Hunting Increases Dispersal Limitation in the Tree Carapa procera, a Nontimber Forest Product

Abstract:  The sustainability of seed extraction from natural populations has been questioned recently. Increased recruitment failure under intense seed harvesting suggests that seed extraction intensifies source limitation. Nevertheless, areas where more seeds are collected tend to also have more intense hunting of seed-dispersing animals. We studied whether such hunting, by limiting disperser activity, could cause quantitative dispersal limitation, especially for large crops and for crops in years of high seed abundance. In each of four Carapa procera (Meliaceae) populations in French Guiana and Surinam, two with hunting and two without, we compared seed fate for individual trees varying in crop size in years of high and low population-level seed abundance. Carapa seeds are a nontimber forest product and depend on dispersal by scatter-hoarding rodents for survival and seedling establishment. Hunting negatively affected the proportion of seeds dispersed and caused greater numbers of seeds to germinate or be infested by moths below parent trees, where they would likely die. Hunting of seed-dispersing animals disproportionally affected large seed crops, but we found no additional effect of population-level seed abundance on dispersal rates. Consistently lower rates of seed dispersal, especially for large seed crops, may translate to lower levels of seedling recruitment under hunting. Our results therefore suggest that the subsistence hunting that usually accompanies seed collection is at the cost of seed dispersal and may contribute to recruitment failure of these nontimber forest products. Seed extraction from natural populations may affect seedling recruitment less if accompanied by measures adequately incorporating and protecting seed dispersers.     

联合改良剂对桉树吸收重金属的作用——以矿区土壤中Cd、Zn和Cu为例

通过5种矿区土壤的盆栽试验,研究了联合改良剂对桉树部分生理指标、根中Cd、Zn和Cu的含量、以及土壤中Cd、Zn和Cu的BCR提取形态的影响,探讨了其对矿区土壤还林的作用.结果表明,与对照相比,施用改良剂后桉树的生物量和叶绿素含量的增幅分别为-7.6%~158.8%和-0.7%~23.1%,丙二醛含量的降幅为2.6%~37.9%,其中部分处理的生物量和丙二醛含量的变化达到显著水平（P<0.05）;土壤中有效态Cd、Zn和Cu的含量分别下降12.5%~63.8%、1.6%~54.7%和16.2%~57.6%,桉树根中Cd、Zn和Cu的含量分别下降3.1%~56.6%、-1.5%~21.3%和9.3%~50.1%.土壤对桉树根中Cd、Zn和Cu的含量有显著影响（P<0.05）,改良剂的配比或施用量无显著影响（P>0.05）,但在5种矿区土壤中G3降低桉树根中Cu含量的效果优于G1和G2;在重金属含量最高的2种土壤中,G1降低桉树根中Cd和Zn含量的效果优于G2和G3.研究表明施用联合改良剂能降低桉树对重金属的吸收,有利于矿区土壤的还林.     

铝合金的实验室盐雾试验腐蚀行为图像特征提取

目的提取铝合金材料在盐雾箱试验中可以表征腐蚀程度的表面形貌图像特征量。方法首先,对采集于表面化学清洗过的试样原始图像进行图像增强等预处理,突出腐蚀部位;其次,基于数字图像处理的分形和小波分解方法提取出分形维数和小波能量特征值。结果与以质量损失量为基础的腐蚀深度特征值进行相关性对比,基于图像分析的特征提取法的准确度和精度比较高。结论该方法可以应用于对试样的腐蚀程度进行定性和定量分析,判断并预测试样的腐蚀速度。     

Determination of organophosphorus pesticides and related compounds in water samples by membrane extraction and gas chromatography

A membrane extraction-gas chromatography method was developed fordetermination of organophosphorus pesticides and related compounds including methamidophos, DDVP, dimethoate, methyl parathion, parathion, thiophosphoric acid trimethyl ester, and thiophosphoramidic acid dimethyl ester in water samples. In thismethod, surface-modified acetic cellulose membranes were used to extract the target analytes in water samples, the extracted analytes were back-extracted into a small amount of methanol, andgas chromatography with pulsed flame photometric detector (GC-PFPD) was used to determine the concentrations of targetanalytes in the extracts. The recoveries obtained for thetarget analytes spiked into the water samples ranged from 66to 94%. The method detection limit for each target analyte was 0.05 g L^-1. The method developed in this study had shown the advantages of being cheap, simple, fast, and reliable. It had been used successfully to determine the concentrations of target analytes in river water samples.     

a study of the temporal variability of atrazine in private well water. part ii: analysis of data

