Influence of floc dynamic protection layer on alleviating ultrafiltration membrane fouling induced by humic substances

Cake layer formation is inevitable over time for ultrafiltration (UF) membrane-based drinking water treatment. Although the cake layer is always considered to cause membrane fouling, it can also act as a “dynamic protection layer”, as it further adsorbs pollutants and dramatically reduces their chance of getting to the membrane surface. Here, the UF membrane fouling performance was investigated with pre-deposited loose flocs in the presence of humic acid (HA). The results showed that the floc dynamic protection layer played an important role in removing HA. The higher the solution pH, the more negative the floc charge, resulting in lower HA removal efficiency due to the electrostatic repulsion and large pore size of the floc layer. With decreasing solution pH, a positively charged floc dynamic protection layer was formed, and more HA molecules were adsorbed. The potential reasons were ascribed to the smaller floc size, greater positive charge, and higher roughness of the floc layer. However, similar membrane fouling performance was also observed for the negative and positive floc dynamic protection layers due to their strong looseness characteristics. In addition, the molecular weight (MW) distribution of HA also played an important role in UF membrane fouling behavior. For the small MW HA molecules, the chance of forming a loose cake layer was high with a negatively charged floc dynamic protection layer, while for the large MW HA molecules it was high with a positively charged floc dynamic protection layer. As a result, slight UF membrane fouling was induced.     

颗粒物分界层Mie散射激光雷达识别的sigmoid算法

基于成都市2013年6月~2015年5月期间由Mie散射激光雷达探测的大气消光系数廓线资料,发现混合层以上在颗粒物消光和分子消光之间一致存在一个S型的过渡区,利用sigmoid函数对此分布形态进行模拟,通过计算该函数上下曲率最大点所在的高度,据此提出了颗粒物分界层Mie散射激光雷达识别的sigmoid算法.针对该算法模拟效果的分析表明,颗粒物分界层过渡区附近大气消光系数理论廓线和实测廓线保持了高度的相关性,二者在春夏秋冬四季的相关系数（R）分别为0.9971±0.0052、0.9935±0.0167、0.9979±0.0038和0.9990±0.0021（均通过α=0.05的显著性检验）.基于sigmoid算法计算的颗粒物分界层过渡区与成都市温江站探空资料得到的逆温层之间存在很好的对应关系.     

7B04铝合金和30CrMnSiA钢短期腐蚀的电化学行为研究

目的研究7B04铝合金和30CrMnSiA合金钢试样的电化学性能。方法采用电化学实验、扫描电子显微镜(SEM)、腐蚀坑深度测试分别对7B04铝合金和30CrMnSiA合金钢试样在是否经过天然海水浸泡的情况下进行测试分析,得到微观腐蚀形貌和腐蚀坑深度以及试样表面不带锈和带锈时的电化学性能。结果随着Na Cl浓度增大,7B04铝合金和30CrMnSiA钢的自腐蚀电流变大,两者之间存在明显的电位差,接触后会发生电偶腐蚀。电偶电流与阴阳极面积比和Na Cl浓度有关,阴阳极面积比增大或Na Cl浓度升高均会导致电偶效应增强。经过海水短期浸泡后,7B04铝合金表面的锈层不仅没有起到抑制腐蚀的作用,反而使自腐蚀加重,但电偶效应确实有所减弱。结论沿海设备在使用过程中应竭力避免铝合金在锈层下工作。     

Application of CFD Methods for Modelling in Air Pollution Problems: Possibilities and Gaps

Different urban air pollution problems deal with complex structure of air flows and turbulence. For such problems the Computer Fluid Dynamics (CFD) methods become widely used. However, this approach despite a number of advantages has some problems. Experience of use of CFD tools for development of models and suggestions of their applications for a local scale air pollution over a complex terrain and stable stratification are discussed in this paper, including: Topography and complex geometry: choose of the co-ordinate system and computer grid; Turbulence closure for air pollution modelling: modified k- model for stable stratified ABL; Boundary conditions for vertical profiles of velocity for stable-stratified atmosphere; Effects of the radiation and thermal budget of inclined surfaces to dispersion of pollutants; Artificial sources of air dynamics and circulation.Some examples of CFD applications for air pollution modelling for a flat terrain, mountainous area, mining open cast and indoor ventilation are discussed. Modified k- model for stably-stratified ABL is suggested. Due to the isotropic character of the k- model a combination of it in vertical with the sub-grid turbulence closure in horizontal can be more suitable for ABL. An effective scheme of boundary conditions for velocity profiles, based on the developed similarity theory for stable-stratified ABL, is suggested. Alongside with the common studies of atmospheric dispersion, the CFD methods have also demonstrated a good potential for studying anthropogenic and artificial-ventilation sources of air dynamic and circulation in local-scale processes of air pollution.     

