螯合纤维的合成及其吸附重金属离子的研究

研究了含有胺肟基和胺腙基功能纤维的合成、结构表征和螯合性能。新型合纤维对多种重金属离子具有良好的吸附性能，能从被污染的水体和土壤中去除重金属离子，经洗脱后可回收金属，螯合纤维能反复使用。     

袋式除尘器在立窑烟气除尘中的应用

对立窑烟尘排放特点与立窑除尘工艺中的问题及对策进行了讨论。分析了立窑烟尘排放特征,对几种常见的立窑除尘的设备和工艺进行了比较,指出袋式除尘器可成功地用于立窑烟气除尘。并且从滤料选择、清灰方式、烟温控制、灰斗的气密性等方面详细地完善了袋式除尘器在立窑烟气除尘中的应用。     

A2/O工艺处理氨纶废水的应用研究

介绍了采用厌氧-缺氧-接触氧化(即A2/O)组合工艺处理氨纶生产废水的流程和设计参数,通过近半年的调试数据,反应季节对A2/O组合工艺处理氨纶生产废水的影响和可行性。提出运行过程中需要控制的参数,提供设计和运行参考。     

改良型固定化Pseudomonas oleovorans DT4降解四氢呋喃的研究

成功构建出了新型的海藻酸钠-活性炭纤维复合固定化Pseudomonas oleovorans DT4来去除四氢呋喃,并优化了该复合固定化载体组分的含量,发现在海藻酸钠含量为3%,活性炭纤维含量为1.5%条件下,制备成细胞浓度为6×109g-1的协同固定化细胞在初始THF浓度为360 mg·L-1时的降解速率达到最大为24.0 mg·(L.h)-1,同时其机械强度也得到了显著的提升.此外与游离菌体相比,该固定化细胞在不同温度和pH条件下的降解速率表现得更加稳定,且去除效果均能稳定在80%以上.在改进的反应体系中,协同固定化小球高效降解THF的重复利用次数达到80批以上,显示出该载体良好的可行性.     

改性纤维球处理炼油废水的应用研究

通过用改性纤维球处理炼油废水的试验,对纤维球过滤技术的处理效果和反冲洗特性进行了详细的研究,试验结果表明,炼油废水经处理后,出水中油的含量小于4 mg/L、悬浮物含量小于6 mg/L,出水可达标排放,并且经过改性后的纤维球在含油废水处理中可以通过反冲洗再生并重复使用.     

An analysis of end-of-life terminology in the carbon fiber reinforced plastic industry

While many studies and reviews into the practices conducted by industry and academia to recycle and remanufacture carbon fibre-reinforced plastic (CFRP) exist, to date no investigation exists which regards the correctness of the use of the terms recycling and remanufacturing. As such, this paper seeks to analyse the CFRP reuse industry’s attempt to recycle and remanufacture manufacturing waste CFRP and end-of-life (EOL) CFRP with an emphasis on the terminology used to describe these practices. Firstly, this paper presents a justification of the importance of using EOL terminology correctly; outlining the benefits and problems associated with using the correct and incorrect terminology. This paper finds that in the case of CFRP remanufacturing, terminology is being applied incorrectly and in the case of CFRP recycling, particular care should be taken when applying the term recycled to CFRP or stating that CFRP has been recycled. Further, this paper proposes new terminology (in keeping with EU directives) which could be adopted by industry and academia working in this area. This paper also finds that in the case of remanufacture, CFRP is incapable of being remanufactured.     

静电布袋复合式除尘器及其应用

介绍了静电布袋复合式除尘器的结构、材料及除尘原理;布袋除尘器在不同工况下的除尘效率、附加脱硫率、阻力和排放浓度等参数的测试结果;利用布袋除尘器改造静电除尘器时的改造方案、运行中应注意的问题.     

Solvent design and inherent safety assessment of solvent alternatives for palm oil recovery

The concept of inherent safety is important in developing an inherently safer and user-friendly process. This paper discusses a new integrated approach of computer-aided product design and inherent safety assessment. Computer-aided Molecular Design (CAMD) approach was utilized in this work to identify potential alternative to n-hexane, the widely used industrial solvent in extracting residual palm oil from pressed palm fibre. The formulation of solvent mixtures was optimized to meet the targeted physical properties before being tested using the Soxhlet Extraction method. Inherent safety assessment to assess the solvent's flammability, toxicity, reactivity, and explosiveness was conducted on the new solvent mix, Mixture 1 (n-hexane + ethanol), Mixture 2 (n-hexane + acetone) and Mixture 3 (n-hexane + n-butanol). It was found that Mixture 1 and 3 are safer than n-hexane and able to extract more oil than n-hexane and Mixture 2. However, the utilization of the solvent is dependent on the end product from the residual palm oil.     

炭纤维载体固定床厌氧发酵启动运行效果实验

以开发高效率、抗冲击性能强的高浓度有机废水沼气发酵技术为目的,用传统的 UASB反应器作为对照,研究了以炭纤维为生物膜载体的固定床厌氧反应器的启动运行效果。反应器进口废水 COD 为 5 000 mg/L, 水力停留时间 (HRT) 由213 h 逐步缩短为35 h,进水有机容积负荷(OLR)由0.56 kg COD/ (m³·d)提到3.45 kg COD/(m³·d)。结果表明,固定床反应器厌氧发酵的效率比对照高,出水 pH 值也比对照稳定;运行到第 50 d 时,固定床厌氧反应器和对照的 COD去除率分别由第 7 d 的36.56%和33.58%上升到87.9%和62.6%;固定床厌氧反应器的容积比产气率最高为1.16 m³/(m³·d),累计产气量为415.59 L,而对照的容积比产气率最高值仅为0.31 m³ /(m³·d),累计产气量为 71.66 L,前者最高容积比产气率和累计产气量分别是后者的3.74倍和5.78倍。固定床厌氧反应器的启动速度、COD 去除率和产甲烷效率显著地高于对照反应器。     

Molecular composition of recycled organic wastes,as determined by solid-state 13C NMR and elemental analyses

Using solid state ¹³C NMR data and elemental composition in a molecular mixing model, we estimated the molecular components of the organic matter in 16 recycled organic (RO) wastes representative of the major materials generated in the Sydney basin area. Close correspondence was found between the measured NMR signal intensities and those predicted by the model for all RO wastes except for poultry manure char. Molecular nature of the organic matter differed widely between the RO wastes. As a proportion of organic C, carbohydrate C ranged from 0.07 to 0.63, protein C from <0.01 to 0.66, lignin C from <0.01 to 0.31, aliphatic C from 0.09 to 0.73, carbonyl C from 0.02 to 0.23, and char C from 0 to 0.45. This method is considered preferable to techniques involving imprecise extraction methods for RO wastes. Molecular composition data has great potential as a predictor of RO waste soil carbon and nutrient outcomes.