单缸摩托车发动机中低速性能优化

目的 解决某单缸摩托车发动机台架测试时中低速扭矩线性度差的问题.方法 基于CFD数值分析方法,运用热力学仿真分析软件GT-Power对发动机进行建模和标定,然后对原方案发动机进行摸底分析,最后通过优化配气机构和进排气系统来实现改善中低速性能的目标.结果 优化后的发动机台架测试结果中,发动机中低速扭矩线性度改善,动力性和经济性及排放都达到项目预期目标,峰值功率达到16 kW(9500 r/min),峰值扭矩达到18.6 N·m(7000 r/min),最低比油耗为183 g/(kW·h),CO、THC、NOx排放量分别为840、83、54 mg/km.配气机构运动学动力学性能与可靠性提升,进排气凸轮丰满系数分别达到5.14、5.15.结论 原方案中低速扭矩线性度差的原因为此转速段充气效率较低.优化凸轮型线、空滤器、消声器、排气管道参数能更好地利用进排气管道谐振效应来提升发动机中低速动力性能.     

高原高寒地域中重型车辆进气预热起动辅助装置研究

目的解决高海拔地域中重型越野车辆的起动困难问题。方法从进气温度对车辆起动的影响因素入手,系统地研究几种典型进气预热型式的优缺点。针对中型和重型两台越野车的具体情况,设计选型集中加热的电阻型格栅式进气预热器。经设计计算和反复测试,确定两型加热器的尺寸和功率等主要参数和控制策略,计算分析与车载蓄电池的匹配关系。结果对两型进气预热器进行实车安装后,分别经过实验室试验和野外现场验证,在-30℃实验室常压环境和-27℃的高原环境条件下,两型车辆均能在3 min内顺利起动。结论在高原高寒地域,格栅式电阻进气预热器可有效解决-30℃以上温度范围的起动困难问题。该装置结构简单、安装方便、可靠性高,便于中重型车辆加装使用,为该类问题提供了有效的技术解决途径。     

胭脂红酸分光光度法测定废水中硼

用胭脂红酸分光光度法测定废水中的硼,着重进行了方法的条件和干扰试验。方法检测限为0.063mg/L,线性范围为0.21mg/L-1.25mg/L。5个实验室对5.00mg/L硼标准样品测得重复性相对标准差为3．4％,再次性相对标准差为3．6％;相对误差为－0．8％－1．4％,回收率在95．2％－104．6％之间。     

Factors affecting the quantitative uncertainty of the estimated short-term intake. Part I—Calculation methods

ABSTRACT

The calculation of the combined uncertainty of the international estimated short-term intake (IESTI) of ethephon residues in apples is shown as an example. The ethephon residues in apples were reported by the Joint FAO (Food and Agriculture Organization of the United Nations)/WHO (World Health Organization) Meeting on Pesticide Residues (JMPR). The apple consumption data were taken from the IESTI (international short-term intake) calculation template used by the JMPR. The IESTI was calculated with the currently used method (case 2a) and a proposed one recommended by the EFSA (European Food Safety Authority)/RIVM (Dutch National Institute for Public Health) Scientific Workshop co-sponsored by FAO and WHO. In this example, the ratio of IESTI_proposed/IESTI_current and their combined relative uncertainty are about 2.8, and 1.7, respectively. The larger IESTI and uncertainty obtained with the proposed equation are the consequence of calculation only with the large portion (LP) instead of its combination with unit mass, and the MRL instead of the highest residue (HR). The LP is the major contributor to the combined uncertainty. Both the calculated IESTI and its combined uncertainty depend on the actual food – pesticide residue combination, and should be calculated for each case.     

Advantages and risks of using steel slag in preparing composts from raw organic waste

It had been reported that iron and manganese oxides in steel slag enhanced the production of humic acid (HA) from low-molecular-weight compounds, such as phenolic acids, amino acids, and saccharides. In the present study, this function of steel slag was applied to the composting of raw organic wastes (ROWs). The degree of humification of HAs is an important factor in evaluating compost quality. Thus, HAs were extracted from the prepared composts and the humification parameters were determined, in terms of elemental compositions, acidic functional group contents, molecular weights, spectroscopic parameters from UV–vis absorption and ¹³C NMR spectra. The timing for adding steel slag affected the degree of humification of HAs in the composts. The weight average molecular weight of a HA when slag was added initially (29 kDa) was significantly higher than when slag was added after elevating the temperature of the compost pile (17–18 kDa). These results show that ROWs are decomposed to low-molecular-weight compounds after the pile temperature is elevated and the presence of slag enhances the polycondensation of these compounds to produce HAs with a higher degree of humification. Because the slag used in the present study contained several-tens ng g^?1 to several μg g^?1 of toxic elements (B, Cu, Cr, and Zn), leaching tests for these elements from the prepared composts were carried out. Levels for leaching boron from composts prepared by adding slag (0.2–0.4 mg L^?1) were obviously higher than the corresponding levels without slag (0.05 mg L^?1).     