Mechanics Principle and Engineering Application of Split Layer and Bed Separation of Mining Overburden

<正>To control land surface subsidence caused the underground mineral exploitation and the catastrophic phenomena such as serious damage of buildings, waterbodies, cultivated lands, railways, bridges caused by land subsidence, bed separation grouting technology of overburden is put forward. To provide theoretical support for the technology, the characteristics and the mechanics mechanism of mining overburden from layer-split to formation of bed separation are studied. On the basis of elastic sheet board theory, calculation formula of rock sheet deflection is presented, and the mechanics criteria of the separation formation and the calculation formula of bed separation volume are set up. Finally, the applications and technics of bed separation grout technology of mining overburden to control land subsidence in china are introduced.     

重庆近11年大气混合层厚度研究

根据新闻颁国家标准ＧＢ／Ｔ１３２０１－９１的规定，计算了重庆地区近１１年大气混合厚度，分析结果表明，重庆地区大气混合层厚度有明显日变化和季节变化，大气稳定度是混合层厚度的主要决定因子。     

宿迁3次突发性空气重污染过程对比分析

利用空气质量资料、常规观测资料、NCEP1.0°×1.0°再分析资料，应用数理统计、天气学等方法对宿迁市3次突发性重污染天气进行对比分析.结果表明：①宿迁"突发"空气重污染时，AQI级别由前一日的一、二级至第2日转为五级以上，AQI值迅速上升.②3次空气重污染过程天气背景相似，高层为宽广平直的偏西气流，地面受高压控制，中低层风向和温度平流突然转变，且都有深厚的逆温层结；持续变化较小的气压梯度、较低风速、温度日较差及相对湿度的增大（150328过程（即2015年3月28日—4月1日污染过程）除外）为颗粒物浓度迅速增长提供了条件.③大气稳定度级别迅速变高和混合层高度迅速降低并维持，对污染物快速聚集有显著影响.④物理量诊断表明，污染发生前期上空为弱上升运动，随后迅速转为下沉运动，或气流下沉运动区域迅速扩大、升高，是空气质量迅速转差的重要动力因素.⑤内蒙古地区的沙尘远距离输送形成的污染，是造成150328过程与另外两次过程明显不同的主要原因.     

Insights into multidimensional transport flux from vertical observation and numerical simulation in two cities in North China

This study represents the first quantitative evaluation of pollution transport budget within the boundary layer of typical cities in the Beijing-Tianjin-Hebei (BTH) region from the perspective of horizontal and vertical exchanges and further discusses the impact of the atmospheric boundary layer (ABL)-free troposphere (FT) exchange on concentration of fine particulate matter (PM_2.5) within the ABL during heavy pollution. From the perspective of the transport flux balance relationship, differences in pollution transport characteristics between the two cities is mainly reflected in the ABL-FT exchange effect. The FT mainly flowed into the ABL in BJ, while in SJZ, the outflow from the ABL to the FT was more intense. Combined with an analysis of vertical wind profile distribution, BJ was found to be more susceptible to the influence of northwest cold high prevailing in winter, while sinking of strong cold air allowed the FT flowing into the ABL influence the vertical exchange over BJ. In addition, we selected a typical pollution event for targeted analysis to understand mechanistic details of the influence of ABL-FT exchange on the pollution event. These results showed that ABL-FT interaction played an important role in PM_2.5 concentration within the ABL during heavy pollution. Especially in the early stage of heavy pollution, FT transport contributed as much as 82.74% of PM_2.5 within the ABL. These findings are significant for improving our understanding of pollution transport characteristics within the boundary layer and the effect of ABL-FT exchange on air quality.     

过程工业安全仪表系统的等级评定

介绍了安全整体性要求级别、安全联锁系统评定的内容、安全联锁系统评定的程序以及确定安全仪表联锁系统等级的方法,并介绍了安全保护层分析在安全联锁系统评定中的应用.     

填埋场垃圾堆体平面压实工程试验研究

原生垃圾密度很小，为提高填埋垃圾堆体密实度、延长填埋场使用寿命，对填埋垃圾进行压实处理很重要。本文通过现场工程试验对影咱填埋垃圾堆体平面压实效果的主要因素进行了系统研究。实验结果表明：为取得最佳的垃圾堆体平面压实效果，最佳垃圾摊铺厚度在0.5m—0.7m之间，最佳机械行程次数为3次，增加碾压次数有利于提高垃圾堆体密实度，垃圾最佳含水率在30％——50％之间。