同槽电解法处理锌—锰废干电池机理研究

针对锌 锰干电池的构成特点 ,结合所采用的研究工艺 ,从试验机理角度对采用同槽电解法处理锌 锰废干电池的工艺方法和工艺条件进行了分析和研究 ,提出了新型的实现废干电池资源化处理技术路线。     

用于燃料电池的甲醇水蒸气重整反应制氢的研究

研究了甲醇水蒸气重整制氢反应过程中各种因素对Cu／ZnO／Al2O3催化剂的活性和选择性的影响。结果表明：Cu／Zn比为2．0的催化剂在250℃反应时，催化剂效果较好，最合适反应条件是：压力0．1MPa，温度250℃，n(H2O)：n(CH3OH)=1．0-1．2，液体流速0．1mL／min。在Cu／ZnO／Al2O3)，催化剂上，甲醇水蒸气重整、甲醇分解和水气转换反应随反应条件的不同而发生相互抑制或促进作用。     

火电厂烟气脱硫工艺国产化初探

火电厂排放的SO2形成酸雨已严重危害人类生存环境。国家把解决烟气脱硫问题纳入大政方针之中，强制要求火电厂必须安装烟气脱硫装置。文章介绍了几种目前国际上较为成熟的脱硫工艺，并对各种工艺进行了比较，分析了国内烟气脱硫市场，并就脱硫技术国产化问题提出若干看法。     

Paradise Threatened: Land Use and Erosion on St. John, US Virgin Islands

2 /yr, respectively. Geomorphic evidence indicates that plantation agriculture during the 18th and 19th centuries did not cause severe erosion. Since about 1950 there has been rapid growth in roads and development due to increasing tourism and second-home development. Our field investigations identified the approximately 50 km of unpaved roads as the primary source of anthropogenic sediment. Field measurements of the road network in two catchments led to the development of a vector-based GIS model to predict road surface erosion and sediment delivery. We estimate that road erosion has caused at least a fourfold increase in island-wide sediment yields and that current sedimentation rates are unprecedented. Paving the dirt roads and implementing standard sediment control practices can greatly reduce current sediment yields and possible adverse effects on the marine ecosystems surrounding St. John.     

Experimental and theoretical investigation of dry-water containing phosphoric acid for new fire suppressant

To overcome the shortcomings of phosphorus-containing compounds (PCCs, not widely used) in fire suppression, the dry water powder containing phosphoric acid was analyzed for a new fire suppressant (SiO₂-P). First, the fine conditions (solid-to-liquid ratio, stirring time and stirring speed) were determined to prepare the new powder. The particle size distributions and XPS of SiO₂-P powder were analyzed. The TG tests were conducted to study the decomposition of powder, and there was a major decomposition peak. Second, the extinguishing time of SiO₂-P powder was tested, which showed that the SiO₂-P powder containing phosphorus species could significantly improve the fire suppression ability. In addition, the kinetic parameters of powder decomposition reaction were determined by genetic algorithm based on TG results. Last, based on the decomposition products and kinetic parameters, the burning velocity and mass fraction of free radicals of CH₄/air flame with SiO₂-P powder addition were studied theoretically. The results indicated that SiO₂-P powder had great ability of reducing the burning velocity and scavenging free radicals. Furthermore, the suppression effects were analyzed, which indicated that the cooperation of H₂O and P suppression effect dominated the suppression mechanism and resulted in the good suppression efficiency.     

Experimental investigation,intelligent modeling and multi-characteristics optimization of dry WEDM process of Al–SiC metal matrix composite

