母岩的风化剥蚀速率与土壤允许流失量的关系 --以长江三峡坝区风化花岗岩土壤为例

土壤允许流失量的确定是一个非常复杂而又必须解决的问题，它关系到水土保持措施的布设和土壤的可持续利用。然而，发育在不同母质上的土壤，其土壤的最大允许流失量差异很大，确定这一值的依据也各不相同。在岩成土壤地区，母岩风化剥蚀速率的大小直接影响土壤的发育。是确定土壤允许流失量、分析人类加速水土流失的重要依据之一。选长江三峡黄陵背斜段风化花岗岩土壤为研究对象，根据剥蚀沉积相关原理，通过恢复古地理环境及时代，计算出新生代以来本区花岗岩的平均风化剥蚀速率为16．97mm／ka．最大剥蚀速率为49．56。又根据区内太平溪流域的泥沙资料，算出了当地现代的剥蚀速率，多年平均为297．7mm／ka，最小值为31．5mm／ka，而水利部颁布的当地土壤允许流失量为200t／km^2,a，折合为76．9mm／ka，二者相差近1．5—4．5倍。基于此。提出了确定土壤允许流失量必须参考母岩风化剥蚀速率的新观点。     

Spatial cost efficiency in waste paper handling: the case of corrugated board in Sweden

This paper analyzes the spatial cost efficiency of the Swedish legislation regarding waste disposal handling. We focus on the case of corrugated board and recognize that the different counties in Sweden possess different economic prerequisites in terms of waste paper recovery and utilization potential. We employ data for six corrugated board mills and 20 counties and a non-linear programming model to identify the least cost strategy for reaching the politically specified recycling target of a 65% recovery rate for corrugated board. That is, the total costs of recovering a minimum of 65% in each county are calculated and compared with the case when the country as a whole recovers 65% of all old corrugated board is collected but there exist no uniform target for each county. The conclusion is that from an efficiency point of view the recovery efforts should be concentrated to the highly populated and urbanized counties, and not be uniformly divided throughout the country. In the base case, the results suggest that the cost efficient county-specific recovery rates should range from 51 to 72%.     

Acceleration of floc-water separation and floc reduction with magnetic nanoparticles during demulsification of complex waste cutting emulsions

Waste cutting emulsions are difficult to treat efficiently owing to their complex composition and stable emulsified structure. As an important treatment method for emulsions, chemical demulsification is faced with challenges such as low flocs–water separation rates and high sludge production. Hence, in this study, Fe₃O₄ magnetic nanoparticles (MNPs) were used to enhance chemical demulsification performance for treating waste cutting emulsions under a magnetic field. The addition of MNPs significantly decreased the time required to attain sludge–water separation and sludge compression equilibrium, from 210 to 20 min. In addition, the volume percentage of sludge produced at the equilibrium state was reduced from 45% to 10%. This excellent flocculation–separation performance was stable over a pH range of 3–11. The magnetization of the flocculants and oil droplets to form a flocculant–MNP–oil droplet composite, and the magnetic transfer of the composite were two key processes that enhanced the separation of cutting emulsions. Specifically, the interactions among MNPs, flocculants, and oil droplets were important in the magnetization process, which was controlled by the structures and properties of the three components. Under the magnetic field, the magnetized flocculant–MNP–oil droplet composites were considerably accelerated and separated from water, and the sludge was simultaneously compressed. Thus, this study expands the applicability of magnetic separation techniques in the treatment of complex waste cutting emulsions.     

