固定源可凝结颗粒物稀释采样器的设计

固定污染源烟气排放进入大气环境后稀释降温,气相中部分饱和蒸气压较低的组分转化为可凝结颗粒物,这部分颗粒物在固定源烟气颗粒物监测中通常被忽略.为评价固定源可凝结颗粒物的排放情况,本文设计开发并评测了一套稀释采样器.稀释采样器稀释比在10：1~40：1范围内,混合停留时间为5~10 s.实验室评测结果表明,稀释气颗粒物背景值低（（~0.1±0.08） 个·cm^-3）,稀释采样器气密性良好,烟气和稀释气能够均匀混合,颗粒物损失较少,细颗粒物 （PM_2.5）损失在5%以下.本稀释采样器能模拟烟气与环境空气混合降温过程,可用于固定源可凝结颗粒物的测量.     

Preliminary air pollution monitoring in San Miguel, Buenos Aires

Passive diffusion samplers were employed in San Miguel(Buenos Aires Metropolitan Area) for a preliminary airpollution monitoring. The highest loads were observedin downtown, compared with an urban background site.Total suspended particulate matter (TSPM) varied from0.257 to 0.033 mg cm^-2 month^-1; dust was examinedfor particle nature and size distribution. A similartrend was observed for nitrogen dioxide (NO₂) andTSPM spatial distribution, suggesting that traffic isthe major pollution source. Sulphur dioxide (SO₂)values were low and rather homogeneous. Levels for theinvestigated pollutants are below EPA's guide linevalues. Geographic (flat area, near to Rio de LaPlata) and climatologic factors (rainfalls andvariable wind directions) contribute to disperse pollutants.     

扩散法测定环境空气中的二氧化硫

介绍了利用自制分子扩散式个体采样器 ,监测环境空气中的二氧化硫的方法 ,该方法改 PRA光度法为离子色谱法 ,提高了方法的灵敏度。经实验室性能评价能够满足实验室测试的要求。并经有动力的溶液吸收管法现场对比测试 ,两种测试方法结果一致     

浅析被动采样器监测环境空气质量数据的可比性

对被动采样器与空气自动站监测环境空气质量进行了全年的对比实验,并对大量的监测数据进行了规范的处理分析。结果表明,被动采样器在环境条件持续稳定满足采样条件时,被动采样器与自动站监测结果无显著性差异;在环境条件不能持续稳定满足采样条件时,二者监测结果有显著性差异,但仍有较大的相关性。     

水和废水中含油水样的成套采集技术研究──一种新型适用的含油水样采样器

在查阅大量文献的基础上，分析总结了现有采样器的优缺点，并依据采集有代表性含油水样的理论要求，设计制作了一种独具特色而又科学适用的新型合油水样采样器。本采样器可用于采集含油水样和其它水样。     

被动采样监测珠江三角洲NOx、SO2和O3的空间分布特征

为获得珠江三角洲区域污染特征,采用被动扩散采样技术,在珠江三角洲200 km×200 km网格区域内测量11月两周暴露的NO2、SO2和O3浓度水平,采用克里格空间插值法(Kriging)获取NOx、SO2和O3的空间分布特征,并与源清单和已有模型结果比对.采用反向轨迹方法模拟了O3的输送途径.结果表明,采样期间珠江三...     

Field monitoring of volatile organic compounds using passive air samplers in an industrial city in Japan

Highly portable, sensitive, and selective passive air samplers were used to investigate ambient volatile organic compound (VOC) levels at multiple sampling sites in an industrial city, Fuji, Japan. We determined the spatial distributions of 27 species of VOCs in three campaigns: Mar (cold season), May (warm season), and Nov (mild season) of 2004. In all campaigns, toluene (geometric mean concentration, 14.0microg/m3) was the most abundant VOC, followed by acetaldehyde (4.76microg/m3), and formaldehyde (2.58microg/m3). The spatial distributions for certain VOCs showed characteristic patterns: high concentrations of benzene and formaldehyde were typically found along major roads, whereas high concentrations of toluene and tetrachloroethylene (PCE) were usually found near factories. The spatial distribution of PCE observed was extremely consistent with the diffusion pattern calculated from Pollutant Release and Transfer Register data and meteorological data, indicated that passive air samplers are useful for determining the sources and distributions of ambient VOCs.     

A directional passive air sampler for monitoring polycyclic aromatic hydrocarbons (PAHs) in air mass

A passive air sampler was developed for collecting polycyclic aromatic hydrocarbons (PAHs) in air mass from various directions. The airflow velocity within the sampler was assessed for its responses to ambient wind speed and direction. The sampler was examined for trapped particles, evaluated quantitatively for influence of airflow velocity and temperature on PAH uptake, examined for PAH uptake kinetics, calibrated against active sampling, and finally tested in the field. The airflow volume passing the sampler was linearly proportional to ambient wind speed and sensitive to wind direction. The uptake rate for an individual PAH was a function of airflow velocity, temperature and the octanol-air partitioning coefficient of the PAH. For all PAHs with more than two rings, the passive sampler operated in a linear uptake phase for three weeks. Different PAH concentrations were obtained in air masses from different directions in the field test.     

油漆挥发分爆炸特性及浓度检测装置设计研究

为了实现对喷涂车间内挥发分浓度的检测,进行20 L球形爆炸特性测试实验,分析了油漆挥发分主成分及爆炸特性,根据油漆挥发分受热易挥发遇冷易凝结的物理特性、采样器采样原理、滤膜增重法测量原理以及基于单机片C++软件程序编写的电路智能控制技术,设计1种喷涂车间挥发分浓度检测装置。研究结果表明:油漆挥发分主成分具有爆炸性,且随着油漆颗粒物浓度增大,爆炸压力也增加。设计的装置对挥发分的采集率都在90%以上,总采集率为93.1%~98.9%,装置能够较为准确地检测挥发分浓度。     

被动式采样器在大区域大气VOC监测中的应用

应用VOC被动式采样器监测了地中海东部塞浦路斯岛大气中挥发性有机化合物(volatile organic compounds,VOC)的浓度。通过岛上设置的80个VOC采样点对苯,甲苯,对、邻、间二甲苯(Benzene、Toluene、o-xylene、m,p-xylene,BTX)数次采样及分析结果表明,其被动采样器中BTX回收率>95%,BTX平行实验的相对标准偏差<6.28%,采样和分析方法准确。得到的污染物分布图较准确地反映了塞浦路斯岛实际污染情况。