ABR工艺预处理木薯酒糟废水的工程应用

木薯酒糟废水有机物浓度高、悬浮物含量大、pH呈酸性、可生化性能较差 ,通常直接采用固液分离—厌氧 (UASB)—好氧曝气生化法处理效果并不理想 ,而采用ABR工艺进行厌氧水解酸化预处理木薯酒糟废水迄今为止未见报道。经绵阳市酒厂废水治理工程证明 ,强化ABR预处理工序是保证后续处理措施能否正常运行的关键     

共生细菌SB1降解聚乙烯醇的研究Ⅱ．共生细菌SB1聚乙烯醇氧化酶的产生、纯

共生细菌ＳＢ１接种在０．３％聚乙烯醇培养堪中，３０℃摇床振荡培养或发酵罐通气培养时，ＰＶＡ氧化酶产生的高峰在４８ｈ或４０ｈ。离心收集的上清液采用４０％－５０％饱和度的硫酸铵分级沉淀ＤＥＡＤ－Ｓｅｐｈａｄｅｘ离子交换柱和Ｃｉｂａｃｒｏｎ蓝Ｓ－Ｓｅｐｈａｒｏｓｅ４Ｂ亲和柱层析等纯化步骤。ＰＶＡ氧化酶收得率３０％，比活力提高３０倍。     

含PVA印染废水的生化动力学研究及其应用

通过对含有聚乙烯醇(PVA)印染废水的生化降解动力学的研究,确定表征微生物生长繁殖、自身氧化等的动力学参数,以此作为生化处理工艺设计的重要依据,使之更符合废水的水质特点,从而提高处理效率;同时,通过掌握其处理过程的规律,为工艺管理、运行效果预测,提供比较明确的控制量。     

Starch, Poly(lactic acid), and Poly(vinyl alcohol) Blends

Research on biodegradable materials has been stimulated due to concern regarding the persistence of plastic wastes. Blending starch with poly(lactic acid) (PLA) is one of the most promising efforts because starch is an abundant and cheap biopolymer and PLA is biodegradable with good mechanical properties. Poly(vinyl alcohol) (PVOH) contains unhydrolytic residual groups of poly(vinyl acetate) and also has good compatibility with starch. It was added to a starch and PLA blend (50:50, w/w) to enhance compatibility and improve mechanical properties. PVOH (M_W 6,000) at 10%, 20%, 30%, 40%, 50% (by weight) based on the total weight of starch and PLA, and 30% PVOH at various molecular weights (M_W 6,000, 25,000, 78,000, and 125,000 dalton) were added to starch/PLA blends. PVOH interacted with starch. At proportions greater than 30%, PVOH form a continuous phase with starch. Tensile strength of the starch/PLA blends increased as PVOH concentration increased up to 40% and decreased as PVOH molecular weight increased. The increasing molecular weight of PVOH slightly affected water absorption, but increasing PVOH concentration to 40% or 50% increased water absorption. Effects of moisture content on the starch/PLA/PVOH blend also were explored. The blend containing gelatinized starch had higher tensile strength. However, gelatinized starch also resulted in increased water absorption.     

Starch- polyvinyl alcohol crosslinked film— performance and biodegradation

Starch-PVOH cast films were prepared with and without crosslinking agent (hexamethoxymethylmelamine) in the absence of plasticizer. Moisture absorption in films without crosslinking agent at a low relative humidity was similar to that of PVOH and increased as the relative humidity increased. Films with crosslinking agent showed moisture absorption linearly proportional to the relative humidity. Significant improvement in resistance to water disintegration for crosslinked starch-PVOH films was observed. While the tensile strength decreased with increased relative humidity, crosslinking significantly improved the tensile strength. Increased PVOH content improved elongation of films even when the relative humidity was 80% or higher. Biodegradation studies revealed that the degradation rate was negatively correlated with the PVOH content in films and crosslinking generated more converged degradation curves. Names are necessary to report factually on available data; however, the USDA neither guarantees nor warrants the standard of the product, and the use of the name by USDA implies no approval of the product to the exclusion of others that may also be suitable.     

Lightweight Concrete Containing an Alkaline Resistant Starch-Based Aquagel

Starch aquagel-based lightweight concrete has properties similar to those of other lightweight concrete products. However, starch aquagels are unstable in the strongly alkaline conditions typical of Portland Cement-based concrete and may interfere with the setting process. The effect of alkali treatments on the physical, mechanical, and functional properties of starch aquagels and aquagels from starch/polymer blends was investigated. Starch was blended at 100–115°C in a twin-screw extruder with five different polymers to determine whether the blends improved alkaline resistance. Polymer blends containing 5%, 15%, and 30% of the polymer hydrated and formed aquagels when equilibrated in water for 24 h. However, equilibrium moisture content was lower for the blends compared to the starch control. Aquagels equilibrated in 0.15 N NaOH swelled, lost compressive strength and had greater than 90% moisture. The blend of starch and 30% PVOH absorbed less moisture and was more resistant to alkaline dissolution in 1 N NaOH than the other blends tested making it a more suitable material for aquagel-based concrete. The moisture content of starch-based aquagels and mixing time were critical factors in determining setting times. The size of aquagel blends had a minor effect on density and compressive strength.     

Supercritical water oxidation of polyvinyl alcohol and desizing wastewater：Influence of NaOH on the organic decomposition

Polyvinyl alcohol is a refractory compound widely used in industry. Here we report supercritical water oxidation of polyvinyl alcohol solution and desizing wastewater with and without sodium hydroxide addition. However, it is difficult to implement complete degradation of organics even though polyvinyl alcohol can readily crack under supercritical water treatment. Sodium hydroxide had a significant catalytic effect during the supercritical water oxidation of polyvinyl alcohol. It appears that the OH ion participated in the C-C bond cleavage of polyvinyl alcohol molecules, the CO2-capture reaction and the neutralization of intermediate organic acids, promoting the overall reactions moving in the forward direction. Acetaldehyde was a typical intermediate product during reaction. For supercritical water oxidation of desizing wastewater, a high destruction rate (98.25%) based on total organic carbon was achieved. In addition, cases where initial wastewater was alkaline were favorable for supercritical water oxidation treatment, but salt precipitation and blockage issues arising during the process need to be taken into account seriously.     

有机胺脱硫工艺在高硫煤地区火电厂的应用分析

近年来,电力行业发展迅速,燃煤电厂大气污染物控制取得很大成就。在电力行业"十二五"规划中,对节能减排工作提出了更高的要求,其中二氧化硫的削减仍占主要地位。本文就高硫煤地区实施有机胺脱硫工艺进行探讨,论述其应用情况、工艺原理,与传统工艺相比的优势、特点及发展方向。     

气体脱硫胺液系统的清洁生产

分析了气体脱硫装置胺液系统污染物的主要来源和危害,通过采取清洁生产工艺、材质升级、在线净化复活、停工清扫塔器和新脱硫剂补充置换等措施,取得了较好的效果.     

Application of magnetic particles modified with amino groups to adsorb copper ions in aqueous solution

A magnetic adsorbent can be easily recovered from treated water by magnetic force,without requiring further downstream treatment.In this research,amine-functionalized silica magnetite has been synthesized using N-[3-(trimethoxysilyl)propyl]-ethylenediamine(TPED) as a surface modification agent.The synthesized magnetic amine adsorbents were used to adsorb copper ions in an aqueous solution in a batch system,and the maximum adsorption was found to occur at pH 5.5 ± 0.1.The adsorption equilibrium data fitted t...