超深厌氧塘的技术特性

超深厌氧塘是一种稳定塘新工艺。与常规厌氧塘相比，具有ＢＯＤ５容积负荷大、占地面积小，受温度影响小的优点。探讨了它的工作机理，本研究确定了负荷、水深和去除率之间的定量关系以供实际应用。     

蔬菜样品的H_2SO_4-H_2O_2快速消化方法

本文报道了使用硫酸 -过氧化氢对蔬菜样品进行快速消化的方法。其消化时间比常规消化方法大为缩短。重金属元素镉、铬、铜、镍、锌含量测定的结果 ,与用常规消化方法 (硝酸 -高氯酸 )相吻合。     

Microwave digestion method in environmental analysis

Ｍｉｃｒｏｗａｖｅｄｉｇｅｓｔｉｏｎｍｅｔｈｏｄｉｎｅｎｖｉｒｏｎｍｅｎｔａｌａｎａｌｙｓｉｓ￥ＺｈａｎｇＹｕｅ（ＷａｄｓｗｏｒｔｈＣｅｎｔｒｅ，ＮｅｗＹｏｒｋＳｔａｔｅＤｅｐａｒｔｍｅｎｔｏｆＨｅａｌｔｈＳｃｈｏｏｌｏｆＰｕｂｌｉｃＨｅａｌｔｈ，Ｓ...     

厌氧升流式污泥层反应器内污泥颗粒化对固液分离效果的影响

厌氧升流式污泥层反应器在较高的COD容积负荷和水力负荷下稳定运行的关键是要有良好的固液分离,而固液分离的必要条件是污泥的沉降速度大于混合液在三相分离器的沉降区的最小断面上的向上流速。通过小型装置的试验表明,污泥的沉降速度与污泥的性状和浓度有关,使反应器内的污泥颗粒化能改善污泥沉降性、提高固液分离效果,使反应器能在相当高的COD容积负荷(20—30kgCOD/m~3·d)和水力负荷(0.8m~3/m~2·h)下稳定运行。本文叙述了厌氧升流式污泥层反应器内的污泥颗粒化过程,并简要地讨论了培养颗粒污泥的基本条件。     

Effect of Cross-Linking Waste Protein with Dialdehydes on Its Biodegradation Under Anaerobic Conditions

Most native polymers used in processing and application technologies are admittedly disposable from the environment in a biologic manner, but products possess low mechanical strength. One of the paths to increasing this attribute (if feasible) is their cross-linking, which may, however, affect their readiness to biodegradation. In the presented work this condition was observed on the example of waste protein (Hykol B) cross-linking by means of glutardialdehyde and glyoxal. Degree and course of cross-linking were determined through impedance spectroscopy. The objective of this work also was to obtain data for constructing a sensor capable of following the cross-linking course in real time, for potential industrial application of Hykol in continuous production. Impedance spectroscopy proved to be applicable even to this kind of material marked by considerable water content and exhibiting relatively high electric conductivity; so far it had been used only for materials of low conductivity. An aqueous environment inoculated with digested anaerobic sludge from a municipal wastewater treatment plant was selected for modeling anaerobic conditions. The relation was studied between cross-linking degree given by content of cross-linking agent (determined by impedance spectroscopy) and biodegradation degree under anaerobic conditions. It was confirmed that network density as given by quantity of added agent not only reduced breakdown degree but also slowed the course of the process. This fact is particularly obvious with cross-linking by means of glyoxal; network density is thus dependent on type of employed substance, which affect type and structure of created network. That not merely forms an obstacle during polymer swelling and dissolution but also prevents access of bacteria to source of metabolized organic carbon.     

短程硝化—厌氧氨氧化组合工艺在脱氮领域的研究进展

基于全程硝化反硝化的传统生物脱氮工艺在硝化过程中需要大量氧气供应,反硝化过程需要有机物作为碳源,存在能耗与药耗过大的问题.为了降低废水脱氮的成本,短程硝化(PN)—厌氧氨氧化(ANAMMOX)组合工艺(PNA工艺)得到了高速发展.综述了PNA工艺的影响因素,重点介绍了4种基于PN与ANAMMOX原理开发的衍生PNA工艺...     

炭纤维载体固定床厌氧发酵启动运行效果实验

以开发高效率、抗冲击性能强的高浓度有机废水沼气发酵技术为目的,用传统的 UASB反应器作为对照,研究了以炭纤维为生物膜载体的固定床厌氧反应器的启动运行效果。反应器进口废水 COD 为 5 000 mg/L, 水力停留时间 (HRT) 由213 h 逐步缩短为35 h,进水有机容积负荷(OLR)由0.56 kg COD/ (m³·d)提到3.45 kg COD/(m³·d)。结果表明,固定床反应器厌氧发酵的效率比对照高,出水 pH 值也比对照稳定;运行到第 50 d 时,固定床厌氧反应器和对照的 COD去除率分别由第 7 d 的36.56%和33.58%上升到87.9%和62.6%;固定床厌氧反应器的容积比产气率最高为1.16 m³/(m³·d),累计产气量为415.59 L,而对照的容积比产气率最高值仅为0.31 m³ /(m³·d),累计产气量为 71.66 L,前者最高容积比产气率和累计产气量分别是后者的3.74倍和5.78倍。固定床厌氧反应器的启动速度、COD 去除率和产甲烷效率显著地高于对照反应器。     

UASB反应器处理染料及印染废水的研究进展

综述了国内外UASB反应器处理染料及印染废水的研究概况.分析了UASB反应器处理废水存在的问题,并给出了相应的建议.展望了UASB反应器处理染料及印染废水的发展趋势,指出厌氧UASB-好氧法组合工艺是目前处理染料及印染废水的一种经济而有效的方法.     

无汞开管法快速测定工业废水中的COD

文章对化学需氧量的几种测定方法进行对比,研究了无汞开管法快速测定方法的实验条件与干扰因素,并与标准方法进行对照,总结出炼油废水应用无汞开管法监测COD的适用范围与注意事项,可供同类企业应用该方法时借鉴。     

强制性内循环快速启动IC厌氧反应器过程的研究

如何在短时间内快速启动厌氧反应器是厌氧处理工程中的关键。本文对IC厌氧反应器分别进行强制性内循环启动和常规启动实验。结果表明 ,强制性内循环启动的反应器充分利用了内循环缓冲 pH和抗冲击负荷的能力 ,创造良好的微生物生长环境 ,最终只用了 5 4天就完成整个启动 ,比常规方式启动缩短近一个月 ,是一种值得借鉴的启动方式