华北地区沙尘天气垂直气溶胶直接辐射强迫

利用CALIOP数据和SBDART（Santa Barbara DISORT Atmospheric Radiative Transfer）辐射传输模式研究了2013~2016年华北地区8d沙尘天气气溶胶及其直接辐射强迫垂直分布特征,分析了气溶胶垂直分布和光学特性对直接辐射强迫的影响.结果表明,气溶胶集中分布在地表及以上3km范围,其中纯净沙尘型和污染沙尘型气溶胶位于上层,污染大陆型气溶胶和烟雾位于下层.大气层顶、地表和大气层的日均气溶胶直接辐射强迫分别是-38.41~-88.44,-74.03~-225.86,9.06~137.42W/m².0~8km高度范围气溶胶直接辐射强迫是负值,且随着高度的增加绝对值逐渐减小.气溶胶垂直分布对大气层顶、地表和大气层的直接辐射强迫影响较小,但对直接辐射强迫垂直分布影响较大,由气溶胶廓线差异造成的同一高度层气溶胶直接辐射强迫最大差值能达到31.18W/m².气溶胶光学厚度和单次散射反照率对直接辐射强迫影响明显.消光能力相同时,吸收性气溶胶对短波太阳光的衰减作用大于散射性气溶胶,后向散射比例大的气溶胶大于后向散射比例小的气溶胶.     

多环芳烃的几种理化参数与LC_(50)的相关性研究

对多环芳烃(PAHS)4种理化参数(K;W、Sw。X Vv。)与 LCO的相关关系进行了研究,建立了 4种一元线性回归方程。结果表明,4种参数的相关系数分别为:0.刀66、08083、09488、0.9570,经r检验,后两种属高度显著相关.用所建立的一元线性回归方程对7种PAHS的LC。进行估算,估算值与实测值相比,平均相对误差分别为58.84％、32.23％、1761％、198％,用l和V＊.H对LClj进行估算的估算精度也较高。经比较,提出用(。估算P＊比对麦穗鱼＊CO的新方法。     

活性炭吸附与生物活性炭脱臭效果的比较研究

针对污水收集与处理系统中恶臭气体的组成与特性,比较分析不同情况下活性炭吸附与生物活性炭的脱臭效果。当干活性碳总处理气量达到1.3m~3/g时,出现穿透。将吸附饱和的活性炭填料塔转为生物滴滤反应器后,仍能较快的实现挂膜生长,达到满意的处理效果。直接运行的生物活性炭滴滤器对H_2S的处理效率在95％以上,并具有较强的恢复能力。H_2S平均出口浓度为0.052mg/m~3。循环液pH值与盐度在一定范围内对系统影响不大。     

中国煤矿工人体能负荷、疲劳与工伤事故

煤矿井下事故对矿工威胁很大，体力负荷过重而导致疲劳是引起事故不可忽视的原因。测定不同工种井下矿工的体能负荷情况，并根据ＦＩＸ疲劳指数的测定，分析矿工劳动负荷与工伤事故发生之间的关系。研究表明，在疲劳状态下事故发生的危险性增加；劳动负荷越重，疲劳越重相对的事故发生率也越高。减轻疲劳对预防事故发生与保证工作安全具有很重要的意义     

Greenhouse impacts of anthropogenic CH4 and N2O emissions in Finland

The Finnish anthropogenic CH₄ emissions in 1990 are estimated to be about 250 Gg, with an uncertainty range extending from 160 to 440 Gg. The most important sources are landfills and animal husbandry. The N₂O emissions, which come mainly from agriculture and the nitric acid industry are about 20 Gg in 1990 (uncertainty range 10–30 Gg). The development of the emissions to the year 2010 is reviewed in two scenarios: the base and the reduction scenarios.According to the base scenario, the Finnish CH₄ emissions will decrease in the near future. Emissions from landfills, energy production, and transportation will decrease because of already decided and partly realized volume and technical changes in these sectors. The average reduction potential of 50%, as assumed in the reduction scenario, is considered achievable.N₂O emissions, on the other hand, are expected to increase as emissions from energy production and transportation will grow due to an increasing use of fluidized bed boilers and catalytic converters in cars. The average reduction potential of 50%, as assumed in the reduction scenario, is optimistic.Anthropogenic CH₄ and N₂O emissions presently cause about 30% of the direct radiative forcing due to Finnish anthropogenic greenhouse gas emissions. This share would be even larger if the indirect impacts of CH₄ were included. The contribution of CH₄ can be controlled due to its relatively short atmospheric lifetime and due to the existing emission reduction potential. Nitrous oxide has a long atmospheric lifetime and its emission control possiblities are limited consequently, the greenhouse impact of N₂O seems to be increasing even if the emissions were limited somehow.     

