Investigation on the relationship between the fine particle emission and crystallization characteristics of gypsum during wet flue gas desulfurization process

The relationship between the fine particles emitted after desulfurization and gypsum crystals in the desulfurization slurry was investigated, and the crystallization characteristics varying with the operation parameters and compositions of the desulfurization slurry were discussed. The results showed that the fine particles generated during the desulfurization process were closely related to the crystal characteristics in the desulfurization slurry by comparison of their morphology and elements. With the higher proportion of fine crystals in the desulfurization slurry, the number concentration of fine particles after desulfurization was increased and their particle sizes were smaller, indicating that the optimization of gypsum crystallization was beneficial for the reduction of the fine particle emission. The lower pH value and an optimal temperature of the desulfurization slurry were beneficial to restrain the generation of fine crystals in the desulfurization slurry. In addition, the higher concentrations of the Fe^3 + ions and the F⁻ ions in the desulfurization slurry both promoted the generation of fine crystals with corresponding change of the morphology and the effect of the Fe^3 + ions was more obvious. With the application of the desulfurization synergist additive, it was beneficial for the inhibition of fine crystals while the thinner crystals were generated.     

La3+掺杂对吸附相反应制备TiO2复合催化剂的结晶过程及弱紫外光下活性的影响

利用吸附相反应技术制备弱紫外光响应的高效催化剂,并通过XRD、XPS以及HRTEM探索了不同焙烧温度下La3+掺杂量对TiO2结晶过程的影响.结合弱紫外光下甲基橙的降解反应,深入研究催化剂结晶过程的变化对弱紫外光下催化剂活性的影响.结果表明,La3+掺杂会抑制TiO2的结晶过程.当焙烧温度或者掺杂量较低时,La3+不能进入TiO2的晶格结构但会轻微地抑制TiO2的结晶过程;未进入晶格结构的La3+存在会引入光生载流子的浅能级捕获中心,在弱光体系中极大提升了催化剂的活性.当La3+的掺杂量为0.05%(原子分数)时,经过900℃焙烧后催化剂降解能力最高,其活性超过商用P25的2倍多.在较高La3+掺杂量(超过0.20%)时,900℃焙烧后一定量La3+进入TiO2的晶格结构而大大抑制了TiO2结晶;这种强烈的抑制作用使得催化剂中存在大量无定形结构TiO2,无定形TiO2甚至多于700℃焙烧后的催化剂,反而大大抑制了弱光体系中催化剂活性.     

A pilot-scale study of cryolite precipitation from high fluoride-containing wastewater in a reaction-separation integrated reactor

Fluoride removal by traditional precipitation generates huge amounts of a water-rich sludge with low quality, which has no commercial or industrial value. The present study evaluated the feasibility of recovering fluoride as low water content cryolite from industrial fluoride-containing wastewater. A novel pilot-scale reaction-separation integrated reactor was designed. The results showed that the seed retention time in the reactor was prolonged to strengthen the induced crystallization process. The particle size of cryolite increased with increasing seed retention time, which decreased the water content. The recovery rate of cryolite was above 75% under an influent fluoride concentration of 3500 mg/L, a reaction temperature of 50℃, and an influent flow of 40 L/hr. The cryolite products that precipitated from the reactor were small in volume, large in particle size, low in water content, high in crystal purity, and recyclable.     

Identification of key factors governing chemistry in groundwater near the water course recharged by reclaimed water at Miyun County, Northern China

Reclaimed water was successfully used to recover the dry Chaobai River in Northern China, but groundwater may be polluted. To ensure groundwater protection, it is therefore critical to identify the governing factors of groundwater chemistry. Samples of reclaimed water, river and groundwater were collected monthly at Chaobai River from January to September in 2010. Fifteen water parameters were analyzed. Two kinds of reclaimed water were different in type (Na-Ca-Mg-Cl-HCO3 or Na-Ca-Cl-HCO3 ) and concentration of nitrogen. The ionic concentration and type in river were similar to reclaimed water. Some shallow wells near the river bed had the same type (Na-Ca-Mg-Cl-HCO3 ) and high concentration as reclaimed water, but others were consistent with the deep wells (Ca-Mg-HCO3 ). Using cluster analysis, the 9 months were divided into two periods (dry and wet seasons), and all samples were grouped into several spatial clusters, indicating different controlling mechanisms. Principal component analysis and conventional ionic plots showed that calcium, magnesium and bicarbonate were controlled by water-rock interaction in all deep and some shallow wells. This included the dissolution of calcite and carbonate weathering. Sodium, potassium, chloride and sulfate in river and some shallow wells recharged by river were governed by evaporation crystallization and mixing of reclaimed water. But groundwater chemistry was not controlled by precipitation. During the infiltration of reclaimed water, cation exchange took place between (sodium, potassium) and (calcium, magnesium). Nitrification and denitrification both happened in most shallow groundwater, but only denitrification in deep groundwater.     

