废水中含磷表面活性剂的测定

应用非水电位滴定法测定了废水中各种烷基磷酸酯钾盐及其单、双酯盐。方法的变异系数分别为２．３％和７．８％（ｎ＝１２）。本法可有效地消除非离子表面活性剂的干扰，适用于化纤油剂的质量检验和上油槽中油剂浓度的测定。     

Test for the effects of three surfactants on the penetration ability of the calcium chloride and water glass solutions in dust

１ＩｎｔｒｏｄｕｃｔｉｏｎＣａｌｃｉｕｍｃｈｌｏｒｉｄｅｉｓｏｆｔｅｎｕｓｅｄｉｎｔｈｅｆｉｅｌｄｏｆｓｏｉｌｓｔａｂｉｌｉｚａｔｉｏｎａｎｄｒａｉｓｉｎｇｄｕｓｔｃｏｎｔｒｏｌｂｅｃａｕｓｅｉｔｃａｎｒｅａｃｔｗｉｔｈｗａｔｅｒｇｌａｓ（Ｗｕ，１９...     

无机高分子絮凝剂的开发与应用进展

主要介绍了各种离子型和复合型无机高分子絮凝剂的种类、原料来源、合成工艺应用情况及其絮凝机理，对无机高分子絮凝剂的发展提出了几点建议。     

Water solubility enhancements of pyrene by single and mixed surfactant solutions

ＩｎｔｒｏｄｕｃｔｉｏｎＳｕｒｆａｃｔａｎｔｓｅｎｈａｎｃｅｔｈｅｒｅｍｅｄｉａｔｉｏｎｏｆＮＡＰＬ ｃｏｎｔａｍｉｎａｔｅｄｓｉｔｅｓｂｙｉｎｃｒｅａｓｉｎｇｔｈｅａｑｕｅｏｕｓ ｐｈａｓｅｃｏｎｃｅｎｔｒａｔｉｏｎｏｆｔｈｅＮＡＰＬｖｉａｍｉｃｅｌｌｅｆｏｒｍａｔｉｏｎ ,ｍｉｃｒｏｅｍｕｌｓｉｆｉｃａｔｉｏｎ ,ｏｒｍｏｂｉｌｉｚｉｎｇｔｈｅＮＡＰＬｐｈａｓｅ (Ｋｉｌｅ ,1989;Ｅｄｗａｒｄｓ,1991;Ｇｕｈａ ,1998ａ ;Ｋｏ ,1998;Ｚｉｍｍｅｒｍａｎ ,1999;Ｂｅｔｔａｈａｒ,1999;Ｗｉｌｌｓｏｎ ,1999;Ｐａ…     

电催化氧化法处理阳离子染料废水的试验研究

以结晶紫作为阳离子染料,采用电催化氧化法对阳离子染料溶液进行了电解脱色处理试验,研究了电流密度、电解质种类、电解质浓度、pH值等对该溶液脱色率的影响,测定了电解时溶液中生成的余氯浓度和溶液的紫外-可见吸收光谱曲线,并对不同电解时间的溶液的吸光度进行了归一化计算。结果表明:随着电解时间的延长,水溶液中活性氯浓度不断上升,经一定时间后达到最大值;在电催化和活性氯的协同作用下,阳离子染料结晶紫分子中的大π共轭体系被破坏、苯环结构基本瓦解,溶液快速脱色;在电流密度为5.1mA/cm2、NaCl浓度为4g/L、pH值为9.41的条件下,初始浓度为100mg/L的结晶紫溶液经过20min的电解,其脱色率可高达98.31%。     

非离子表面活性剂对污泥调理脱水效果的影响

现有污泥脱水技术仅使污泥含水率降到80%左右,难以满足日益严格的污泥处置要求.以污泥比阻（SRF）、脱水率为考察指标,比较了两大类非离子型表面活性剂（辛基酚聚氧乙烯醚OPEO型和烷基糖苷APG）对剩余污泥的脱水效果,并对原泥及调理后污泥进行了显微观察.结果表明,非离子表面活性剂可使污泥絮体粒径变小,不规则程度降低,改善了污泥的脱水性能,而且烷基糖苷APG脱水效果优于OPEO型.APG投加量为0.05%干固体时,污泥比阻即可降低到原泥的42%,脱水率可达到93%.以烷基糖苷APG为调理剂进行板框脱水实验,结果表明,当APG投加量为0.05%干固体时,脱水泥饼含水率比原泥脱水泥饼含水率低约10%,脱水率可达到97%.本研究为APG应用于污泥脱水,改善污泥脱水性能提供一些参考.     