Evaluation of a recycling process for printed circuit board by physical separation and heat treatment

Printed circuit boards (PCBs) from discarded personal computer (PC) and hard disk drive were crushed by explosion in water or mechanical comminution in order to disintegrate the attached parts. More parts were stripped from PCB of PC, composed of epoxy resin; than from PCB of household appliance, composed of phenol resin.In an attempt to raise the copper grade of PCB by removing other components, a carbonization treatment was investigated. The crushed PCB without surface-mounted parts was carbonized under a nitrogen atmosphere at 873–1073 K. After screening, the char was classified by size into oversized pieces, undersized pieces and powder. The copper foil and glass fiber pieces were liberated and collected in undersized fraction. The copper foil was liberated easily from glass fiber by stamping treatment.As one of the mounted parts, the multi-layered ceramic capacitors (MLCCs), which contain nickel, were carbonized at 873 K. The magnetic separation is carried out at a lower magnetic field strength of 0.1 T and then at 0.8 T. In the +0.5 mm size fraction the nickel grade in magnetic product was increased from 0.16% to 6.7% and the nickel recovery is 74%.The other useful mounted parts are tantalum capacitors. The tantalum capacitors were collected from mounted parts. The tantalum-sintered bodies were separated from molded resins by heat treatment at 723–773 K in air atmosphere and screening of 0.5 mm. Silica was removed and 70% of tantalum grade was obtained after more than 823 K heating and separation.Next, the evaluation of Cu recycling in PCB is estimated. Energy consumption of new process increased and the treatment cost becomes 3 times higher comparing the conventional process, while the environmental burden of new process decreased comparing conventional process.The nickel recovery process in fine ground particles increased energy and energy cost comparing those of the conventional process. However, the environmental burden decreased than the conventional one.The process for recovering tantalum used more heat for the treatment and therefore the energy consumption increased by 50%, when comparing with conventional process. However, the market price for tantalum is very large; the profit for tantalum recovery is added. Also the environmental burden decreased by the recycling of tantalum recovery. Therefore, the tantalum recovery is very important step in the PCB recycling. If there is no tantalum, the consumed energy and treatment cost increase in the new process, though the environmental burden decreases.     

染料废水处理技术现状与发展

介绍了染料废水的物理、化学和生物处理技术,分析了其去除原理和工艺优缺点,提出了未来染料废水处理技术的发展走向——高效、经济、适应性强、清洁性的废水处理技术。     

工业废水的处理方法探讨

为实现水资源的循环利用与国民经济的可持续发展,必须对工业废水进行处理。在过去的几十年中,工业废水的任意排放给水资源环境和人民的身体健康带来了巨大的危害,为了杜绝这种现象的再次出现,本文对工业废水的处理方法做了如下的探讨。     

铁路职工健康维护工作初探

从健康意识逐渐提高、健康知识不断增加、健康生活方式逐步建立及健康状况有所改善等方面阐述铁路实施健康行动计划后取得的成效,分析健康维护中存在的主要问题,即专业人员不足、服务方式较单一及高血压控制率有待提高,进而提出加强专业队伍建设、引进研发新设备、强化铁路健康教育及深化“四高”联防联控等进一步开展健康维护工作的建议。     

Part V—sorption of pharmaceuticals and personal care products

Background, aim, and scope  Pharmaceuticals and personal care products (PPCPs) including antibiotics, endocrine-disrupting chemicals, and veterinary pharmaceuticals are emerging pollutants, and their environmental risk was not emphasized until a decade ago. These compounds have been reported to cause adverse impacts on wildlife and human. However, compared to the studies on hydrophobic organic contaminants (HOCs) whose sorption characteristics is reviewed in Part IV of this review series, information on PPCPs is very limited. Thus, a summary of recent research progress on PPCP sorption in soils or sediments is necessary to clarify research requirements and directions. Main features  We reviewed the research progress on PPCP sorption in soils or sediments highlighting PPCP sorption different from that of HOCs. Special function of humic substances (HSs) on PPCP behavior is summarized according to several features of PPCP–soil or sediment interaction. In addition, we discussed the behavior of xenobiotic chemicals in a three-phase system (dissolved organic matter (DOM)–mineral–water). The complexity of three-phase systems was also discussed. Results  Nonideal sorption of PPCPs in soils or sediments is generally reported, and PPCP sorption behavior is relatively a more complicated process compared to HOC sorption, such as the contribution of inorganic fractions, fast degradation and metabolite sorption, and species-specific sorption mechanism. Thus, mechanistic studies are urgently needed for a better understanding of their environmental risk and for pollution control. Discussion  Recent research progress on nonideal sorption has not been incorporated into fate modeling of xenobiotic chemicals. A major reason is the complexity of the three-phase system. First of all, lack of knowledge in describing DOM fractionation after adsorption by mineral particles is one of the major restrictions for an accurate prediction of xenobiotic chemical behavior in the presence of DOM. Secondly, no explicit mathematical relationship between HS chemical–physical properties, and their sorption characteristics has been proposed. Last but not least, nonlinear interactions could exponentially increase the complexity and uncertainties of environmental fate models for xenobiotics. Discussion on proper simplification of fate modeling in the framework of nonlinear interactions is still unavailable. Conclusions  Although the methodologies and concepts for studying HOC environmental fate could be adopted for PPCP study, their differences should be highly understood. Prediction of PPCP environmental behavior needs to combine contributions from various fractions of soils or sediments and the sorption of their metabolites and different species. Recommendations and perspectives  More detailed studies on PPCP sorption in separated soil or sediment fractions are needed in order to propose a model predicting PPCP sorption in soils or sediments based on soil or sediment properties. The information on sorption of PPCP metabolites and species and the competition between them is still not enough to be incorporated into any predictive models.