Potential of secondary aerosol formation from Chinese gasoline engine exhaust

Light-duty gasoline vehicles have drawn public attention in China due to their significant primary emissions of particulate matter and volatile organic compounds(VOCs). However,little information on secondary aerosol formation from exhaust for Chinese vehicles and fuel conditions is available. In this study, chamber experiments were conducted to quantify the potential of secondary aerosol formation from the exhaust of a port fuel injection gasoline engine. The engine and fuel used are common in the Chinese market, and the fuel satisfies the China V gasoline fuel standard. Substantial secondary aerosol formation was observed during a 4–5 hr simulation, which was estimated to represent more than 10 days of equivalent atmospheric photo-oxidation in Beijing. As a consequence, the extreme case secondary organic aerosol(SOA) production was 426 ± 85 mg/kg-fuel, with high levels of precursors and OH exposure. The low hygroscopicity of the aerosols formed inside the chamber suggests that SOA was the dominant chemical composition. Fourteen percent of SOA measured in the chamber experiments could be explained through the oxidation of speciated single-ring aromatics. Unspeciated precursors, such as intermediate-volatility organic compounds and semi-volatile organic compounds, might be significant for SOA formation from gasoline VOCs. We concluded that reductions of emissions of aerosol precursor gases from vehicles are essential to mediate pollution in China.     

流动注射法测定水中总碳酸盐

将流动注射应用于水中总碳酸盐的分析,并研究了各种实验条件对于结果的影响。实验证明,这种方法基本不存在干扰,在采样量为0.05ml时,检出限(3σ)为80mg/L;峰高的检测范围100~1000mg/L;峰宽的检测范围1000~5000mg/L,能够很好地应用于火力发电厂中生水、锅炉水的总碳酸盐测定。     

高压密封消解-流动注射同时测定海水中总氮和总磷

建立了高压密封消解-流动注射同时测定海水中总氮和总磷的方法,方法采用特制聚四氟乙烯密封消解罐,经高压消解锅消解后,用流动注射分析仪同时测定海水中的总氮和总磷。结果显示,总氮和总磷在0~3.20 mg/L范围内线性良好,总氮相关系数(r)=0.9997,检出限为0.012 mg/L,相对标准偏差为0.65%~2.59%,加标回收率为97.8%~102%;总磷相关系数(r)=0.9999,检出限为0.006 mg/L,相对标准偏差为0.50%~6.67%,加标回收率为98.8%~101%。该方法可同时测定海水中总氮和总磷,方法准确度和精密度良好,满足分析要求,适用于大批量海水样品中总氮和总磷的快速准确定量。     

Fractionation of Cu, Pb and Zn in certified reference soils SRM 2710 and SRM 2711 using the optimized BCR sequential extraction procedure

Sequential extraction of metals from solid media is a common analytical tool used in environmental and exploration geochemistry. A number of procedures exist, but without harmonization and standardization, meaningful comparisons are tenuous without baseline data. A newly developed, standardized sequential extraction procedure (optimized BCR) was applied to two contaminated certified reference soils from Montana, US (SRM 2710 and SRM 2711) for Cu, Pb and Zn. Four operationally defined fractions were isolated, acid extractable, reducible, oxidizable, and residual (by aqua regia). Fraction-specific concentrations, percentages and recoveries for Cu, Pb and Zn were used to explore differences between the optimized BCR procedure and three other sequential extraction schemes with published data for SRM 2710 and 2711 (i.e. Tessier scheme, Geological Survey of Canada scheme and the original BCR scheme). Results indicate significant differences between the four schemes, even for schemes that are closely associated (i.e. the original and optimized BCR schemes). Order-of-magnitude fraction-specific concentration differences were observed, especially for Pb in the reducible fraction. Differences between schemes are worrisome because trends varied between metals, between fractions and between reference soils. These data reinforce the need for increased adoption of standardized sequential extraction procedures and further examination of different solid media.     

流动注射在线氢化物发生—原子荧光光谱法测定环境水样中痕量无机汞和有机汞

提出了一种流动注射在线氢化物发生—原子荧光光谱法测定水样中痕量无机汞和有机汞的分析方法。以溴化剂作为有机汞的消解剂 ,在有、无溴化剂的存在下 ,采用流动注射在线氢化物发生—原子荧光光谱法分别测定总汞和无机汞 ,差减法求出有机汞的含量。方法操作简便快速 ,灵敏度高 ,干扰少 ,经加标回收实验验证 ,回收率达 95 %～ 10 5 %。     

颗粒物质金属形态逐级提取技术问题的探讨

本文综述了国内外对颗粒物质中金属形态逐级提取测定技术方面的研究情况，重点阐述了颗粒物质金属形态分离方法，并对各相态的浸取技术和金属总量提取方法进行了讨论．从而为开展颗粒物质的金属化学形态的分析和研究，提出几点认识．     

在线树脂富集流动注射法测定水中痕量酚

研究了用流动注射分析中的流体动力学注入技术与在线树脂富集相结合的方式，富集水中痕量苯酚，以４－氨基安替比林比色法测定的方法。结果表明，当进样频率为２４个样品每小时时，方法的检出限为０．０５ｍｇ／Ｌ，线性范围为０．０５～７ｍｇ／Ｌ；对水中苯酚重复测定１０次，相对标准偏差小于２％；回收率为９９％～１０５％。     

Kinetic-spectrophotometric determination of free cyanide by stopped-flow reversed flow injection analysis

A stopped-flow reversed flow injection method for the determination of free cyanide is proposed. Pyridine-barbituric acid mixture is injected in the flow system as reagent to form the colour species with cyanide. The flow is stopped when the reagent zone comes in the flow cell, where absorbance-time data are collected at 580nm wavelength. The linear range of the determination is 0.1 -10μg/ml CN-. The sampling rate is 60h-1 and the relative standard deviation is 1.6% (n=16) at 5.0 μg/ml CN-1 level. With satisfactory results, the proposed method was applied to the determination of free cyanide in wastewater without sample pretreatment.     

VE泵端面凸轮冷/温复合成形技术研究

采用温锻制坯与冷摆辗相结合的复合成形工艺生产VE泵端面凸轮精密成形件,不仅材料利用率可达到95%左右;而且成形件的尺寸精度高,表面光洁度高,能有效地减少后续仿形磨削加工的余量,从而降低了生产成本,提高了生产效率。采用该工艺可以进行大批量生产,能满足我国轻型汽车VE泵的生产需要。     

煤飞灰中铬铁元素的形态分析研究

用连续提取法将煤飞灰中的铬、铁元素依结合态区分为水溶态,交换态,表面氧化物和碳酸结合态,铁锰氧化物结合态,金属有机物和硫化物结合态,磁性四氧化三铁结合态和硅铝酸盐矿物态,用原子吸收法及X-衍射分析进行测定。并对煤飞灰化学形态分布进行了讨论。