黄酒行业工业废水COD与BOD_5相关性研究

对黄酒厂各工序产生废水及各酒厂产生综合性废水及其处理后的排放水进行ＣＯＤ、ＢＯＤ５的测定，对两者的相关性进行研究，同时对两种回归方程作方差分析及相关系数的显著性检验．回归方程的建立对酒厂污染源监测分析、环境管理具有实际意义．     

BOD测定的仪器法与化学法关系初探

本文介绍了在实验室中运用压差式仪器法测定BOD值的优越性,并着重与相应的化学稀释法所测BOD值进行对照.通过计算机找出二者的相关关系,以便得到准确的BOD值进而推广利用BOD测定的新技术.     

长寿命BOD微生物传感器的研究

本研究将从淀粉厂活性污泥中分离筛选出的一种性能优良的腊状芽孢杆菌(Bacillus Cereus)用高分子等材料包埋制成薄膜,与氧电极组合成BOD传感器。经对其技术性能进行测试表明,间断使用寿命已达16个月以上;对BOD标准物质线性响应范围5—60mg/L;响应时间不大于8min;测定环境标样平均误差1％,变异系数5.1;与BOD_5经典法同步测定废水样品结果相关性良好。     

Abating whey organic load through ethanol and lactic acid production by kefir

Abstract

The extent to which selected ethanol and lactic acid production bioprocesses contribute to whey waste abatement was examined. Alcoholic fermentation of whey was carried out by kefir cells immobilized on grape stalks, delignified cellulosic materials, or brewer's spent grains. Lactic acid fermentation was also performed by free kefir cells with or without addition of brewer's spent grains as promoting material. Since whey fermentation rate is affected by the lactose uptake rate, ¹⁴C-labeled lactose was used to study the fermentation ability of kefir. The highest reductions in biochemical oxygen demand and chemical oxygen demand of whey, about 68% and 52%, respectively, were achieved by lactic acid fermentation in 6 h at 37 °C and pH 5.5, in the presence of 120 g brewer's spent grains. Additionally, at the same conditions, the highest ¹⁴C-labeled lactose uptake rate by kefir and consequently the highest alcoholic fermentation rate were also recorded. However, greater reductions in biochemical oxygen demand and chemical oxygen demand of whey are required prior to final disposal.     

如何提高压差法测定BOD_5标样考核合格率

针对压差法测定生化需氧量的技术特点,通过总结日常分析、标样考核取得的经验,提出了想要提高压差法测定BOD标样考核合格率应注意的问题。     

膨胀石墨污水净化处理研究

利用膨胀石墨强大的吸附能力来处理城市生活污水,结果发现用膨胀石墨处理污水的前8h,COD的去除率达43％;处理第5～9d将出现第二个高峰,COD的去除率达48％,分析原因可能是存在物理吸附和微生物絮凝两方面的作用。最后经过20d的处理,膨胀石墨对生活污水的COD和BOD总去除率分别达到86％、78．9％,且除臭能力也很显著。     

湿式空气氧化法处理TNT红水的影响因素

使用湿式空气氧化技术与生物技术联合处理TNT精制阶段所产生的红水,研究了湿式空气氧化过程中反应温度、反应时间、初始压强和pH值对流出物的COD值与流出物可生化性的影响规律。研究结果表明,随着反应温度和反应初始压强的升高、反应时间的延长、催化剂投加量的增加和反应pH值的降低,出水COD值均有所下降。在温度为300℃、初始压强为14MPa、反应时间为2h、pH值为5,3、铁盐催化剂添加量为2g的条件下,出水COD值为498mg／L,COD去除率可达到99．27％。在温度为300℃、初始压强为11MPa、反应时间为1h、pH值为3、添加1g铁盐催化剂的条件下：反应流出物的BOD5／COD值为0．301,此时可生化性已经得到很好改善。通过生物方法对反应流出物后续处理发现,湿式空气氧化技术处理TNT红水在反应温度300℃以上,反应流出物均可生物降解。     

微曝气Fenton氧化法处理模拟双酚A废水的效果及其生物验证

研究了微曝气Fenton氧化法关键工艺参数对模拟双酚A（BPA）废水处理效果的影响,并从活性污泥性质和污染物去除率两方面,采用膜生物反应器(membrane bioreactor, MBR)对微曝气Fenton氧化法的处理效果进行了实验验证,为实现BPA废水的生物处理奠定基础。结果表明,初始pH值、反应时间、H₂O₂/COD(质量浓度比)、H₂O₂/Fe²⁺ (摩尔浓度比)、反应温度及曝气量均对预处理效果有较大影响,在最佳条件下,COD去除率可达70%,BOD/COD值则由原废水的0.02提高到0.50以上。MBR处理上述出水的结果表明,经微曝气Fenton氧化处理BPA的废水,可较好地适应后续的生化处理。     

Toxicological characterization of the landfill leachate prior/after chemical and electrochemical treatment: A study on human and plant cells

In this research, toxicological safety of two newly developed methods for the treatment of landfill leachate from the Piškornica (Croatia) sanitary landfill was investigated. Chemical treatment procedure combined chemical precipitation with CaO followed by coagulation with ferric chloride and final adsorption by clinoptilolite. Electrochemical treatment approach included pretreatment with ozone followed by electrooxidation/electrocoagulation and final polishing by microwave irradiation. Cell viability of untreated/treated landfill leachate was examined using fluorescence microscopy. Cytotoxic effect of the original leachate was obtained for both exposure periods (4 and 24 h) while treated samples showed no cytotoxic effect even after prolonged exposure time. The potential DNA damage of the untreated/treated landfill leachate was evaluated by the comet assay and cytokinesis-block micronucleus (CBMN) assay using either human or plant cells. The original leachate exhibited significantly higher comet assay parameters compared to negative control after 24 h exposure. On the contrary, there was no significant difference between negative control and chemically/electrochemically treated leachate for any of the parameters tested. There was also no significant increase in either CBMN assay parameter compared to the negative control following the exposure of the lymphocytes to the chemically or electrochemically treated landfill leachate for both exposure periods while the original sample showed significantly higher number of micronuclei, nucleoplasmic bridges and nuclear buds for both exposure times. Results suggest that both methods are suitable for the treatment of such complex waste effluent due to high removal efficiency of all measured parameters and toxicological safety of the treated effluent.     

The removal of lignin and phenol from paper mill effluents by electrocoagulation

This study aims to investigate the treatment of paper mill effluents using electrocoagulation. Removal of lignin, phenol, chemical oxygen demand (COD) and biological oxygen demand (BOD) from paper mill effluents was investigated at various current intensities by using different electrodes (Al and Fe) and at various electrolysis times (1.0, 2.5, 5.0 and 7.5min). It was observed that the experiments carried out at 12V, an electrolysis time of 2min and a current intensity of 77.13mA were sufficient for the removal of these pollutants with each electrode. The removal capacities of the process using an Al electrode were 80% of lignin, 98% of phenol, 70% of BOD, and 75% of COD after 7.5min. Using an Fe electrode the removal capacities were 92%, 93%, 80% and 55%, respectively. In addition, it was found that removal of lignin, phenol, BOD and COD increased with increasing current intensity. In the experiments carried out at different current intensities, higher removal can be explained through a decrease in intra-resistance of solution and consequently an increase at the transfer speed of organic species to electrodes. It was also found that Al electrode performs higher efficiency than Fe electrode except for COD removal. However, the time required for removal of BOD was more than that of COD. The results suggest that electrocoagulation could be considered as an effective alternative to paper mill effluents treatment.