In 1988, the Iowa Department of Natural Resources, along withthe University of Iowa, conducted the Statewide Rural WellWater Survey, commonly known as SWRL. A total of 686private rural drinking water wells was selected by use of aprobability sample and tested for pesticides and nitrate. A subsetof these wells, the 10% repeat wells, were additionally sampledin October, 1990 and June, 1991. Starting in November, 1991,the University of Iowa, with sponsorship from the United StatesEnvironmental Protection Agency, revisited the 10% repeat wellsto begin a study of the temporal variability of atrazine and nitratein wells. Other wells, which had originally tested positive foratrazine in SWRL but were not in the 10% population, wereadded to the study population. Temporal sampling for a year-long period began in February of 1992 and concluded in Januaryof 1993. All wells were sampled monthly, a subset was sampledweekly, and a second subset was sampled for 14 day consecutiveperiods. Of the 67 wells in the 10% population tested monthly,7 (10.4%) tested positive for atrazine at least once during theyear, and 3 (4%) were positive each of the 12 months. Theaverage concentration in the 7 wells was 0.10 µg/L. Fornitrate, 15 (22%) wells in the 10% repeat population monthlysampling were above the Maximum Contaminant Level of 10 mg/L at least once. This paper, the second of two papers on thisstudy, describes the analysis of data from the survey. The firstpaper (Lorber et al., 1997) reviews the study design, theanalytical methodologies, and development of the data base.     

Fractionation of Cu, Pb and Zn in certified reference soils SRM 2710 and SRM 2711 using the optimized BCR sequential extraction procedure

Sequential extraction of metals from solid media is a common analytical tool used in environmental and exploration geochemistry. A number of procedures exist, but without harmonization and standardization, meaningful comparisons are tenuous without baseline data. A newly developed, standardized sequential extraction procedure (optimized BCR) was applied to two contaminated certified reference soils from Montana, US (SRM 2710 and SRM 2711) for Cu, Pb and Zn. Four operationally defined fractions were isolated, acid extractable, reducible, oxidizable, and residual (by aqua regia). Fraction-specific concentrations, percentages and recoveries for Cu, Pb and Zn were used to explore differences between the optimized BCR procedure and three other sequential extraction schemes with published data for SRM 2710 and 2711 (i.e. Tessier scheme, Geological Survey of Canada scheme and the original BCR scheme). Results indicate significant differences between the four schemes, even for schemes that are closely associated (i.e. the original and optimized BCR schemes). Order-of-magnitude fraction-specific concentration differences were observed, especially for Pb in the reducible fraction. Differences between schemes are worrisome because trends varied between metals, between fractions and between reference soils. These data reinforce the need for increased adoption of standardized sequential extraction procedures and further examination of different solid media.     

石油亚砜萃取巯基醋酸的研究

对石油亚砜(PSO)萃取巯基醋酸的条件和影响进行了实验研究,确定了石油亚砜通过氢键和巯基醋酸形成的萃合物的组成.为从废水中回收巯基醋酸以及石油硫醚的综合利用提供了依据.     

农村井水受病原微生物污染的可能性及对策

井水是我国农村地区主要的饮用水源。由于农村地区缺乏生活污水集中处理设施，大量的病原微生物进入环境中。并可能通过各种途径污染井水。世界卫生组织和国外的一些数据显示，饮水中的病原微生物严重地影响了人的健康。本文讨论了我国南方农村水井受病原微生物污染的可能性，井提出了相应的对策。     

正己烷萃取—此外分光光度法测定矿井水中微量油

在进行矿井水中油类分析时，用正己烷作为萃取剂，以工作曲线代替标准曲线，从而使油平均回收率增加到96％以上。并在正己烷用量、水样预处理等测试参数选择上做了条件试验。     

Studies on the use of power ultrasound in solid–liquid myrobalan extraction process

Focus on eco-friendly processing techniques makes vegetable tanning a viable option in leather processing and establishes the subsequent need for the more efficient methods of extraction in tannin manufacture. Application of ultrasound has been tried in the extraction of tannins from myrobalan nuts in order to improve the extraction efficiency, to perform the extraction under milder process conditions and to reduce the process time. The influence of process parameters such as ultrasonic output power, time and temperature has been studied. Scale-up trials and the use of ultrasound in pulse mode have also been attempted. The results show that a three- to fivefold improvement is possible with ultrasonic output from 20 to 100 W. Extraction efficiency has been calculated from the maximum extractable materials from myrobalan nuts. Extraction efficiency is found to be 90% for ultrasound, 100 W without external heating as compared to 77% for control process at 70 °C for 4 h. Therefore, ultrasound could be employed even dispensing with provision for temperature controls. The use of ultrasound in pulse mode offered 70% extraction efficiency of continuous mode. Scale-up trials indicate that there exists an optimum ultrasonic output power depending on the amount of nuts used, to achieve better extraction efficiency. The effectiveness of ultrasonically extracted tannin solution has also been tested in the tanning process for its applicability. The degree of tanning efficacy has been assessed by shrinkage temperature measurement. The results indicate that ultrasonically extracted tannin solution is suitable for tanning process. Therefore, application of ultrasound in tannin extract manufacture is a viable option with added advantages.