Polychlorinated dibenzo-p-dioxins/furans and dioxin-like polychlorinated biphenyls in food and feed in the Lithuanian market

Foods and feeds were analyzed during the period of 2007–2014 employing validated and accredited methods based on gas chromatography–high-resolution mass spectrometry. Sampling has been carried out in-line with national monitoring programs as well as during import controls into Lithuania. Food samples such as eggs, milk, beef, pork, poultry, fats of plant and animal origin, fish, cod liver, and feed samples such as premixes, feeds of plant origin, compound feed, mineral feed, vegetable oil, and fish meals were analyzed. Most of the samples exhibited concentrations below maximum limits, except cod liver. Health impacts were assessed in respect to human daily intakes. Data between groups are compared.     

The health risk assessment of organochlorine pesticides in smoked fish products available in Szczecin,Poland

The aim of this study was to determine the concentration of organochlorine pesticides [HCH and isomers (α, β, γ), aldrin, dieldrin, endrin, heptachlor and heptachlor epoxide and DDT and its metabolites (op’-DDD, pp’-DDD, op’-DDT, pp’-DDE, pp’-DDT] in smoked fish. Analysis was made of 12 typical smoked fish products that are the most popular among customers from the city of Szczecin, Poland. Pesticide residues were found in all samples of smoked fish. The smoked sprat and cold-smoked Baltic salmon were the most contaminated smoked fish products in terms of chlorine pesticides. The sum of DDT metabolites ranged from 1.48 (smoked mackerel) to 35.53 ng/g wet weight (smoked sprat), with the lowest concentrations found for op’-DDT and the highest for pp’-DDE. The level of heptachlor epoxide isomer B was low and ranged from 0.06 ± 0.01 (smoked eel) to 0.27 ± 0.07 ng/g w.w. (smoked sprat). The content of heptachlor was 0.48–1.99 ng/g w.w. Concentration of endrin was higher compared to other pesticides, ranged from 1.50 (cold-smoked salmon fillet) to 16.84 ng/g w.w (hot-smoked warehou). The contamination of smoked products was significantly low and poses no risk to the health of consumers provided that they eat a diverse diet. The concentration of organochlorine pesticides in the analysed products was below the standards accepted in European countries.     

Nitrogen fertilizer improves boron phytoextraction by Brassica juncea grown in contaminated sediments and alleviates plant stress

In this study we evaluated the effect of different fertilizer treatments on Brassica plants grown on boron-contaminated sediments. Experiments were conducted in the laboratory and on the lysimeter scale. At laboratory scale (microcosm), five different fertilizers were tested for a 35-d period. On the lysimeter scale, nitrogen fertilization was tested at three different doses and plants were allowed to grow until the end of the vegetative phase (70 d). Results showed that nitrogen application had effectively increased plant biomass production, while B uptake was not affected. Total B phytoextracted increased three-fold when the highest nitrogen dose was applied. Phytotoxicity on Brassica was evaluated by biochemical parameters. In plants grown in unfertilized B-contaminated sediments, the activity of antioxidant enzymes superoxide dismutase (SOD), ascorbate peroxidase (APX) and pyrogallol peroxidase (PPX) increased, whereas catalase (CAT) decreased with respect to control plants. Addition of N progressively mitigated the alteration of enzymatic activity, thus suggesting that N can aid in alleviating B-induced oxidative stress. SOD activity was restored to control levels just at the lowest N treatment, whereas the CAT inhibition was partially restored only at the highest one. N application also lowered the B-induced increase in APX and PPX activities. Increased glutathione reductase activity indicated the need to restore the oxidative balance of glutathione. Data also suggest a role of glutathione and phytochelatins in B defense mechanisms. Results suggest that the nitrogen fertilizer was effective in improving B phytoextraction by increasing Brassica biomass and by alleviating B-induced oxidative stress.     

Pesticide residue dynamics in passion fruits: Comparing field trial and modelling results

We evaluated the exposure to pesticides from the consumption of passion fruits and subsequent human health risks by combining several methods: (i) experimental field studies including the determination of pesticide residues in/on passion fruits, (ii) dynamic plant uptake modelling, and (iii) human health risk assessment concepts. Eight commonly used pesticides were applied onto passion fruits cultivated in Colombia. Pesticide concentrations were measured periodically (between application and harvest) in whole fruits and fruit pulp. Measured concentrations were compared with predicted residues calculated with a dynamic and crop-specific pesticide uptake model, namely dynamiCROP. The model accounts for the time between pesticide application and harvest, the time between harvest and consumption, the amount of spray deposition on plant surfaces, uptake processes, dilution due to crop growth, degradation in plant components, and reduction due to food processing (peeling). Measured and modelled residues correspond well (r² = 0.88-0.99), with all predictions falling within the 90% confidence interval of the measured values. A mean error of 43% over all studied pesticides was observed between model estimates and measurements. The fraction of pesticide applied during cultivation that is eventually ingested by humans is on average 10⁻⁴-10⁻⁶, depending on the time period between application and ingestion and the processing step considered. Model calculations and intake fractions via fruit consumption based on experimental data corresponded well for all pesticides with a deviation of less than a factor of 2. Pesticide residues in fruits measured at recommended harvest dates were all below European Maximum Residue Limits (MRLs) and therefore do not indicate any violation of international regulatory thresholds.