Effects of SO2 and H2O on low-temperature NO conversion over F-V2O5-WO3/TiO2 catalysts

F-V_2 O_5-WO3/Ti02 catalysts were prepared by the impregnation method.As the content of F ions increased from 0.00 to 0.35 wt.%,the NO conversion of F-V_2 O_5-WO_3/TiO_2 catalysts initially increased and then decreased.The 0.2 F-V_2 O_5-WO_3/TiO_2 catalyst(0.2 wt.% F ion)exhibited the best denitration(De-NOx) performance,with more than 95% NO conversion in the temperature range 160-360℃,and 99.0% N2 selectivity between 110 and 280℃.The addition of an appropriate amount of F ions eroded the surface morphology of the catalyst and reduced its grain size,thus enhancing the NO conversion at low temperature as well as the sulfur and water resistance of the V_2 O_5-WO3/Ti02 catalyst.After selective catalytic reduction(SCR) reaction in a gas flow containing SO_2 and H_2 O,the number of NH3 adsorption sites,active component content,specific surface area and pore volume decreased to different degrees.Ammonium sulfate species deposited on the catalyst surface,which blocked part of the active sites and reduced the NO conversion performance of the catalyst.On-line thermal regeneration could not completely recover the catalyst activity,although it prolonged the cumulative life of the catalyst.In addition,a mechanism for the effects of S02 and H_2 O on catalyst NO conversion was proposed.     

非程序升温色谱法分析CO/CO2加氢反应混合物

在非程序升温单桩色谱仪上，采用双柱温法对ＣＯ／ＣＯ２加氢反应混合物进行在线分析，设置条件为３ｍ长的色谱柱ＧＤＸ－４０３，柱前压和检测温度固定不变，氢气为载气，ＴＣＤ为检测器，结果表明：在柱温３１３Ｋ，可以分析ＣＯ、ＣＨ４、ＣＯ２。在柱温３６８Ｋ，可以分析Ｈ２Ｏ和甲醇。通过计算反应前后２组物质浓度的变化，可以快速、准确评价催化剂的活性和选择性。     

On-line production of ferrate with an electrochemical method and its potential application for wastewater treatment – A review

A number of studies on the oxidation of various organic/inorganic contaminants by ferrate(VI) were reported in the 1980s and 1990s. The exploration of the use of ferrate(VI) for water and wastewater treatment has been well addressed recently. However, challenges have existed for the implementation of ferrate(VI) technology in practice due to the instability of a ferrate solution or high production cost of solid ferrate products. The research has been carried out aiming at the generation and application of ferrate(VI) in situ. This paper thus reviews ferrate chemistry and its overall performance as a water treatment chemical, discusses the factors affecting the ferrate yield efficiency using the electrochemical method, and finally, summarises the work on the production and use of ferrate in situ which is currently under study.     

水质生物毒性在线监测技术研究进展

从生物分子、细胞、个体、种群和群落水平,系统介绍了国内外研发的水质毒性在线监测技术,归纳分析了各种技术的特点及应用,并提出了其发展前景与趋势。     

在线分析宁波市北仑区VOCs组成、趋势及来源

利用VOCs在线监测技术,对2010年宁波市北仑区空气内的VOCs的浓度、组成、变化规律及来源进行分析研究。结果表明,在北仑区域内的16种VOCs中,苯、甲苯、二甲苯、乙苯和己烷的比例占到了总数的82．9％,且该5种有机物浓度存在较为典型的季节性变化规律和日变化规律;采用CMD模型法对VOCs的来源进行解析后发现,北仑区域内的VOCs主要来源于汽车尾气、汽油蒸气和石油液化气,而且汽车尾气的贡献值要比一些大城市低得多,且夏季和冬季的成分源贡献率存在明显差异。     

加强环境监测站规范化管理的有效措施

环境监测质量是监测工作的生命线,也是监测技术管理的核心内容,其根本目的是确保监测数据达到代表性、精密性、准确性、可比性和完整性的要求。实践证明,加强环境监测站规范化管理可以全程序的保证监测质量,提高工作效率,减少工作中的随意性。实验室资质认证、持续有效运行的质量管理体系、完善的监测技术规范、强化培训机制提高人员素质、加强全程序质量监督等措施可以有效地提高监测站规范化管理。     

碳组分不同监测分析技术的比较

采用在线监测和实验室分析方法,分别在热光透射法(TOT)NIOSH 5040、870升温协议和热光反射法(TOR)IMPROVE-A升温协议下测定PM_2.5中有机碳(OC)、元素碳(EC),并将各测定结果做比对分析。结果表明,在线监测(NIOSH 5040)与实验室分析(IMPROVE-A)结果的相关系数R>0.8,总体相关性较好,EC值差异略大;在线监测与实验室分析在NIOSH 870协议下TC测定值总体相近,OC与EC测定值略有差异;在线监测中NIOSH 5040协议下的OC测定值略低于870协议,EC测定值略高于870协议,日常监测中两种温度协议均可选择。     

水质自动监控系统在水产养殖业上的应用

设计了新型的测量池，配上在线分析仪、PC机、485总线、模块和电气控制设备，研制了池塘养殖水质处动监控系统，能做到监测水质、自动增氧和投饲、更换池水，系统经长期运行，正常无故障。     

在线分离富集FI分光光度法直接测定铜

本文针对ＡＡＳ法测定痕量铜时，大量铁存在表现干扰，研究并建立了流动注射（ＦＩ）在线螯合树脂分离富集光度法直接测定痕量铜的新方法，具有灵敏度高、选择性强；因此，已成功地用于水样中痕量铜的测定，该法在水质检验和环境监测中有一定的适用性．     

工业园区水污染源精细化管控系统的应用

针对工业园区污水排放监管问题,以北京某园区为例,提出了水污染源精细化管控方案。按照多级防控的思路,在企业级、管网级、园区级建成在线监测系统和精细化管控平台,实现园区水环境监管的全覆盖,有效监控企业排污动态,实时掌握园区污水排放状况,为企业、园区管理部门和环保管理部门提供决策支持。