The use of the removable thin film coating technique as an alternative to traditional decontamination methods to mitigate and abate hazardous particulates

This article summarizes a study that evaluated a new decontamination technique for the mitigation and abatement of hazardous dust and particulates. Traditional decontamination methods are time‐consuming, expensive, can create airborne hazards, and do not always bring the concentration of the contaminant to acceptable levels. The use of the removable thin film coating will increase efficiency, will not generate airborne hazards, will decrease costs, and, with one application, will bring the hazardous dust concentrations to acceptable levels. Qualitative tests demonstrated that the removable thin film coating reduced the amount of visible luminescent dust (a surrogate for hazardous dust) from various surfaces. It also indicated that wherever there were minute scratches, the coating did not remove all of the dust. However, the qualitative tests showed that this decontamination method worked well as a preventative method, protecting clean areas from becoming contaminated when exposed to the luminescent dust. Further investigation was conducted using a scanning electron microscope (SEM) and carbon dust. Overall, the SEM experiment demonstrated that there was a statistically significant (p = 0.00007) removal of carbon dust (less than 10 μm in size) from surfaces with crevasses larger than 3 μm. The SEM also revealed that there were some limitations where there were large clusters of carbon dust; in these instances, the coating would tear and remain on the sample surface. One method to resolve this limitation involved adding Kevlar^TM fibers to the removable thin film coating. It was thought that this would increase the strength of the coating and eliminate the coating from tearing when removing large clusters of a contaminant. Unfortunately, this did not alleviate the issue. The use of an engineered textile, saturated with the coating, appeared to eliminate the problem with the coating not being able to remove the contaminant from the minute surface scratches and improved the removal process of the coating. © 2008 Wiley Periodicals, Inc.