Kitchen waste valorization through a mild-temperature pretreatment to enhance biogas production and fermentability: Kinetics study in mesophilic and thermophilic regimen

Biowaste valorization through anaerobic digestion is an attractive option to achieve both climate protection goals and renewable energy production. In this paper, a complete set of batch trials was carried out on kitchen waste to investigate the effects of mild thermal pretreatment, temperature regimen and substrate/inoculum ratio. Thermal pretreatment was effective in the solubilisation of macromolecular fractions, particularly carbohydrates. The ability of the theoretical methodologies in estimating hydrogen and methane yields of complex substrates was evaluated by comparing the experimental results with the theoretical values. Despite the single batch configuration, a significant initial hydrogen production was observed, prior to methane yield. Main pretreatment effect was the gain in hydrogen production; the extent was highly variable according to the other parameters values. High hydrogen yields, up to 113 mL H2/g VSfed, were related to the prompt transformation of soluble sugars. Thermophilic regimen resulted, as expected, in faster digestions (up to 78 mL CH₄/gVS/day) and sorted out pH inhibition. The relatively low methane yields (342–398 mL CH₄/g VS_fed) were the result of the consistent lignocellulosic content and low lipid content. Thermal pretreatment proved to be a promising option for the enhancement of hydrogen production in food waste dark fermentation.     

2-丁烯醛生产废水的臭氧脱毒预处理

CMW（crotonaldehyde manufacturing wastewater,2-丁烯醛生产废水）污染物浓度高、毒性强、直接采用生物法处理难度大.为了降低CMW的生物处理毒性,采用臭氧氧化法对CMW进行脱毒预处理,并通过考察不同臭氧氧化条件对废水COD_Cr、TOC（总有机碳）、UV_{254 nm}去除率及SMA（specific methanogenic activity,比产甲烷活性）抑制率的影响,获得了优化的臭氧氧化条件,进一步分析了废水脱毒机理.结果表明:①优化的臭氧氧化条件为接触反应时间180 min、初始pH 3.0、反应温度35℃、气相臭氧浓度30.3 mg/L,进气流量500 mL/min;并且在该条件下,CMW中COD_Cr、TOC和UV_{254 nm}的去除率分别为19.9%、9.9%和70.6%,主要特征有机污染物[包括2-丁烯醛、（E,E）-2,4-己二烯醛、3-（2-甲基-2-丙烯）-5-戊内酯、1,5-二甲基-1-烯-4-羰基-环氧己烷、山梨酸乙酯等]的去除率在74.4%以上.②厌氧产甲烷毒性试验结果显示,CMW的SMA抑制率由臭氧氧化前的82.0%降至臭氧氧化后的47.2%.③反应动力学研究显示,CMW中COD_Cr、TOC及UV_{254 nm}的去除过程均符合一级反应动力学方程,R2分别为0.82、0.97、0.94.研究显示,臭氧氧化预处理可以较好地去除CMW中的特征有机污染物,降低废水的厌氧生物处理毒性,是一种可行的脱毒预处理方法.      

柴油机尾气中PAH_s的分析

本文概述了柴油机尾气中ＰＡＨｓ的分析方法，着重论述了采样及预处理方法，特别对预处理方法进行了深入的探讨。另外，通过对柴油机两种不同工况下产生的尾气进行分析后发现，柴油机转速越高，其排放尾气中ＰＡＨｓ的含量就越低。     

石墨炉原子吸收光谱法测定轻质油中痕量砷时样品前处理方法的探讨

研究了轻质油中痕量砷的几种样品处理方法。实验表明，石墨炉原子吸收光谱法测定时，用碘-甲苯和H2O2-HNO3相结合处理轻质油样品较为合适，萃取效率可达90％。并对影响萃取测定的其它因素作了初步探讨。     

