酸化处理后,CODCr去除率为70%,再经好氧生化系统处理,CODCr去除率可达60%.试验结果表明装置运行效果稳定,为实际废水处理提供了一定设计依据.     

水中化学耗氧量的快速测定法

利用烘箱法测定水中的化学耗氧量是国内外在微量分析测定方法上较为先进的分析，优点是仪器、设备简便、操作简单、分析快速、节省大量化学试剂，可以大批量地进行试验．实验中不加入硫酸汞试剂，避免或减少了汞污染．方法的空白值较好，提高了实验的精密度和准确度，是一种易推广的方法