ABSTRACT: Long term data on surface water quality can sometimes be assembled by combining data collected by different agencies at different times and assuming that between agency differences in data quality are insignificant. The objective of this paper was to assess the quality of riverine nitrate (NO3) concentrations in Illinois measured and reported by four agencies from 1967 to 1974 by comparing median values for similar sampling locations and periods. A total of 17 river reaches were identified for which two agencies reported NO3 concentrations during similar periods. Nonparametric comparison of median values and analysis of covariance with discharge as a covariant produced similar results. Nitrate concentrations reported by the U.S. Geological Survey (USGS) from 1967 to 1971 were not statistically (P > 0.05) different from values reported by the Illinois State Water Survey (ISWS) for two of three river reaches. Additionally, NO3 concentrations reported by USGS from 1972 to 1974 were not statistically different than concentrations reported by the Illinois Environmental Protection Agency (IEPA) for four of five river reaches. From 1969 to 1971, NO3 concentrations reported by the Illinois Department of Public Heath and the Illinois Environmental Protection Agency (IDPH/IEPA) were less than one‐fourth the magnitude of values reported by ISWS. The median NO3 concentrations measured by the Central Illinois Public Service (CIPS) were significantly greater than those measured by USGS and IDPH/IEPA in the three comparable sampling locations. The use of NO3 concentrations measured by CIPS and IDPH/IEPA prior to 1972 is not recommended. 相似文献
A programme of large-scale experiments for atmospheric dispersion was carried out by INERIS over a period extending from December 1996 to April 1997. The objectives of the test campaign were to measure anhydrous ammonia concentrations in a range of few meters to 2 km from the release, in order to generate data to be used to improve 2-phase discharge and dispersion modelling.
The discharges were released from a 6-tonne storage tank of pressurised liquid ammonia and through a discharge device with an outlet diameter of 2 in. Fifteen trials were carried out with various release configurations corresponding to industrial situations (impinging jets on the ground and on a wall at various distances, release through a flange without seal…). The quantity of ammonia discharged from the liquid phase varied according to the tests, from 1.4 to 3.5 tons for durations between 7 and 14 min and, therefore, at flow rates between 2 and 4.5 kg/s. Approximately 200 sensors were settled downwind to measure ammonia concentrations and temperature in the plume. These tests showed that for discharges with identical flow rates the distances corresponding to the same concentration vary a lot according to the configurations. These distances tend to be reduced by the presence of obstacles or retention dikes that collected liquid ammonia. In the paper, the main experimental results are presented. In order to enable the comparisons with numerical predictions, more detailed information are given in [Bouet R. (1999). Ammoniac—Essais de dispersion atmosphérique à grande échelle. INERIS rapport, ref INERIS-DRA-RBo-1999-20410 (available at http://www.ineris.fr/recherches/recherches.htm). 相似文献