Regulated emission characteristics of in-use LNG and diesel semi-trailer towing vehicles under real driving conditions using PEMS

On-road driving emissions of six liquefied natural gas(LNG) and diesel semi-trailer towing vehicles(STTVs) which met China Emission Standard IV and V were tested using Portable Emission Measurement System(PEMS) in northern China.Emission characteristics of these vehicles under real driving conditions were analyzed and proved that on-road emissions of heavy-duty vehicles(HDVs) were underestimated in the past.There were large differences among LNG and diesel vehicles, which also existed between China V vehicles and China IV vehicles.Emission factors showed the highest level under real driving conditions, which probably be caused by frequent acceleration, deceleration, and start-stop.NOx emission factors ranged from 2.855 to 20.939 g/km based on distance-traveled and 6.719–90.557 g/kg based on fuel consumption during whole tests, which were much higher than previous researches on chassis dynamometer.It was inferred from tests that the fuel consumption rate of the test vehicles had a strong correlation with NOx emission, and the exhaust temperature also affected the efficiency of Selected Catalytic Reduction(SCR) aftertreatment system, thus changing the NOx emission greatly.THC emission factors of LNG vehicles were 2.012–10.636 g/km, which were much higher than that of diesel vehicles(0.029–0.185 g/km).Unburned CH_4 may be an important reason for this phenomenon.Further on-road emission tests, especially CH_4 emission test should be carried out in subsequent research.In addition, the Particulate Number(PN) emission factors of diesel vehicles were at a very high level during whole tests, and Diesel Particulate Filter(DPF)should be installed to reduce PN emission.     

ACF的结构及其滤材特性的研究

根据活性炭纤维与颗粒状活性炭的平行实验，对比了ＡＣＦ与ＧＡＣ的物化特性和基本结构，以说明ＡＣＦ作为新型环境功能材料的特点，在实验室建立的流动法测定材料吸附特性的系统中，对ＡＣＦ在不同流量下对不同上游浓度污染气体（ＮＨ３）的吸附性能进行了测定，获得了ＡＣＦ的穿透曲线，对其吸附性能与吸附床流量和上游浓度进行了相关分析，并对以ＡＣＦ为滤料的空气过滤器的除污性能进行了测试。     

复杂矿井通风系统角联风路自动识别方法的研究

角联风路的识别与稳定性分析是矿井通风系统稳定性与可靠性分析理论中的核心内容之一。笔者对通风系统角联风路进行了深入的研究;分析了通路法的局限性,简化了角联风路的数学模型,提出了快速、准确、灵活的角联风路自动识别的新方法——节点位置法;编写了角联风路自动识别软件,并应用现场数据进行测试,将其结果与通路法的结果进行了比较分析;证明了节点位置法是切实可行的。     

超滤技术的应用和发展研究

本文介绍了超滤技术的相关知识,在水处理、食品工业、染料工业的应用。最后探讨了超滤技术的发展趋势。     

提高GPS定位精度的群调度滤波算法*

为解决现行安全生产科技领域中全球定位系统（GPS）/惯性导航系统（INS）融合系统容易产生较大时变误差的关键问题,满足GPS定位信号的精度和信号数据处理时间的要求,提出1种群调度滤波算法,通过实验仿真,分别与模糊算法、机器学习算法及卡尔曼滤波网络算法进行比较研究。结果表明:群调度滤波算法兼顾了定位精度与数据处理时间,具有较大优势,可在航空安全、船舶安全、应急监测、灾后抢险等安全科技领域广泛应用。     

Monte Carlo analysis of field water flow comparing uni- and bimodal effective hydraulic parameters for structured soil

