颗粒物悬浮体系中聚合铝凝聚絮凝形态表征 (Ⅰ):Al-Feron法的应用研究

应用Ａｌ－Ｆｅｒｒｏｎ法于悬浮体系中聚合铝的形态分布表征，对其中的主要影响因素进行探讨，就不同碱化度聚合铝的形态分析进行实例研究．结果表明，混合方式对Ａｌ－Ｆｅｒｏｎ法的应用具有一定的影响作用．比色管混合测得Ａｌａ为２１．５４％，低于磁力搅拌方式结果（２４．５２％，２５．２２％，２５．０６％）．应用磁力搅拌方式可以获取较好的重复性与更多初期反应信息．颗粒物的存在对反应的影响主要取决于其浓度与粒度分布，成一定线性关系，可以从中加以扣除．在本实验范围内因其溶解所产生的影响可以忽略不计．对多个碱化度聚合铝的实例研究表明，Ａｌ－Ｆｅｒｏｎ法完全适用于颗粒物悬浮体系中的形态分布表征     

Study on the hydrolysis/precipitation behavior of Keggin Al13 and Al30 polymers in polyaluminum solutions

The hydrolysis/precipitation behaviors of Al³⁺, Al₁₃ and Al₃₀ under conditions typical for flocculation in water treatment were investigated by studying the particulates' size development, charge characteristics, chemical species and speciation transformation of coagulant hydrolysis precipitates. The optimal pH conditions for hydrolysis precipitates formation for AlCl₃, PAC_Al13 and PAC_Al30 were 6.5–7.5, 8.5–9.5, and 7.5–9.5, respectively. The precipitates' formation rate increased with the increase in dosage, and the relative rates were AlCl₃ ? PAC_Al30 > PAC_Al13. The precipitates' size increased when the dosage increased from 50 μM to 200 μM, but it decreased when the dosage increased to 800 μM. The Zeta potential of coagulant hydrolysis precipitates decreased with the increase in pH for the three coagulants. The iso-electric points of the freshly formed precipitates for AlCl₃, PAC_Al13 and PAC_Al30 were 7.3, 9.6 and 9.2, respectively. The Zeta potentials of AlCl₃ hydrolysis precipitates were lower than those of PAC_Al13 and PAC_Al30 when pH > 5.0. The Zeta potential of PAC_Al30 hydrolysis precipitates was higher than that of PAC_Al13 at the acidic side, but lower at the alkaline side. The dosage had no obvious effect on the Zeta potential of hydrolysis precipitates under fixed pH conditions. The increase in Zeta potential with the increase in dosage under uncontrolled pH conditions was due to the pH depression caused by coagulant addition. Al–Ferron research indicated that the hydrolysis precipitates of AlCl₃ were composed of amorphous Al(OH)₃ precipitates, but those of PAC_Al13 and PAC_Al30 were composed of aggregates of Al₁₃ and Al₃₀, respectively. Al³⁺ was the most un-stable species in coagulants, and its hydrolysis was remarkably influenced by solution pH. Al₁₃ and Al₃₀ species were very stable, and solution pH and aging had little effect on the chemical species of their hydrolysis products. The research method involving coagulant hydrolysis precipitates based on Al–Ferron reaction kinetics was studied in detail. The Al species classification based on complex reaction kinetic of hydrolysis precipitates and Ferron reagent was different from that measured in a conventional coagulant assay using the Al–Ferron method. The chemical composition of Al_a, Al_b and Al_c depended on coagulant and solution pH. The Al_b measured in the current case was different from Keggin Al₁₃, and the high Al_b content in the AlCl₃ hydrolysis precipitates could not used as testimony that most of the Al³⁺ was converted to highly charged Al₁₃ species during AlCl₃ coagulation.     

颗粒物悬浮体系中聚合铝凝聚絮凝形态表征 (Ⅰ):Al-Feron法的应用研究

应用Ａｌ－Ｆｅｒｒｏｎ法于悬浮体系中聚合铝的形态分布表征,对其中的主要影响因素进行探讨,就不同碱化度聚合铝的形态分析进行实例研究。结果表明,混合方式对Ａｌ－Ｆｅｒｒｏｎ法的应用具有一定的影响作用。比色管混合测得Ａｌａ为２１．５４％,低于磁力搅拌方式结果（２４．５２％,２５．２２％,２５．０６％）。应用磁力搅拌方式可以获取较好的重复性与更多初期反应信息。颗粒物的存在对反应的影响主要取决于其浓度与粒度     

