应用测雹板评估1998年涞源县防雹效果

应用测雹板布网,选用雹块大小,密度以及与其有关的冰雹动能,动能通量,冰雹质量,质量通量等物理量参数作为评估防雹效果的统计量,通过计算,对作业区与对比区分别进行统计分析,确定防雹作业效果。     

Antimony leaching release from brake pads: Effect of pH,temperature and organic acids

Metals from automotive brake pads pollute water, soils and the ambient air. The environmental effect on water of antimony (Sb) contained in brake pads has been largely untested. The content of Sb in one abandoned brake pad reached up to 1.62 × 10⁴ mg/kg. Effects of initial pH, temperature and four organic acids (acetic acid, oxalic acid, citric acid and humic acid) on Sb release from brake pads were studied using batch reactors. Approximately 30% (97 mg/L) of the total Sb contained in the brake pads was released in alkaline aqueous solution and at higher temperature after 30 days of leaching. The organic acids tested restrained Sb release, especially acetic acid and oxalic acid. The pH-dependent concentration change of Sb in aqueous solution was best fitted by a logarithmic function. In addition, Sb contained in topsoil from land where brake pads were discarded (average 9 × 10³ mg/kg) was 3000 times that in uncontaminated soils (2.7 ± 1 mg/kg) in the same areas. Because potentially high amounts of Sb may be released from brake pads, it is important that producers and environmental authorities take precautions.     

Antimony leaching release from brake pads: Effect of pH,temperature and organic acids

Metals from automotive brake pads pollute water, soils and the ambient air. The environmental effect on water of antimony(Sb) contained in brake pads has been largely untested. The content of Sb in one abandoned brake pad reached up to 1.62 × 104mg/kg.Effects of initial p H, temperature and four organic acids(acetic acid, oxalic acid, citric acid and humic acid) on Sb release from brake pads were studied using batch reactors.Approximately 30%(97 mg/L) of the total Sb contained in the brake pads was released in alkaline aqueous solution and at higher temperature after 30 days of leaching. The organic acids tested restrained Sb release, especially acetic acid and oxalic acid. The p H-dependent concentration change of Sb in aqueous solution was best fitted by a logarithmic function. In addition, Sb contained in topsoil from land where brake pads were discarded(average9 × 103mg/kg) was 3000 times that in uncontaminated soils(2.7 ± 1 mg/kg) in the same areas. Because potentially high amounts of Sb may be released from brake pads, it is important that producers and environmental authorities take precautions.? 2015 The Research Center for Eco-Environmental Sciences, Chinese Academy of Sciences.     

Antimony leaching release from brake pads: Effect of pH, temperature and organic acids

Metals from automotive brake pads pollute water, soils and the ambient air. The environmental effect on water of antimony (Sb) contained in brake pads has been largely untested. The content of Sb in one abandoned brake pad reached up to 1.62 × 10⁴ mg/kg. Effects of initial pH, temperature and four organic acids (acetic acid, oxalic acid, citric acid and humic acid) on Sb release from brake pads were studied using batch reactors. Approximately 30% (97 mg/L) of the total Sb contained in the brake pads was released in alkaline aqueous solution and at higher temperature after 30 days of leaching. The organic acids tested restrained Sb release, especially acetic acid and oxalic acid. The pH-dependent concentration change of Sb in aqueous solution was best fitted by a logarithmic function. In addition, Sb contained in topsoil from land where brake pads were discarded (average 9 × 10³ mg/kg) was 3000 times that in uncontaminated soils (2.7 ± 1 mg/kg) in the same areas. Because potentially high amounts of Sb may be released from brake pads, it is important that producers and environmental authorities take precautions.     

Microbial and size characterization of airborne particulate matter collected on sticky tapes along US–Mexico border

Particulate matter(PM) emissions from various sources can affect significantly human health and environmental quality especially in the Chihuahuan Desert region along US–Mexico border. The objective of this study was to use the low-cost sticky tape method to collect airborne PM for size characterization and identification of fungal spores. Sticky tape samplers were placed at 1.0 and 2.0 m above the ground surface at experimental sites in Ciudad Juárez, Mexico and at 0.6, 1.2 and 1.8 m at New Mexico sites, USA. Soil samples were collected in both countries to determine fungal diversity, texture and moisture content Dust particles collected from all of the experimental sites had a dominant texture of clay( 0.002 mm). The dominant textures identified from soil samples collected from the US and Mexican sites were loam and sandy clay loam, respectively. Alternaria, Penicillium and Fusarium were frequently found funguses in the US sites while Alternaria and Aspergillus were commonly observed in the Mexican sites. The sticky tapes also showed a similar diversity of fungal microorganisms present in the airborne PM at both Mexico and US sites Alternaria, Penicillium and Aspergillus were the three groups of airborne fungal microorganisms consistently present in the US and Mexican sites. The low-cost sticky tape method has the potential to be used for characterizing different airborne microorganisms and dust particles.     

The development of a novel method for directional dust monitoring

Dust monitoring using sticky pads was popularised in the 1980s. The discolouration caused by dust adhering to white adhesive material was measured with a smoke stain reflectometer. This loss of reflectance was expressed as the percentage effective area coverage (EAC%) per day. EAC% can be used as a measure of nuisance caused by dust. EAC% may also be measured with a hand-held Sticky Pad Reader (SPR). Sticky pads can be mounted on flat or cylindrical surfaces to measure dust by deposition or in flux. An alternative method was developed in the 1990s that measured total dust coverage using computer-based scanning. DustScan used a transparent adhesive film wrapped around a vertical cylinder with magnetic north marked. The sticky pad was sealed with another transparent sheet before scanning at 50 dots per inch (dpi). Dust levels were assessed by comparing the grey-scale values of pixels in the exposed area with an unexposed reference area. Insects and other extraneous material could be ‘masked out’ from the computer analysis. Dust coverage was expressed as percentage absolute area coverage (AAC%). DustScan has subsequently been developed commercially. A limited trial indicated that monitoring periods of 7–14 days were preferred to avoid dust saturation of the sticky pad. A method for calculating EAC% has been developed and shown to have a high degree of correspondence with an SPR. A trial for the Minerals Industry Research Organisation (MIRO) made comparisons between DustScan and other dust monitoring methods. Dust nuisance limits based on AAC% and EAC% are proposed.par     

Performance analysis of a new sustainable evaporative cooling pad made from coconut coir

This paper reports a performance analysis for a new sustainable engineering application to beneficially reuse an abundant agricultural waste, coconut coir (Cocos nucifera), in evaporative cooling pads. Two small coconut coir pads of different configurations were fabricated and tested using a laboratory‐scale experimental arrangement. The air supply velocity was controlled and varied between 1.88 and 2.79 m s^?1. Heat and mass transfer coefficients, evaporative cooling efficiency and pressure drop across the two types of coconut coir pad were analysed and compared with those of a commercial rigid media paper pad. Results show that the cooling efficiency of the manufactured coconut coir evaporative cooling pad was fairly good (about 50%) and close to that of the commercial paper pad (about 47%). The average pressure drop across the two coconut coir pads was 1.5 and 5.1 Pa respectively. Correlations for heat and mass transfer coefficients expressed using Nusselt and Sherwood numbers are also reported. In addition, the cooling potential of the coconut coir pads was analysed using the average climatic conditions of the central region in Thailand throughout the year. The analysis showed that the air temperature leaving the coconut coir pad varied from 23 to 28°C. Commercial development appears feasible given the coconut coir pad's good performance, lower cost and its availability throughout the country.