Dry wire electrical discharge machining (WEDM) is an environmentally friendly modification of the oil WEDM process in which liquid dielectric is replaced by a gaseous medium. In the present work, parametric analysis has been fulfilled while dry WEDM of Al–SiC metal matrix composite. Experiments were designed and conducted based on L₂₇ Taguchi's orthogonal array to study the effect of pulse on time, pulse off time, gap voltage, discharge current, wire tension and wire feed on cutting velocity (CV) and surface roughness (SR). Firstly, a series of exploratory experiments has been conducted to identify appropriate gas and wire material based on the values of cutting velocity. After selection of best gas and best wire, they were used for later stage of experiments. Analysis of variances (ANOVA) has been performed to identify significant factors. In order to correlate relationship between process inputs and responses, an adaptive neuro-fuzzy inference system (ANFIS) has been employed to predict the process characteristics based on experimental observation. At the end, an artificial bee colony (ABC) algorithm has been associated with ANFIS models to maximize CV and minimize SR, simultaneously. Then the optimal solutions that obtained through ANFIS-ABC technique have been compared with numbers of confirmatory experiments. Results indicated that oxygen gas and brass wire guarantee superior cutting velocity. Also, according to ANOVA, pulse on time and discharge current were found to have significant effect on CV and SR. In modeling of CV and SR by ANFIS, it was resulted that the proposed method has superiority in prediction of them in the ranges of factors beyond the training condition. Also, association of ANFIS with ABC can find the optimal combination of process parameters accurately according to the confirmatory experiments.     

浅谈热泵技术在兖矿集团的应用

通过对兖矿集团所属煤矿供暖小区的现状以及能耗进行调查、分析,本文就如何采用先进的热泵技术,对矿区燃煤小锅炉进行节能技术改造展开探讨,对类似节能改造有较高借鉴作用。     

Low cost measurements of nitrogen and sulphur dry deposition velocities at a semi-alpine site: gradient measurements and a comparison with deposition model estimates

The conditional time averaged gradient method was used to measure air-surface exchange of nitrogen and sulphur compounds at a semi-alpine site in Southern Norway. Dry deposition velocities were then obtained from the bi-weekly concentration gradient measurements. Annual deposition velocities were found to be 1.4, 11.8 and 4.0 mm s(-1) for NH3, HNO3 and SO2, respectively, if all data were included, and to be 10.8, 11.8 and 13.0 mm s(-1), respectively, if only positive values were included. Measured deposition velocities were compared to two sets of values estimated from a big-leaf dry deposition module applying to two different land types (short grass and forbs, and tundra), driven by measured micrometeorological parameters. The deposition module gives reasonable values for this site throughout the year, but does not reproduce the large variability as shown in the measured data. No apparent seasonal variations were found from either measurements or module estimates due to the very low productivity of the studied area.     

Steam reforming of glycerol for syngas generation under cold plasma conditions: A DFT study

Density functional theory (DFT) has been used to investigate the reaction pathways with steam reforming of glycerol under cold plasma conditions. Total energies, energy barriers, and reaction enthalpies at 298.15 K have been calculated at the GGA/PW91/DNP level. The calculation shows that, with the presence of steam, the energy barrier of glycerol conversion is reduced and the conversion from glycerol to H₂ and CO is promoted under cold plasma conditions. The formation of syngas was through a multi-step pathway via the conversion of OHCH₂CHOH, CH₂OH, CH₂O, HCO,·and CH₃, while the recombination of H generated extra H₂. The synthesis of hydrocarbons are from the recombination of·CH₃,·CH₂, and·CH, which could be primarily generated through glycerol dissociation. The structure of glycerol anion was also studied in this work, and it was less stable than the neutral molecule. The route for the formation of OHCH₂CHOH·and CH₂OH·from glycerol anion is thermodynamically favorable.     

Nitrogen deposition effects on Mediterranean-type ecosystems: an ecological assessment

We review the ecological consequences of N deposition on the five Mediterranean regions of the world. Seasonality of precipitation and fires regulate the N cycle in these water-limited ecosystems, where dry N deposition dominates. Nitrogen accumulation in soils and on plant surfaces results in peaks of availability with the first winter rains. Decoupling between N flushes and plant demand promotes losses via leaching and gas emissions. Differences in P availability may control the response to N inputs and susceptibility to exotic plant invasion. Invasive grasses accumulate as fuel during the dry season, altering fire regimes. California and the Mediterranean Basin are the most threatened by N deposition; however, there is limited evidence for N deposition impacts outside of California. Consequently, more research is needed to determine critical loads for each region and vegetation type based on the most sensitive elements, such as changes in lichen species composition and N cycling.