Review: recent advances in biogas purifying technologies

Biomethane production through biogas upgrading is a promising renewable energy for some industries which could be part of the equilibrium needed with fossil fuels consumption to achieve a sustainable society. This paper presents a comprehensive list of biogas upgrading technologies focused on carbon dioxide removal as well as recent advances reported by researcher with wide expertise in this topic. Additionally, an extensive costs–performance comparison among the technologies studied is discussed. Among the different alternatives, chemical scrubbing stood out to achieve high biomethane purities while cryogenic technologies proved to be effective against methane losses. Regarding the different costs, water scrubbing and membrane separation seem to be the most affordable techniques.     

可张孔曝气器曝气能耗试验研究

通过试验研究，总结出可张孔曝气阻力损失的影响因素，以优化产品的结构设计参数，降低产品在工程应用中的能耗，获取更好的经济效益。     

垃圾焚烧烟气中HCl与消石灰的反应机理研究

测试了两种消石灰与垃圾焚烧烟气中HCl的反应率,得出了消石灰的反应率与反应时间的反应曲线,分析了消石灰与HCl的反应机理及影响消石灰最终反应率的因素。试验结果表明,消石灰与HCl反应初期按灰层扩散控制进行,两种消石灰的最终反应率分别为16％和36％。     

Advanced molecular-fingerprinting analysis of dissolved organic sulfur by electrospray ionization-Fourier transform ion cyclotron resonance mass spectrometry using optimal spray solvent

Molecular level characterization of dissolved organic sulfur (DOS) by electrospray ionization-Fourier transform ion cyclotron resonance mass spectrometry (ESI-FTICR MS) is necessary for further understanding of the role of DOS in the environment. Here, ESI spray solvent, a key parameter for ion production during ESI process, was investigated for its effect on the molecular characterization of DOS by ESI-FTICR MS. 100% MeOH as spray solvent was found for the first time to remarkably enhance the ionization efficiency of the majority of CHOS-molecules in NOM, which facilitated a total of 1473 CHOS-molecular formulas with one sulfur atom to be detected. The number of CHOS-molecular formulas obtained using 100%MeOH as spray solvent increased notably over 740 in comparison with those using 50% MeOH aqueous solution (731) or 50% ACN aqueous solution (653). Moreover, due to the enhancement of ionization efficiency of DOS during ESI processes, the tandem mass spectra of the NOM CHOS-molecules could be easily obtained using 100% MeOH as spray solvent, which were hardly obtained using 50% MeOH aqueous solution as spray solvent. The results of the tandem mass spectra suggested the first discovery of organosulfates or sulfonic acids in Suwannee River NOM sample. A simple method based on 100% MeOH as ESI spray solvent for advanced molecular characterization of DOS by ESI-FTICR MS was proposed and applied, and the results revealed more molecular information of DOS in sea DOM samples.     

重金属离子对肺表面活性物质单层膜的影响

为了探究重金属对肺表面活性物质（PS）膜的影响,利用Langmuir–Wilhelmy膜天平,研究了不同种类和浓度的重金属离子与PS单层膜的相互作用.发现Cr³⁺、Cu²⁺、Hg²⁺、Pb²⁺、Cd²⁺、Ni²⁺6种重金属离子均使PS单层的π-A等温线G-LE相变阶段外扩,而Fe³⁺可诱导单层缩合.随后,选取Cd²⁺,Cu²⁺,Hg²⁺,Fe³⁺4种离子进一步探究了重金属浓度对PS单层膜表面活性的影响规律,进行了可压缩模量分析,并结合红外光谱（FTIR）和原子力显微镜（AFM）探究其作用机理,发现Cu²⁺,Fe³⁺和Hg²⁺均会以浓度依赖的方式与PS单层的极性头部发生络合作用,形成复合物,改变膜的稳定性;而Cd²⁺的影响明显弱于其他3种金属离子,但也能使得PS单层有序性增强.     

Ni2+对好氧颗粒污泥系统性能的影响

以城镇污水处理厂A²/O工艺的回流污泥作为接种污泥,在序批式反应器（SBR）中培养好氧颗粒污泥（AGS）,探究Ni²⁺对AGS系统的影响.结果表明：在25℃的条件下,50d左右培养出成熟的AGS,其形态多呈球状或椭球状,外表分布着少量丝状菌,颗粒污泥粒径主要在2~4mm,MLSS达6000mg/L,SVI维持在40~50mL/g.将Ni²⁺作用于培养出的成熟AGS,Ni²⁺在0~2mg/L的浓度范围内会提高AGS的稳定性,使MLSS上升,SVI降低;同时会促进AGS分泌胞外多聚物（EPS）,EPS组成成分中的蛋白质（PN）明显多于多糖（PS）;Ni²⁺对好氧颗粒污泥去除总氮（TN）的抑制程度要大于COD,最终COD去除率可维持在95%以上,TN去除率可维持在70%以上.     

