聚合物对反渗透处理水系统中碳酸钙垢的控制

结垢是反渗透水处理过程中经常遇到的问题，碳酸钙是最常见的垢型之一。介绍了碳酸钙垢的形成及危害，通过加入微量聚合物抑制其结垢，并采用电镜对膜表面碳酸钙垢进行了分析。实验表明添加上述聚合物能有效阻止碳酸钙垢生成。     

膜分离技术在水处理中的应用研究

介绍了膜分离技术及其特点，对膜分离技术进行了分类，同时阐述了渗透、电渗析、反渗透、超滤、微滤和纳滤这些常规膜分离技术的研究和应用情况，在此基础上介绍了近年来发展起来的液膜、气态膜、双极膜、膜萃取和膜蒸馏这些新型膜分离技术。提出了膜分离技术存在的一些问题、研究方向、展示了膜分离技术的应用前景。     

MBR＋纳滤＋反渗透工艺处理垃圾渗滤液实验研究

摘要：结合青岛市某生活垃圾处理场工程实例,介绍了MBR工艺处理垃圾渗滤液的工艺流程、原理等,分析了MBR工艺处理垃圾渗滤液的特点和优势。垃圾渗滤液经过MBR工艺处理,生化部分采用前置反硝化／硝化工艺,再经纳滤／反渗透等膜分离技术和其他方法处理,最终流出液水质可以达到《生活垃圾填埋场污染控制标准》（GB16889—2008）。     

Fouling distribution in forward osmosis membrane process

Fouling behavior along the length of membrane module was systematically investigated by performing simple modeling and lab-scale experiments of forward osmosis （FO） membrane process. The flux distribution model developed in this study showed a good agreement with experimental results, validating the robustness of the model. This model demonstrated, as expected, that the permeate flux decreased along the membrane channel due to decreasing osmotic pressure differential across the FO membrane. A series of fouling experiments were conducted under the draw and feed solutions at various recoveries simulated by the model. The simulated fouling experiments revealed that higher organic （alginate） fouling and thus more flux decline were observed at the last section of a membrane channel, as foulants in feed solution became more concentrated. Furthermore, the water flux in FO process declined more severely as the recovery increased due to more foulants transported to membrane surface with elevated solute concentrations at higher recovery, which created favorable solution environments for organic adsorption. The fouling reversibility also decreased at the last section of the membrane channel, suggesting that fouling distribution on FO membrane along the module should be carefully examined to improve overall cleaning efficiency. Lastly, it was found that such fouling distribution observed with co-current flow operation became less pronounced in counter- current flow operation of FO membrane process.     

反渗透在环境工程中的应用

阐述了反渗透膜的分离机理(氢键理论,优先吸附-毛细管流动模型,溶解-扩散模型,等),反渗透膜技术在环境工程(重金属废水,垃圾渗滤液和印染废水处理)中的应用,以及膜集成工艺处理废水的概况,并对反渗透膜技术的研究和发展方向进行了展望。     

反渗透技术在小便池废水回用中的试验研究

首先将自配模拟尿液稀释不同的倍数后进行反渗透处理,确定了适宜的操作压力和合理的稀释倍数,然后用实际的人体尿液进行验证试验,经反渗透处理后,BOD5去除率达到98.3%、氨氮去除率达到97.7%、电导率降低了96.1%,产水投碱和二氧化氯后可达到城市杂用水水质标准(GB/T18920-2002)的要求,回用作冲厕用水。最后指出了值得关注的研究方向,以期能为小便池废水的循环利用提供一定的参考。     

苦咸水淡化处理方法探讨

针对苦成水的淡化水处理方法,分别介绍了不同方法的原理、试用性和优缺点。通过对各种方法的对比,采用反渗透膜法对不同古盐量的苦成水进行脱盐淡化处理,具有较强的适应性。膜分离技术中的反渗透法是较其他方法更为合理、有效的苦咸水淡化技术。     

大港油田苦咸再生水反渗透工艺自动控制研究

分析了大港油田污水回用深度处理工程苦咸再生水反渗透工艺仪表配置及自动控制方式,介绍了苦咸再生水反渗透系统亟待解决的各类问题。着重论述了仪表设置、余氯控制、结垢污堵控制、微生物污堵控制的实际运行方式,探讨了苦咸再生水反渗透工艺的技术可行性和可靠性。     

Green energy generation by pressure retarded osmosis: State of the art and technical advancement—review

Pressure-retarded osmosis (PRO) is a method for converting salinity gradients to power by allowing water to flow through a semi-permeable membrane against an applied hydraulic pressure. PRO already has a long history, starting from the middle of the last century, and has rapidly improved in recent years. In this paper, we present a historical development of PRO since its inception: the development of this renewable energy process has gone through several stages, depending on technological developments, worldwide energy demands, and environmental concerns. The technological progress of the process is also studied, as well as its cost viability and environmental impact. Finally, some ideas to further develop the PRO process and mitigate its detrimental effects are discussed.     

反渗透处理稀土氨氮废水试验研究

根据稀土冶炼厂排放的碳铵沉淀洗涤废水的水质情况,采用NH4Cl和 NaCl模拟废水进行了反渗透可行性对比实验。模拟实验发现,在相同条件下反渗透对NaCl 较NH₄Cl 有着更高的去除率,而NH₄Cl 相对NaCl则有着更高的产水速率。实际废水试验结果表明,在恒定操作压力范围内回收率为65%的条件下,NH₄Cl浓度为2.85 g/L的碳铵沉淀洗涤废水经反渗透处理其NH₄Cl去除率为77.3%,可作为氨氮废水的预处理。对该废水处理成本进行了分析,得出其约为2.7元/m³,比相近浓度氨氮废水的氨吹脱处理成本节省约26%。