诱导结晶磷回收技术处理低浓度含磷废水研究

诱导结晶技术是近年发展的新型废水处理技术。采用自设计的诱导结晶反应器,反应器形式与Phosnix相似,但结构相对简单,无Phosnix反应器的内外同心筒结构,并增加了过渡区。研究了HRT、[PO43-]、[Ca2+]/[PO43-]对诱导结晶处理低浓度含磷废水的影响规律,并以实验室双泥系统厌氧上清液为原水,考察了结晶反应器长期运行效果。研究表明,在一定范围增加HRT、[PO43-]或[Ca2+]/[PO43-]均可提高磷酸盐去除率,但超过一定数值后,再继续增加对提高磷酸盐去除效果的贡献很小,[PO43-]或[Ca2+]/[PO43-]过高还会导致均相结晶出现,使磷酸盐去除率下降;研究给出了一定条件下的最佳HRT、[PO43-]或[Ca2+]/[PO43-];运行效果试验表明,诱导结晶反应器在进水平均磷酸盐浓度仅为23.6 mg/L的情况下,磷酸盐的平均去除率仍可达到55.2%,该技术在处理低浓度含磷水方面较具应用前景。     

不同诱导条件对结晶产物形貌特征的影响

在流化床反应器中,以含铜废水为处理对象,重点考察了诱导条件改变对结晶系统运行效率及结晶产物形貌特征的影响。结果表明,进水200 mg/L,进药比([Cu2+]/[CO2-3])1∶1.2,p H为10.2的条件下,铜离子去除率可接近100%,诱导晶种表面平滑,诱导颗粒生长成致密杆状晶体结构,以碳酸盐为沉淀剂的诱导结晶系统依赖于体系的p H,高p H体系下发生的共结晶现象是影响系统运行的主要原因;随着进药摩尔比的增加,结晶产物由短杆状向球状转化,晶体机械强度显著降低大量破碎,影响出水水质;进药比1∶1.2,p H为11的条件下,含铜废水浓度为500 mg/L时,系统去除率可达95%以上,微晶产率低于5%。     

烟气脱硫溶液中硫酸根的去除

分别采用石灰乳化学沉淀法和低温结晶法去除烟气脱硫溶液中的SO42-。实验结果表明：在室温、CaO溶液质量分数25%的条件下,石灰乳化学沉淀法对SO42-的去除率仅为59.51%,且向溶液中引入了Ca2+,产生的硫酸钙固体废物难以再生利用;采用低温结晶法处理烟气脱硫溶液,在结晶温度7 ℃、结晶时间3 h、NaOH加入量34.8 g/L的条件下,SO42-的去除率为82.04%、滤液中的ρ（Na+）为3.88 g/L。在现场工业应用试验中,采用低温结晶法去除烟气脱硫溶液中的SO42-,平均SO42-的去除率可达70.00%以上,滤液中的ρ（Na+）小于15.00 g/L。该法可有效抑制烟气脱硫溶液中SO42-含量的增加。     

用煤矸石合成4A沸石分子筛处理氨氮废水

以煤矸石为原料,采用碱熔-水热法合成4A沸石分子筛。由于煤矸石中铝、硅主要以高岭土形式存在,其活化过程是合成4A沸石分子筛关键环节。为提高4A沸石分子筛钙离子的交换能力,增加对模拟废水氨氮的去除率,实验考察了碳酸钠与煤矸石质量比、活化温度、活化时间、晶化温度和晶化时间对4A沸石分子筛钙离子交换能力的影响,同时也考察了模拟废水的pH、4A沸石分子筛加入量及吸附时间对氨氮去除率的影响。结果表明,最佳工艺条件为,碳酸钠与煤矸石质量比为0.9、活化温度为800℃、活化时间1.5 h、晶化温度90℃和晶化时间3 h。合成4A沸石分子筛的钙离子交换能力为310 mg/g,在pH为6的100 mL模拟氨氮废水中加入6 g 4A沸石分子筛吸附40 min后,废水中氨氮的去除率达到86%。通过最佳工艺条件合成4A沸石分子筛,在处理氨氮废水方面具有一定的应用前景。     

Fenton试剂氧化法处理染料结晶废母液

采用Fenton试剂氧化法处理分散橙、分散紫和分散蓝3种染料结晶废母液。研究了H₂O₂加入量、n（H₂O₂）#x02236;n（Fe²⁺）和废母液pH对COD去除率或TOC去除率的影响。对TOC去除反应分段进行了动力学方程拟合,并探讨了反应机理。实验得到的分散橙、分散紫和分散蓝的废母液处理工艺条件：H₂O₂加入量分别为264.4,352.9,441.2mmol/L;n（H₂O₂）#x02236;n（Fe²⁺）分别为20,10,20;废母液pH=3。3种废母液在0~20min和20~120min两个阶段的反应与二级动力学拟合方程的相关性最好。3种废母液经Fenton试剂氧化处理后,部分有机物降解为小分子有机酸,部分有机物完全矿化。     

鸟粪石结晶法从废水中回收磷的研究进展

鸟粪石结晶法是一种能同时回收废水中磷源和氮源的处理方法。本文总结了鸟粪石晶体的生长机理、颗粒形成和生长的影响因素,并着重比较了能够形成鸟粪石的各种反应器的优缺点。此外,文章总结了采用鸟粪石结晶法处理实际废水的相关研究,并对其经济效益做了评估。最后对鸟粪石结晶技术未来的研究方向进行了展望,提出了国内鸟粪石结晶技术研究的必要性。