低温等离子体协同催化降解废气污染物的研究进展

阐述了低温等离子体协同催化工艺流程与反应机理,探讨了反应温度、废气进口组分、废气中水蒸气含量、气体流速、气溶胶等因素对降解效果的影响。分析认为:一段式低温等离子体协同催化可改变低温等离子体特征及催化剂催化特性,但尚未解决尾气臭氧逃逸、副产物产生及放电稳定性等问题;两段式低温等离子体协同催化可提高污染物分子降解效率并减少尾气臭氧逃逸,但未能有效利用等离子体的能量,气体中的水蒸气、粉尘及反应过程中产生的气溶胶均能影响后置催化剂的催化性能;两段式低温等离子体协同催化已具备工程应用条件,还需配套高效预处理单元以降低废气中水蒸气、粉尘等对催化剂的影响。     

消泡剂硅油I在工业废水氨氮测定中的应用

对色泽较深，含杂质量较高的废水加硅油I以抑制测定中蒸馏产生的泡沫．结果表明，在250ml水样中加硅油IO．10～1．25ml，即可收到理想效果．硅油I性质稳定，不随水蒸汽蒸出，对测定无干扰．     

泰州市环境空气中挥发性有机物分布特征

于2018年4—9月对泰州市环境空气中挥发性有机物(VOCs)组分开展现场观测,结合观测数据分析该市大气中VOCs的时空分布特征。结果表明:观测期间泰州市环境空气中VOCs平均摩尔比为45.1 nmol/mol,其中含氧挥发性有机物占比为57.8%;受周边排放源和地理位置影响,下风向点位的VOCs测定值高于其他点位;VOCs月均最高值出现在6月,与臭氧月均最高值出现时间一致,7—9月气团出现老化,导致臭氧生成能力减弱;观测期间VOCs中甲苯/苯(T/B)比值范围为0.201 9～5.130 3,且大部分T/B比值2,说明溶剂、油气和液化石油气挥发等排放源对泰州市环境空气中VOCs的影响较为显著。     

大兴安岭西坡中生代火山岩形成机制

依据火山喷发特点、火山岩岩石组合及火山岩的同位素年代学证据,大兴安岭西坡地区发育的大量中生代火山岩可分为三个放回,自早而晚依次为：晚侏罗世的塔木兰沟族回、上库力旋回和早白垩世的伊列克得旋回。不同旋回火山岩具有不同的地质、地球化学特征。在岩浆起源、源区性质和演化过程等方面,不同族回火山岩既有相似之处,也存在明显差别。火山岩为深部作用和过程的产物,对其形成机制的研究,有助于理解本区中生代发生的剧烈的火山岩浆作用和成矿作用的构造背景及演化过程。     

贵阳地区基本地质环境和主要岩土工程问题综述

本文系笔者对贵阳地区主要地质环境和工程地质特点进行的初步总结,内容为贵阳地区主要岩土构成情况、分布范围及与之相应的岩土工程地质特点和主要的岩土工程地质问题的描述,旨在给同行提供宏观性的了解和方向性的参考。     

小型废电池填埋焚烧处置的健康风险分析

对废电池采取填埋、焚烧处置所引起的健康风险进行了分析，采用3种模型，分别研究了废电池随城市固体废物一起完全填埋处置，一起完全焚烧处置，一起部分填埋处置和部分焚烧处理时，可能引起的健康风险，由分析可知，镉镍电池焚烧过程将引起不可接受的致癌风险，填埋废电池也会引起重金属非致癌风险，提出在现阶段没有单独收集分类管理的条件下，对于小型废电池应采取填埋焚烧联合处置的办法，但应避免镉镍电池的焚烧，在建立了收集体系后，应该分类进行资源化和无害化管理。     

我国电子废弃物收集体系构想

解决中国电子废弃物问题,一是控制电子废弃物进入非正式循环利用者手中;二是把非正式循环利用系统纳入良好的电子废弃物管理系统,使之成为更有效和对环境友好的系统.因此,如何把千家万户废弃的电子废弃物有效收集起来,是关系到电子废弃物管理和循环利用的重要环节.在我国建立良好的电子废弃物收集体系,应以市场经济和目前我国“城乡二元经济“为基础,建立具有收集主体多元化、收集方式多样化,收集途径多渠道等特点的电子废弃物收集体系.