Soil structure critically affects the hydrological behaviour of soils. In this paper, we examined the impact of areal heterogeneity of hydraulic properties of a structured soil on soil ensemble behaviour for various soil water flow processes with different top boundary conditions (redistribution and drainage plus evaporation and infiltration). Using a numerical solution of the Richards' equation in a stochastic framework, the ensemble characteristics and flow dynamics were studied for drying and wetting processes observed during a time interval of ten days when a series of relatively intense rainfall events occurred. The effects of using unimodal and bimodal interpretative models of hydraulic properties on the ensemble hydrological behaviour of the soil were illustrated by comparing predictions to mean water contents measured over time in several sites at field scale. Although the differences between unimodal and bimodal fitting are not significant in terms of goodness of fit, the differences in process predictions are considerable with the bimodal soil simulating water content measurements much better than unimodal soil. We also investigated the relative contribution of the soil variability of each parameter on the variance of the water contents obtained as the main output of the stochastic simulations. The variability of the structural parameter, weighting the two pore space fractions in the bimodal interpretative model, has the largest contribution to water content variance. The contribution of each parameter depends only partly on the coefficient of variation, much more on the sensitivity of the model to the parameters and on the flow process being observed. We observed that the contribution of the retention parameters to uncertainty increases during drainage processes; the opposite occurs with the hydraulic conductivity parameters.     

二维平流扩散模型下的集合卡尔曼滤波模拟同化研究

为提高环境数值预报水平,构建了一个针对污染物扩散的模拟数据同化系统。采用集合卡尔曼滤波方法对二维平流扩散模型的状态变量进行了实时校正,实现污染物浓度的实时模拟预报,完成了敏感性实验中集合数目变化、观测方差变化和同化窗口长度变化研究。比较考察观测点位置与污染源距离不同时的预报效果,探讨了优化条件下的同化策略,提出一种根据距离远近动态调节卡尔曼增益权重的方法。在集合数目较小时,可降低计算代价,得到优化的同化效果。     

脉冲袋式除尘器过滤风速的确定

过滤风速的选择是设计布袋除尘器的关键。本文在对工程应用中的脉冲袋式除尘器相关参数测定后,采用数学拟合法,得出了过滤风速与烟粉尘粒径的对数成正比、与废气含尘浓度和废气温度成反比的数学关系,并建立了具体的数学模型。     

Estimating marine biogeochemical rates of the carbonate pH system—A Kalman filter tested

Oxygen (O₂), nitrate (NO₃), dissolved inorganic carbon (DIC) or pCO₂, and pH or total alkalinity (TA), are useful indices of marine chemical, physical and biological processes operating on varying time-scales. Although these properties are increasingly being monitored at high frequency, they have not been extensively used for studying ecosystem dynamics. We test whether we can estimate time-evolving biogeochemical rates (e.g. primary production, respiration, calcification and carbonate dissolution, and nitrification) from synthetic high frequency time-series of O₂, NO₃, DIC, pCO₂, TA or pH. More specifically, a Kalman filter has been implemented in a very simplified biogeochemical model describing the dynamics of O₂, NO₃, DIC and TA and linking the concentration data to biogeochemical fluxes. Different sets of concentration data are assimilated and biogeochemical rates are estimated. The frequency of assimilation required to get acceptable results is investigated and is compared with the frequency of sampling in the field or in controlled experimental settings.Smoothing of the data to remove data noise before assimilation improves the estimation of the biogeochemical rates. The best estimated rates are obtained when assimilating O₂, NO₃ and TA although the assimilation of DIC instead of TA also gives satisfactory results. In case pH or pCO₂ is assimilated rather than DIC or TA, the linearization of the (now nonlinear) observation equation introduces perturbations and the Kalman filter behaves suboptimal. We conclude that, given the resolution of data required, the tool has potential to estimate biogeochemical rates of the carbonate system under controlled settings.     

KALMAN FILTER CALCULATION OF SAMPLING FREQUENCY WHEN DETERMINING ANNUAL MEAN SOLUTE CONCENTRATIONS

ABSTRACT: A linear filter (Kalman filter) technique was used with a Streamflow-concentration model the minimize surface water quality sampling frequencies when determining annual mean solute concentrations with a predetermined allowable error. The Kalman filter technique used the stream discharge interval as a replacement for the more commonly used time interval. Using filter computations, the measurement error variance was minimized within the sample size constraints. The Kalman filter application proposed here is applicable only under several conditions including: monitoring is solely to estimate annual mean concentration; discharge measurement errors are negligible; the Streamflow-concentration model is valid; and monthly samples reflect the total variance of the solute in question.