一种硫离子响应杀菌材料的制备及应用研究

目的制备硫离子响应杀菌材料,研究它在不同浓度铜离子条件下的封装效果,以及在不同浓度硫离子条件下的释放行为。方法选择埃洛石纳米管为载体并用透射电镜进行表征、采用真空负载的方式,将甲硝唑和苯骈三氮唑(BTA)分步填充到埃洛石纳米管内部,使用紫外分光光度法测试不同浓度铜离子对纳米管中甲硝唑的封堵效果,以及材料在不同浓度硫离子条件下的释放情况。结果实验中通过调整铜离子浓度发现,铜离子浓度越大对甲硝唑的封堵效果越好,当铜离子浓度达到160 mmol/L时,对甲硝唑的封堵效果最好。杀菌材料在外界硫离子达到0.1mmol/L后,甲硝唑的释放浓度迅速提高,进一步提高硫离子浓度,释放情况改变不明显。结论铜离子浓度达到160 mmol/L时,材料的封装效果是最好的。材料能够对硫离子实现响应释放,且对应的临界浓度为0.1 mmol/L。     

鄂东鸭儿湖地区大气中有机氯农药特征及土-气交换

采用聚氨酯泡沫-被动采样法（PUF-PAS）采集鸭儿湖地区大气样,研究典型污染源地区大气中有机氯农药（OCPs）组成、来源及土-气交换现状。鸭儿湖地区大气中OCPs主要组成为艾氏剂（Aldrin）、滴滴涕（DDTs）、六六六（HCHs）、六氯苯（HCB）、甲氧滴滴涕（Methoxychlor）和a-硫丹（α-Endosulfan）,约占OCPs总量的84%。较高浓度Aldrin（平均浓度为161.25 pg/m³）广泛存在应引起高度重视。HCHs（平均浓度为89.64 pg/m³）和DDTs（平均浓度为92.29 pg/m³）普遍存在且含量高,污染程度比较明显。HCHs异构体中β-HCH高于α-HCH,远远高于γ-HCH和δ-HCH,说明HCHs经过长期降解已逐渐稳定下来;来源分析推测存在工业HCHs的使用或者受大气长距离传输影响。DDTs在各点位分布明显不同于HCHs,且各点位DDTs的六种组成均存在很大差别,可能由于点位地理位置以及农药使用情况导致;来源分析推测大气中DDTs主要来自历史残留。鸭儿湖地区OCPs土气交换研究表明,HCHs主要表现为从大气向土壤中沉降;DDTs在大多数点位源于土壤中历史残留的挥发,部分点位受到大气长距离传输影响。     

环境升温过程对常温固化环氧树脂热力学性能的影响

目的提高常温固化环氧树脂体系的高温使用性能。方法采用常温固化剂T31、中温固化剂IPDA以及高温固化剂DDM作为混合固化剂,对E-44型和AG-80型混合环氧树脂体系进行常温固化反应,并分析环境升温过程对固化物热力学性能的影响。通过DMA分析、热变形测量、固化度测试,分别评价室温固化环氧树脂在环境升温过程前后的玻璃化转变温度、热变形量及体系内部的固化反应程度变化,并通过吸水率测试和弯曲强度测试对玻璃纤维布增强常温固化环氧树脂基复合材料的耐湿热性能以及高温条件下的力学性能进行分析。结果环氧树脂常温固化物的tg为85.21℃,经1.5℃/min的平均升温速率加热至90℃之后,该环境升温过程使固化物的固化度增大至92%以上,tg增长为132.06℃的同时热变形温度增大。其复合材料耐湿热性能提高,且100℃时弯曲强度的保持率为65%,对于加热至120℃的环境升温过程,固化物的固化度接近96%,tg增长为144.45℃的同时热变形温度进一步提高,其复合材料耐湿热性能改善程度更加明显,且130℃时弯曲强度保持率仍接近60%。结论常温、中温、高温混合固化剂的合理复配有助于环氧树脂体系在环境升温变化的诱导条件下发生梯度式固化反应,使体系内部的交联固化程度迅速升至较高水平,可以有效提高其玻璃化转变温度,显著改善常温固化环氧树脂体系在高温条件下的热力学性能。     

Determination of organophosphorus pesticides and related compounds in water samples by membrane extraction and gas chromatography

A membrane extraction-gas chromatography method was developed fordetermination of organophosphorus pesticides and related compounds including methamidophos, DDVP, dimethoate, methyl parathion, parathion, thiophosphoric acid trimethyl ester, and thiophosphoramidic acid dimethyl ester in water samples. In thismethod, surface-modified acetic cellulose membranes were used to extract the target analytes in water samples, the extracted analytes were back-extracted into a small amount of methanol, andgas chromatography with pulsed flame photometric detector (GC-PFPD) was used to determine the concentrations of targetanalytes in the extracts. The recoveries obtained for thetarget analytes spiked into the water samples ranged from 66to 94%. The method detection limit for each target analyte was 0.05 g L^-1. The method developed in this study had shown the advantages of being cheap, simple, fast, and reliable. It had been used successfully to determine the concentrations of target analytes in river water samples.