| 抛物形件用软凸模拉深成形 |
| |
| 引用本文： | 周建忠,韩向东. 抛物形件用软凸模拉深成形[J]. 装备环境工程, 1995, 0(1) |
| |
| 作者姓名： | 周建忠 韩向东 |
| |
| 作者单位： | 江苏理工大学汽车工程系(周建忠)，江苏理工大学汽车工程系(韩向东) |
| |
| 摘 要： | 分析了抛物形件用软凸模拉深过程,用聚氨酯橡胶凸模能简化抛物形件的制造工艺,有效地防止拉裂、起皱和回弹,给出了软凸模拉深系数和合适的软模硬度。
|
| 关 键 词： | 聚氨酯/抛物形件 拉深 |
Soft Raised Die Drawing for ParaboLa |
| |
| Jiangsu university of Science and Technology Zhou Jianzhong Han Xiangdong. Soft Raised Die Drawing for ParaboLa[J]. Equipment Environmental Engineering, 1995, 0(1) |
| |
| Authors: | Jiangsu university of Science and Technology Zhou Jianzhong Han Xiangdong |
| |
| Affiliation: | Jiangsu university of Science and Technology Zhou Jianzhong Han Xiangdong |
| |
| Abstract: | Drawing process of soft raised die are analysed. The manufacturing process is simplifed for parabola and the use of polyurethane die will prevent the parabola form bouncing, wrinkling and tearing. Drawing coefficient and reasonable hardness are suggested. |
| |
| Keywords: | Soft modes Drawing polyurethane/Parabola |
| 本文献已被 CNKI 等数据库收录！ |
