Performance of a Semi-Industrial Scale Gasification Process for the Destruction of Polychlorinated Biphenyls

Abstract

A semi-industrial scale test was conducted to thermally treat mixtures of spent oil and askarels at a concentration of 50,000 ppm and 100,000 ppm of polychlorinated biphenyls (PCBs) under a reductive atmosphere. In average, the dry-basis composition of the synthesis gas (syngas) obtained from the gasification process was: hydrogen 46%, CO 34%, CO₂ 18%, and CH₄ 0.8%. PCBs, polychlorinated dibenzo-p-dioxins, and polychlorinated dibenzofurans (PCDDs/PCDFs) in the gas stream were analyzed by high-resolution gas chromatography (GC)-mass spec-trometry. The coplanar PCBs congeners 77, 105, 118, 156/157, and 167 were detected in the syngas at concentrations <2 ×10^?7 mg/m³ (at 298 K, 1 atm, dry basis, 7% O₂). The chlorine released in the destruction of the PCBs was transformed to hydrogen chloride and separated from the gas by an alkaline wet scrubber. The concentration of PCBs in the water leaving the scrubber was below the detection limit of 0.002 mg/L, whereas the destruction and removal efficiency was >99.9999% for both tests conducted. The concentration of PCDDs/PCDFs in the syngas were 8.1 ×10^?6 ng-toxic equivalent (TEQ)/m³ and 7.1 × 10^?6 ng-TEQ/m³ (at 298 K, 1 atm, dry basis, 7% O₂) for the tests at 50,000 ppm and 100,000 ppm PCBs, respectively. The only PCDD/F congener detected in the gas was the octachloro-dibenzo-p-dioxin, which has a toxic equivalent factor of 0.001. The results obtained for other pollutants (e.g., metals and particulate matter) meet the maximum allowed emission limits according to Mexican, U.S., and European regulations for the thermal treatment of hazardous waste (excluding CO, which is a major component of the syngas, and total hydrocarbons, which mainly represent the presence of CH₄).