半干法钙基烟气脱硫技术

阐述了半干法脱硫机理和影响因素以及容易出现的问题及其解决方法。针对半干法脱硫剂利用率低、Ca／S高的问题，提出了几种提高脱硫剂利用率的技术。     

Pd/activated carbon sorbents for mid-temperature capture of mercury from coal-derived fuel gas

Higher concentrations of Hg can be emitted from coal pyrolysis or gasification than from coal combustion, especially elemental Hg. Highly efficient Hg removal technology from coal-derived fuel gas is thus of great importance. Based on the very excellent Hg removal ability of Pd and the high adsorption abilities of activated carbon（AC） for H2 S and Hg, a series of Pd/AC sorbents was prepared by using pore volume impregnation, and their performance in capturing Hg and H2 S from coal-derived fuel gas was investigated using a laboratory-scale fixed-bed reactor. The effects of loading amount, reaction temperature and reaction atmosphere on Hg removal from coal-derived fuel gas were studied. The sorbents were characterized by N2 adsorption, X-ray diffraction（XRD） and X-ray photoelectron spectroscopy（XPS）. The results indicated that the efficiency of Hg removal increased with the increasing of Pd loading amount, but the effective utilization rate of the active component Pd decreased significantly at the same time. High temperature had a negative influence on the Hg removal. The efficiency of Hg removal in the N2-H2S-H2-CO-Hg atmosphere（simulated coal gas） was higher than that in N2-H2S-Hg and N2-Hg atmospheres, which showed that H2 and CO, with their reducing capacity, could benefit promote the removal of Hg. The XPS results suggested that there were two different ways of capturing Hg over sorbents in N2-H2S-Hg and N2-Hg atmospheres.     

树脂基固态胺吸附剂室温下对低浓度CO2的吸附性能研究

以大孔甲基丙烯酸酯吸附树脂为载体,聚乙烯亚胺(PEI)为有机胺,采用液相浸渍法制备出固态胺吸附剂,并研究了其在室温下对低浓度CO2的吸附行为.同时,利用氮气吸附、热重分析和扫描电镜表征了材料的物理化学性质,并采用热重法和固定床吸附法考察了材料的CO2吸附性能.结果表明,大孔树脂担载50%PEI(质量分数)时吸附性能最佳,对纯CO2的最大吸附量为175 mg·g-1;CO2的吸附行为由扩散动力学与吸附热力学共同决定,低温有利于提高吸附容量;吸附剂对400 ppm~15%浓度的CO2都具有优异的动态吸附性能,其中对400 ppm CO2的吸附量达到86 mg·g-1,对15%CO2的吸附量达到150 mg·g-1;湿度对吸附起促进作用,相对湿度为10%时,对400 ppm CO2的吸附量提高至139mg·g-1;吸附剂具有优异的循环性能,具有直接空气捕集CO2的潜力.     

用于干式脱污的CaO蒸汽活化实验研究

利用小型活化转炉实验台对以CaO为主要成分的钙基脱污剂在300～650℃的温度范围内进行蒸汽活化处理,结合X射线衍射和压汞仪的分析结果,初步探讨了蒸汽活化的机理.研究表明,蒸汽活化温度在600℃以上时,脱污剂孔隙结构有显著的改善,比孔容积和比表面积有着显著的增加,微孔(＜100nm)的数量大量增加,而低温下蒸汽活化的效果不是十分明显;研究还发现高温下延长活化时间有利于改善脱污剂的孔隙结构.     

纳米氧化物对钙基材料在高温燃煤中除砷脱硫的促进机理研究

将纳米MgO、Al2O3和ZnO分别添加于CaCO3中制备出钙基纳米氧化物复合吸附剂,进行了燃煤过程中除砷脱硫的实验研究;对燃煤灰渣进行了比表面积及孔隙度分析、X-射线衍射分析和扫描电镜观察,探讨了纳米MgO对CaCO3除砷脱硫的促进机理。结果表明,添加了纳米MgO的复合吸附剂除砷脱硫性能最好,比单一的CaCO3除砷率和脱硫率分别高出了28．73％和37．21％,表现出同时除砷脱硫的良好性能;其促进机理是纳米MgO的加入改变了灰样的微观结构促进了气相间的流动使得灰渣孔隙明显扩大,提高了CaO与As2O3和SO2反应的能力;在除砷的反应中生成了新的物质Ca3Mg2（AsO4）2,在一定程度上抑制了除砷产物的分解。     

Treatment of tunnel wash waters – experiments with organic sorbent materials. Part II: Removal of toxic metals

In the first part of the article, the column and the bag experiments concerning removal of polycyclic aromatic hydrocarbons (PAHs) and nonpolar oil (NPO) from tunnel wash waters using organic sorbent materials have been described. This part presents the results of removal of toxic metals. The metals of concern (Al, As, Cd, Cr, Cu, Fe, Pb, Mo, Ni, and Zn) were selected based on the priority toxicant pollutants defined in surface water quality criteria. Concentrations of these metals in the collected effluent...     

固态合成粉煤灰类脱硫吸附剂的脱硫活性测试

固态合成的粉煤灰吸附剂的脱硫活性测试结果表明 ,30 0℃得到的无定形硅铝钠高效脱硫剂 (FA NSA)在 5 0 0℃的脱硫温度下 ,穿透和饱和硫容分别为 64 6mg·g- 1 和 1 34 0mg·g- 1 ;穿透和饱和效率分别为 46 3%和 96 2 % .     

Sorbents with high efficiency for CO2 capture based on amines-supported carbon for biogas upgrading

Sorbents for CO_2 capture have been prepared by wet impregnation of a commercial active carbon(Ketjen-black, Akzo Nobel) with two CO_2-philic compounds, polyethylenimine(PEI)and tetraethylenepentamine(TEPA), respectively. The effects of amine amount(from 10 to70 wt.%), CO_2 concentration in the feed, sorption temperature and gas hourly space velocity on the CO_2 capture performance have been investigated. The sorption capacity has been evaluated using the breakthrough method, with a fixed bed reactor equipped with on line gas chromatograph. The samples have been characterized by N_2 adsorption–desorption,scanning electron microscopy and energy dispersive X-ray(SEM/EDX). A promising CO_2 sorption capacity of 6.90 mmol/gsorbenthas been obtained with 70 wt.% of supported TEPA at 70℃ under a stream containing 80 vol% of CO_2. Sorption tests, carried out with simulated biogas compositions(CH_4/CO_2mixtures), have revealed an appreciable CO_2 separation selectivity; stable performance was maintained for 20 adsorption–desorption cycles.     

Natural and waste materials as metal sorbents in permeable reactive barriers (PRBs)

A range of waste products and natural materials including chitin, fly ash, clay soil, cocoa shell, calcified seaweed and the natural zeolite clinoptilolite were tested in batch experiments to assess their ability to remove metals from a synthetic groundwater containing 10 mg l^–1 Cu, Pb and Zn and 1 mg l^–1 Cd. All had the ability to remove more than 70% of the metals from solution with fly ash being the most efficient, then chitin, clinoptilolite, calcified seaweed, clay soil and cocoa shell. After consideration of geochemical and morphological properties, calcified seaweed and clinoptilolite were shown to have potential as barrier materials. Given current issues with regard to the longevity of zero-valent iron barriers alternative materials could be the key to the future adoption of this remediation technology.