ABR工艺预处理木薯酒糟废水的工程应用

木薯酒糟废水有机物浓度高、悬浮物含量大、pH呈酸性、可生化性能较差 ,通常直接采用固液分离—厌氧 (UASB)—好氧曝气生化法处理效果并不理想 ,而采用ABR工艺进行厌氧水解酸化预处理木薯酒糟废水迄今为止未见报道。经绵阳市酒厂废水治理工程证明 ,强化ABR预处理工序是保证后续处理措施能否正常运行的关键     

分光光度法测定水样中铬

在ｐＨ４．４ＨＡＣ－ＮａＡｃ缓冲介质及乳化剂ＯＰ存在下，Ｃｒ６＋与二溴羟基苯基荧光酮（ＤＢＨＰＦ）显色反应生成桔红色络合物．该络合物最大吸收位于４８２ｎｍ波长处，表现摩尔吸光系数εｍａｘ＝３．４７×１０４．络合物配位比为Ｃｒ６＋：ＤＢＨＰＦ＝２：３，Ｃｒ６＋在０－１６μｇ／２５ｍＬ范围内遵守比耳定律．方法已用于水样中微量铬的测定，结果满意．     

抗生素制药废水的处理

锦州九泰制药废水属于不易生化类废水，废水量1000m^3/d，污水站总投资140万元。本文阐述了该工程的水质、预处理、生化处理工艺、活性污泥的培养与驯化及运行效果与设计特点。     

Comparison of mesophilic and thermophilic anaerobic digestions of thermal hydrolysis pretreated swine manure: Process performance, microbial communities and energy balance

Anaerobic digestion (AD) of swine manure (SM) commonly shows low biogas output and unsatisfactory economic performance. In this study, thermophilic AD (TAD, 50 ± 1 °C) was combined with thermal hydrolysis pretreatment (THP, 170 °C/10 bar), to investigate its potential for maximizing biogas yield, securing successful digestion and microbial diversity, as well as improving energy balance. Four lab-scale continuously stirred tank reactors were operated for 300 days and compared with each other, i.e., reactor 1 (raw SM fed in mesophilic AD: RSM-MAD), reactor 2 (THP-treated SM fed in MAD: TSM-MAD), reactor 3 (RSM-TAD), and reactor 4 (TSM-TAD). The results showed that THP was efficient to increase methane production of SM, TSM-TAD mode led to the highest methane yield (129.8 ± 40.5 mL-CH₄/g-VS/day) among the tests (p < 0.05). Although TAD was more likely to induce free ammonia (> 700 mg/L) or volatile fatty acids (> 6000 mg/L) accumulation compared with MAD in start-up phase, TSM-TAD treatment mode behaved a sustainable digestion process in a long-term operation. For TSM-TAD scenario, higher Shannon–Weaver (3.873) and lower Simpson index (0.061) indicated this mode ensured and enlarged the diversity of bacteria communities. Phylum Bathyarchaeota was dominant (59.3%−90.0%) in archaea community, followed by Euryarchaeota in the four reactors. RSM-MAD treatment mode achieved the highest energy output (4.65 GJ/day), TSM-TAD was less effective (−17.38 GJ/day) due to increased energy demands. Thus improving the energetic efficiency of THP units is recommended for the development of TSM-TAD treatment mode.     

超临界流体萃取法

介绍了超临界流体的性质：超临界流体萃取法的原理，特点及应用。讨论了应用超临界流体萃取进行样品预处理的条件选择：超临界流体的选择，列举了数种常用的超临界流体，详尽介绍了ＣＯ２的特性及其在样品预处理中的应用范围；萃取条件选择的预测方法，试验方法，萃取压力的选择，， 同类别物质的以，不联机及联机的收集技术等。     

铁炭微电解法预处理浆纱废水的研究

研究了采用铁炭微电解法预处理浆纱废水.试验结果表明,经微电解处理后的废水,COD的去除率达到67.2%,BOD5/COD从0.07提高到0.32,废水的可生化性得到显著提高.通过正交试验考察pH、反应时间及铁炭对比处理效果的影响,并对各因素作了单因素影响试验,确定了最佳工艺条件.