Evaluation of reusing alum sludge for the coagulation of industrial wastewater containing mixed anionic surfactants

A coagulation-flocculation process is typically employed to treat the industrial wastewater generated by the consumer products industry manufacturing detergents, soaps, and others. The expenditure of chemicals including coagulants and chemicals for pH adjustment is costly for treating this wastewater. The objective of this study was to evaluate the feasibility of reusing the aluminum sulfate (alum) sludge as a coagulant or as a coagulation aid so that the fresh alum dosage can be minimized or the removal e ciency can be enhanced. The experiments were conducted in a jar-test apparatus simulating the coagulation-flocculation process for simultaneous removals of organic matters, anionic surfactants, suspended solids, and turbidity. At the optimum initial pH value of 10 and the fresh alum concentration of 400 mg/L, the total suspended solids (TSS), total chemical oxygen demand (TCOD), total anionic surfactants, and turbidity removal e ciencies were 71.5%, 76.4%, 95.4%, and 98.2%, respectively. The addition of alum sludge as a coagulant alone without any fresh alum addition could significantly remove the turbidity, TCOD, and anionic surfactants. The TSS was left in the supernatants after the settling period, but would subsequently be removed by adding the fresh alum. The TSS, TCOD, and turbidity removal e ciencies were also enhanced when both the alum sludge and the fresh alum were employed. The TCOD removal e ciency over 80% has been accomplished, which has never fulfilled by using the fresh alum alone. It is concluded that the alum sludge could be reused for the treatment of industrial wastewater generated by the consumer products industry.     

土壤阴离子表面活性剂总量亚甲基蓝法研究

文章通过设计正交试验,针对提取的主要因素提取液配比、提取时间、提取温度和提取剂用量确定最优的前处理方法,建立与国标《水质阴离子表面活性剂亚甲基蓝分光光度法》(GB7494-87)对应的土壤阴离子表而活性剂(LAS)的亚甲基蓝分光光度法.土壤样品烘干后经20 mL乙醇水溶液(70％)提取,水浴恒温振荡仪45℃下振荡2h,...     

亚甲蓝分光光度法测定水体阴离子表面活性剂方法的探讨

LAS是地表水和地下水水质的必测项目,国标（GB7494—87）方法操作复杂,要重复萃取四次后再洗涤,有机溶剂消耗量大,而且相当的耗时,本文通过同步实验对比与分析,得出：一次性加入20mL氯仿萃取加洗涤的方法其测定结果较好,而且极大地减轻了氯仿对分析人员身体的损害程度。测定结果有较好的精密度和准确度。本方法具有可观的经济性、安全性和可操作性。     

阳离子聚丙烯酸酯对污泥脱水性能的影响

以比阻(SRF)、过滤时间(TTF)和泥饼含水率作为评价污泥脱水性能的指标,考察2种阳离子聚丙烯酸酯CPAL-1和CPAL-2对污泥脱水性能的影响,并与阳离子絮凝剂三氯化铁(FeCl3)、聚合氯化铝(PAC)、阳离子聚丙烯酰胺(CPAM)和阳离子表面活性剂十六烷基三甲基溴化铵(CTAB)的作用效果进行比较.还测定了Zeta电位(ZP)和滤液中胞外聚合物(EPS)含量的变化来探讨CPAL的作用机理.实验结果表明,经CPAL-1调理的污泥脱水效果优于CPAM、PAC和FeCl3,明显优于CPAL-2和CTAB.当CPAL-1的投加剂量为0.200 g/g干基时,SRF、TTF和泥饼含水率降至最低,依次为5.37 ×1011m/kg、70 s和75.73％.CPAL主要通过电中和、吸附架桥作用和溶出EPS等来改善污泥的沉降脱水性能.