Ferron逐时络合比色法研究TEOS－PAC中AI的形态

以TEOS为原料,将其与AlCl_3溶液混合后再缓慢滴加Na0H溶液,合成出具有不同Si/Al比和B值的复合絮凝剂样品TEOS-PAC。用Ferron逐时络合比色法对其Al形态分布及转化特征进行了研究,并与以硅酸钠(Na_2SiO_3·9H_2O)为原料相同条件下制备的样品作了比较,初步得出了Si/Al比和β值对TEOS-PAC复合絮凝剂中Al形态的影响规律。     

工业聚合氯化铝的形态分布及混凝效果

对铝浓度为2.50mol·l-1的聚合氯化铝.采用Al-Ferron络合比色法和烧杯混凝实验对样品的形态分布和混凝性能进行了研究.结果表明:三个工业系列样品中Al的形态分布规律基本一致,Ala随盐基度的升高而逐渐降低;Alc随盐基度的升高而升高;Alb则先随盐基度的升高而升高,达到最大值后,再随盐基度的升高而降低.同一系列样品在相同加药条件下,盐基度愈高,混凝效果愈好,Alb含量愈高,混凝效果并不一定愈好.因此,提高Alb不一定能提高混凝效果,工业产品的质量控制以及追求目标应当是尽量提高盐基度,而不是Alb的含量.     

镉的激光时间分辨荧光测定

本文报道了以７－碘－８－羟基喹啉－５－磺酸（Ｆｅｒｏｎ）作荧光增强剂测定镉的激光时间分辨荧光分析方法。在１．５～１０００ｎｇ／ｍｌ的范围内,镉浓度和荧光强度呈良好的线性关系（γ＞０．９９９）,方法的检出限为１．５ｎｇ／ｍｌ。可用于水中镉的测定,也可用于其它环境样品的测定。     

聚合氯化铝与有机高分子复合絮凝剂的形态分布研究--Al-Ferron和27Al-NMR相结合

主要研究了Al Ferron逐时络合比色法和2 7Al NMR法应用于聚合铝与有机高分子复合絮凝剂形态分布的测定 .结果表明 ,两种方法分别测定的Alb 和Al13 的结果具有一定的相关性 ;聚合铝与有机高分子复合后其形态分布发生了一定的变化 ,Alb(或Al13 )的含量有所降低 ,但仍是优势形态 ,Ala(或Al单)的含量基本保持不变 .     

聚合硅酸铝铁絮凝剂中铁的形态分布与转化

以AlCl₃·6H₂O ,FeCl₃·6H₂O ,Na₂CO₃,盐酸和硅酸钠为原料制备了不同碱化度B及不同n(Al)∶n(Fe)∶n(Si)摩尔比的系列聚合硅酸铝铁絮凝剂 (PAFSC) ,采用Fe -Ferron逐时络合比色法研究了PAFSC中铁的形态分布情况 ,考察了熟化时间、制备工艺及n(Al)∶n(Fe)∶n(Si)对PAFSC中铁的形态分布的影响情况。研究结果表明 :随着熟化时间的延长 ,铁和聚硅酸摩尔数的增加 ,PAFSC中铁的形态由低聚物向高聚物转化.      

Species analysis methods for hydrolysis polymerization of aluminum

ＳｐｅｃｉｅｓａｎａｌｙｓｉｓｍｅｔｈｏｄｓｆｏｒｈｙｄｒｏｌｙｓｉｓｐｏｌｙｍｅｒｉｚａｔｉｏｎｏｆａｌｕｍｉｎｕｍＦｅｎｇＬｉ，ＬｕａｎＺｈａｏｋｕｎ，ＴａｎｇＨｏｎｇｘｉａｏＲｅｓｅａｒｃｈＣｅｎｔｅｒｆｏｒＥｃｏＥｎｖｉｒｏｎｍｅｎｔａ...     

聚磷氯化铝铁溶液形态转化及电动特性

采用[Al+Fe]-Ferron逐时络合比色法研究了典型聚磷氯化铝铁溶液的形态转化,结果表明,聚磷氯化铝铁的形态转化主要由P(/Al+Fe)、OH(/Al+Fe)和nAl/nFe等因素决定,聚磷氯化铝铁的形态转化特征是优势形态之间的转变。通过对模拟悬浊水样的絮凝实验,对其除浊性能进行了考察,通过测定zeta电位对其水解物的电动特性进行了研究,结果表明,聚磷氯化铝铁水解聚合产物的电动特性与P(/Al+Fe)、OH(/Al+Fe)和nAl/nFe的变化密切相关,聚磷氯化铝铁是通过电中和、吸附架桥和沉淀网捕作用起混凝作用的,三种作用的综合能力越强,其混凝效果就越好。